Performance assessment of a hybrid system integrating a molten carbonate fuel cell and a thermoelectric generator

A hybrid system consisting of an MCFC (Molten Carbonate Fuel Cell), a TEG (Thermoelectric Generator) and a regenerator is proposed. In this system, the MCFC produces electricity and heat from fuels and the TEG utilizes the heat for additional power generation. A numerical model is developed to evaluate the performance of the proposed system. The relationship between the operating current density of the MCFC and the dimensionless current of the TEG is theoretically derived and the operating current density region of the MCFC that allows the TEG to function is determined. Numerical expressions of the power output and efficiency for the hybrid system are specified under different operating conditions. The general performance characteristics and optimum criteria for the hybrid system are revealed. It is found that the hybrid system is superior to the stand-alone MCFC system as the bottoming TEG can effectively increase the maximum power density. In addition, the effects of the operating current density, operating temperature, operating pressure, heat conductivity, integrated parameters and dimensional figure of merit on the performance characteristics of the hybrid system are investigated. The results obtained are useful for the design and optimization of novel MCFC system to achieve a better performance.

[1]  Stefano Cordiner,et al.  Analysis of a SOFC energy generation system fuelled with biomass reformate , 2007 .

[2]  Chang Chung Yang,et al.  Modeling and simulation for the design of thermal-concentrated solar thermoelectric generator , 2014 .

[3]  Xiaohang Chen,et al.  An available method exploiting the waste heat in a proton exchange membrane fuel cell system , 2011 .

[4]  Gequn Shu,et al.  Start-up modes of thermoelectric generator based on vehicle exhaust waste heat recovery , 2015 .

[5]  Ibrahim Dincer,et al.  Thermodynamic performance analysis of a molten carbonate fuel cell at very high current densities , 2011 .

[6]  陈金灿,et al.  Performance Evaluation and Parametric Optimum Criteria of an Irreversible Molten Carbonate Fuel Cell-Heat Engine Hybrid System , 2011, International Journal of Electrochemical Science.

[7]  Ananthanarayanan Veeraragavan,et al.  Influence of Hydration by Steam/Superheating on the CO2 Capture Performance and Physical Properties of CaO-Based Particles , 2013 .

[8]  Fabio Rinaldi,et al.  4E analysis and multi-objective optimization of an integrated MCFC (molten carbonate fuel cell) and ORC (organic Rankine cycle) system , 2015 .

[9]  Xiaolong Gou,et al.  A dynamic model for thermoelectric generator applied in waste heat recovery , 2013 .

[10]  S. Badwal,et al.  A comprehensive review of direct carbon fuel cell technology. , 2012 .

[11]  Tianjun Liao,et al.  Performance analysis and load matching of a photovoltaic–thermoelectric hybrid system , 2015 .

[12]  G. Cinti,et al.  Carbon capture with molten carbonate fuel cells: Experimental tests and fuel cell performance assessment , 2012 .

[13]  Ibrahim Dincer,et al.  Three-dimensional modeling of polarization characteristics in molten carbonate fuel cells using peroxide and superoxide mechanisms , 2012 .

[14]  Lan Hu,et al.  Electrochemical performance of reversible molten carbonate fuel cells , 2014 .

[15]  E Brian Smith.  Basic Chemical Thermodynamics , 1973 .

[16]  J. R. Selman,et al.  The Polarization of Molten Carbonate Fuel Cell Electrodes I . Analysis of Steady‐State Polarization Data , 1991 .

[17]  A. Olabi,et al.  Three-dimensional proton exchange membrane fuel cell model: Comparison of double channel and open pore cellular foam flow plates , 2017 .

[18]  Denver F. Cheddie,et al.  Thermo-economic optimization of an indirectly coupled solid oxide fuel cell/gas turbine hybrid power plant , 2011 .

[19]  Ricardo Chacartegui,et al.  Stirling based fuel cell hybrid systems: An alternative for molten carbonate fuel cells , 2009 .

[20]  R. Venkatasubramanian,et al.  Thin-film thermoelectric devices with high room-temperature figures of merit , 2001, Nature.

[21]  Jincan Chen,et al.  Performance evaluation and parametric optimum design of a syngas molten carbonate fuel cell and gas turbine hybrid system , 2015 .

[22]  Jung‐Ho Wee.  Carbon dioxide emission reduction using molten carbonate fuel cell systems , 2014 .

[23]  Rahman Saidur,et al.  Technologies to recover exhaust heat from internal combustion engines , 2012 .

[24]  M. A. Karri,et al.  Exhaust energy conversion by thermoelectric generator: Two case studies , 2011 .

[25]  Wei-Chin Chang,et al.  A mathematic model of thermoelectric module with applications on waste heat recovery from automobile engine , 2010 .

