Control of temperature profile for a spray deposition process

Spray forming is a novel method of rapidly manufacturing tools and dies for stamping and injection operations. The process sprays molten tool steel from a set of arc spray guns onto a ceramic former to build up a thick steel shell. The volumetric contraction that occurs as the steel cools is offset by a volumetric expansion taking place within the sprayed steel, which allows the dimensional accurate tools to be produced. To ensure that the required phase transformation takes place, the temperature of the steel is regulated during spraying. The sprayed metal acts both as a source of mass and a source of heat and by adjusting the rate at which metal is sprayed, the surface temperature profile over the surface of the steel shell can be controlled. The temperature profile is measured using a thermal imaging camera and regulated by adjusting the rate at which the guns spray the steel. Because the temperature is regulated by adjusting the feed rate to an actuator that is moving over the surface, this is an example of mobile control, which is a class of distributed parameter control. The paper describes the design of a time-varying H/sub 2/ controller for the process and presents results from the implementation of the controller on the spray forming process.

[1]  B. Anderson,et al.  Optimal Filtering , 1979, IEEE Transactions on Systems, Man, and Cybernetics.

[2]  Patrick S. Grant,et al.  An inverse problem in modelling liquid metal spraying , 2003 .

[3]  Charalabos C. Doumanidis,et al.  Temperature distribution control in scanned thermal processing of thin circular parts , 2001, IEEE Trans. Control. Syst. Technol..

[4]  A. G. Butkovskiǐ,et al.  Mobile control of distributed parameter systems , 1987 .

[5]  S. Bittanti,et al.  The difference periodic Ricati equation for the periodic prediction problem , 1988 .

[6]  Charalabos C. Doumanidis,et al.  In-process control in thermal rapid prototyping , 1997 .

[7]  C. Doumanidis,et al.  Geometry Modeling and Control by Infrared and Laser Sensing in Thermal Manufacturing with Material Deposition , 2001 .

[8]  W. Strauss,et al.  Partial Differential Equations: An Introduction , 1992 .

[9]  R. Honeycombe Steels, Microstructure and Properties , 1982 .

[10]  Charalabos C. Doumanidis,et al.  Multivariable adaptive control of the bead profile geometry in gas metal arc welding with thermal scanning , 2002 .

[11]  Charalabos C. Doumanidis,et al.  Temperature Field Regulation in Thermal Cutting for Layered Manufacturing , 1999 .

[12]  Patrick S. Grant,et al.  A Computer Model for Trajectories and Thermal Profiles of Atomised Droplets in Spray Forming , 1990 .

[13]  Stephen R. Duncan,et al.  Estimating the surface temperature profile from a sequence of partial thermal images , 2001, SPIE Optics East.