Removal and effects of scatter-glare in cone-beam CT with an amorphous-silicon flat-panel detector

Scatter in a detector and its housing can result in image degradation. Typically, such scatter leads to a low-spatial frequency 'glare' superimposed on the primary signal. We infer the glare-spread function (GSF) of an amorphous-silicon flat-panel detector via an edge-spread technique. We demonstrate that this spread (referred to as 'scatter-glare' herein) causes a low-spatial frequency drop in the associated modulation-transfer function. This results in a compression of the range of reconstructed CT (computed tomography) numbers and is an impediment to accurate CT-number calibration. We show that it can also lead to visual artefacts. This explains previously unresolved CT-number discrepancies in an earlier work (Poludniowski et al 2009 Phys. Med. Biol. 54 3847). We demonstrate that after deconvolving the GSF from the projection images, in conjunction with a correction for phantom-scatter, the CT-number discrepancies disappear. We show results for an in-house-built phantom with inserts of tissue-equivalent materials and for a patient scan. We conclude that where scatter-glare has not been accounted for, the calibration of cone-beam CT numbers to material density will be compromised. The scatter-glare measurement method we propose is simple and requires no special equipment. The deconvolution process is also straightforward and relatively quick (60 ms per projection on a desktop PC).

[1]  Friedlieb Lorenz,et al.  A new strategy for online adaptive prostate radiotherapy based on cone-beam CT. , 2009, Zeitschrift fur medizinische Physik.

[2]  G. Poludniowski.  Calculation of x-ray spectra emerging from an x-ray tube. Part II. X-ray production and filtration in x-ray targets. , 2007, Medical physics.

[3]  T. Marchant,et al.  Shading correction algorithm for improvement of cone-beam CT images in radiotherapy , 2008, Physics in medicine and biology.

[4]  Matthias Guckenberger,et al.  Investigation of the usability of conebeam CT data sets for dose calculation , 2008, Radiation oncology.

[5]  Aldo Badano,et al.  Experimental validation of Monte Carlo (MANTIS) simulated x-ray response of columnar CsI scintillator screens. , 2009, Medical physics.

[6]  Mingli Chen,et al.  Adaptive fractionation therapy: I. Basic concept and strategy , 2008, Physics in medicine and biology.

[7]  J A Seibert,et al.  Characterization of the veiling glare PSF in x-ray image intensified fluoroscopy. , 1984, Medical physics.

[8]  Avinash C. Kak,et al.  Principles of computerized tomographic imaging , 2001, Classics in applied mathematics.

[9]  I A Cunningham,et al.  Normalization of the modulation transfer function: the open-field approach. , 2008, Medical physics.

[10]  S Webb,et al.  Adapting IMRT delivery fraction-by-fraction to cater for variable intrafraction motion , 2008, Physics in medicine and biology.

[11]  Lingyun Chen,et al.  Spatial resolution properties in cone beam CT: a simulation study. , 2008, Medical physics.

[12]  Ying Xiao,et al.  Daily image guidance with cone-beam computed tomography for head-and-neck cancer intensity-modulated radiotherapy: a prospective study. , 2010, International journal of radiation oncology, biology, physics.

[13]  L. Feldkamp,et al.  Practical cone-beam algorithm , 1984 .

[14]  J H Siewerdsen,et al.  An empirical method for lag correction in cone-beam CT. , 2008, Medical physics.

[15]  Colin Studholme,et al.  An overlap invariant entropy measure of 3D medical image alignment , 1999, Pattern Recognit..

[16]  D. Jaffray,et al.  Cone-beam computed tomography with a flat-panel imager: magnitude and effects of x-ray scatter. , 2001, Medical physics.

[17]  R. Sloboda,et al.  Comprehensive Monte Carlo calculation of the point spread function for a commercial a-Si EPID. , 2005, Medical physics.

[18]  Ulrich Neitzel,et al.  Measurement of the modulation transfer function of digital X-ray detectors with an opaque edge-test device. , 2005, Radiation protection dosimetry.

[19]  F Verhaegen,et al.  SpekCalc: a program to calculate photon spectra from tungsten anode x-ray tubes , 2009, Physics in medicine and biology.

[20]  J A Seibert,et al.  An edge spread technique for measurement of the scatter-to-primary ratio in mammography. , 2000, Medical physics.

[21]  P. Evans,et al.  A low Z linac and flat panel imager: comparison with the conventional imaging approach. , 2008, Physics in medicine and biology.

[22]  Radhe Mohan,et al.  Scatter kernel estimation with an edge-spread function method for cone-beam computed tomography imaging , 2008, Physics in medicine and biology.

[23]  D. Jaffray,et al.  A ghost story: spatio-temporal response characteristics of an indirect-detection flat-panel imager. , 1999, Medical physics.

[24]  Frank Verhaegen,et al.  Characterization of scattered radiation in kV CBCT images using Monte Carlo simulations. , 2006, Medical physics.

[25]  S Webb,et al.  An efficient Monte Carlo-based algorithm for scatter correction in keV cone-beam CT , 2009, Physics in medicine and biology.

[26]  Ann-Katherine Carton,et al.  The effect of scatter and glare on image quality in contrast-enhanced breast imaging using an a-Si/CsI(TI) full-field flat panel detector. , 2009, Medical physics.