[26]  S. C. Kaushik,et al.  The influence of Thomson effect in the performance optimization of a two stage thermoelectric generator , 2016 .

[27]  Angelo Moreno,et al.  Numerical investigation of a MCFC (Molten Carbonate Fuel Cell) system hybridized with a supercritical CO2 Brayton cycle and compared with a bottoming Organic Rankine Cycle , 2015 .

[28]  Jincan Chen,et al.  Influence of multiple irreversible losses on the performance of a molten carbonate fuel cell-gas turbine hybrid system , 2012 .

[29]  Faryar Jabbari,et al.  Analysis of a molten carbonate fuel cell: Numerical modeling and experimental validation , 2006 .

[30]  Omar Z. Sharaf,et al.  An overview of fuel cell technology: Fundamentals and applications , 2014 .

[31]  S. Ghamaty,et al.  New thermoelectric materials and applications , 2012, 13th InterSociety Conference on Thermal and Thermomechanical Phenomena in Electronic Systems.

[32]  X. Chen,et al.  Performance and Evaluation of a Fuel Cell–Thermoelectric Generator Hybrid System , 2010 .

[33]  P. Ekins,et al.  Hydrogen and fuel cell technologies for heating: A review , 2015 .

[34]  François Maréchal,et al.  Thermo‐Economic Modelling and Optimisation of Fuel Cell Systems , 2005 .

[35]  Stefano Cordiner,et al.  Domestic distributed power generation: Effect of sizing and energy management strategy on the environmental efficiency of a photovoltaic-battery-fuel cell system , 2014 .

[36]  Ananthanarayanan Veeraragavan,et al.  Modeling of CaCO3 decomposition under CO2/H2O atmosphere in calcium looping processes , 2014 .

[37]  José Luz Silveira,et al.  Analysis of a molten carbonate fuel cell: cogeneration to produce electricity and cold water , 2001 .

[38]  Lauryn L. Baranowski,et al.  Concentrated solar thermoelectric generators , 2012 .

[39]  J. R. Selman,et al.  Corrosion of the wet-seal area in molten carbonate fuel cells. I - Analysis. II - Experimental results , 1984 .

[40]  Houcheng Zhang,et al.  Performance optimum analysis of an irreversible molten carbonate fuel cell–Stirling heat engine hybrid system , 2014 .

[41]  Lingen Chen,et al.  Thermoelectric-generator with linear phenomenological heat-transfer law , 2005 .

[42]  Bihong Lin,et al.  Optimal design of a multi-couple thermoelectric generator , 2000 .

[43]  Yuan Wang,et al.  A unified model of high-temperature fuel-cell heat-engine hybrid systems and analyses of its optimum performances , 2014 .

[44]  G. Angelino,et al.  Organic Rankine cycles (ORCs) for energy recovery from molten carbonate fuel cells , 2000, Collection of Technical Papers. 35th Intersociety Energy Conversion Engineering Conference and Exhibit (IECEC) (Cat. No.00CH37022).

[45]  Stefano Cavallaro,et al.  Lifetime-limiting factors for a molten carbonate fuel cell , 1994 .

[46]  Manfred Bischoff,et al.  Operating experience with a 250 kWel molten carbonate fuel cell (MCFC) power plant , 2002 .

[47]  Ziyang Hu,et al.  Performance characteristics of a direct carbon fuel cell/thermoelectric generator hybrid system , 2015 .

[48]  K. Qiu,et al.  A Natural-Gas-Fired Thermoelectric Power Generation System , 2009 .

[49]  Harish C. Barshilia,et al.  Performance evaluation of a natural convective-cooled concentration solar thermoelectric generator coupled with a spectrally selective high temperature absorber coating , 2016 .

[50]  C. Hochenauer,et al.  Water droplet accumulation and motion in PEM (Proton Exchange Membrane) fuel cell mini-channels , 2012 .

[51]  K. Romanjek,et al.  High temperature solar thermoelectric generator – Indoor characterization method and modeling , 2015 .

[52]  Yuan Wang,et al.  An efficient hybrid system using a thermionic generator to harvest waste heat from a reforming molten carbonate fuel cell , 2016 .

[53]  A. Dicks.  Molten carbonate fuel cells , 2004 .

[54]  Jincan Chen,et al.  Performance analysis and multi-objective optimization of a new molten carbonate fuel cell system , 2011 .

[55]  Ermete Antolini,et al.  The stability of molten carbonate fuel cell electrodes: A review of recent improvements , 2011 .

[56]  Saad Mekhilef,et al.  Comparative study of different fuel cell technologies , 2012 .

[57]  Jincan Chen.  Thermodynamic analysis of a solar‐driven thermoelectric generator , 1996 .