Comparative study of the thermal and power performances of a semi-transparent photovoltaic façade under different ventilation modes

This paper studied the thermal and power performances of a ventilated photovoltaic facade under different ventilation modes, and appropriate operation strategies for different weather conditions were proposed accordingly to maximize its energy conversion efficiency. This ventilated PV double-skin facade (PV-DSF) consists of an outside layer of semi-transparent amorphous silicon (a-Si) PV laminate, an inward-openable window and a 400mm airflow cavity. Before installation, the electrical characteristics under standard testing conditions (STC) and the temperature coefficients of the semi-transparent PV module were tested and determined in the laboratory. Field measurements were carried out to investigate the impact of different ventilation modes, namely, ventilated, buoyancy-driven ventilated and non-ventilated, on the thermal and power performances of this PV-DSF. The results show that the ventilated PV-DSF provides the lowest average solar heat gain coefficient (SHGC) and the non-ventilated PV-DSF provides the best thermal insulation performance. In terms of power performance, the energy output of the ventilated PV-DSF is greater than those of the buoyancy-driven ventilated and non-ventilated PV-DSFs by 1.9% and 3%, respectively, due to its much lower operating temperature. Based on the experimental results, a conclusion was drawn that the ventilation design can not only reduce the heat gain of PV-DSF but also improve the energy conversion efficiency of PV modules by bringing down their operating temperature. In addition, an optimum operation strategy is recommended for this kind of PV-DSF to maximize its overall energy efficiency under different weather conditions.

[1]  Juan Zhou,et al.  A REVIEW ON APPLYING VENTILATED DOUBLE-SKIN FACADE TO BUILDINGS IN HOT-SUMMER AND COLD-WINTER ZONE IN CHINA , 2010 .

[2]  David Infield,et al.  Thermal performance estimation for ventilated PV facades , 2004 .

[3]  Stephen Wittkopf,et al.  Solar heat gain coefficient measurement of semi-transparent photovoltaic modules with indoor calorimetric hot box and solar simulator , 2012 .

[4]  Monika Woloszyn,et al.  Three-dimensional simulation with a CFD tool of the airflow phenomena in single floor double-skin facade equipped with a venetian blind , 2005 .

[5]  A. Campos-Celador,et al.  A comparative study of the CFD modeling of a ventilated active façade including phase change materials , 2014 .

[6]  H. Radhi.  Energy analysis of façade-integrated photovoltaic systems applied to UAE commercial buildings , 2010 .

[7]  Fariborz Haghighat,et al.  Airflow and heat transfer in double skin facades , 2011 .

[8]  Kwang Ho Lee,et al.  An experimental study on the annual surface temperature characteristics of amorphous silicon BIPV window , 2013 .

[9]  K. Steemers,et al.  Design and overall energy performance of a ventilated photovoltaic façade , 2007 .

[10]  Rustu Eke,et al.  Monitoring the performance of single and triple junction amorphous silicon modules in two building integrated photovoltaic (BIPV) installations , 2013 .

[11]  Nalanie Mithraratne,et al.  Energy analysis of semi-transparent BIPV in Singapore buildings , 2013 .

[12]  E. Caamaño-Martín,et al.  Integral energy performance characterization of semi-transparent photovoltaic elements for building integration under real operation conditions , 2014 .

[13]  Yiping Wang,et al.  Influence of a building's integrated-photovoltaics on heating and cooling loads , 2006 .

[14]  R. Viskanta,et al.  Experimental studies of combined heat transfer in turbulent mixed convection fluid flows in double-skin-façades , 2002 .

[15]  André De Herde,et al.  Optimal operation of a south double-skin facade , 2004 .

[16]  Danny H.W. Li,et al.  Energy and cost analysis of semi-transparent photovoltaic in office buildings , 2009 .

[17]  Tin-Tai Chow,et al.  Potential application of “see-through” solar cells in ventilated glazing in Hong Kong , 2009 .

[18]  Wei Sun,et al.  Experimental and numerical investigation on the performance of amorphous silicon photovoltaics window in East China , 2011 .

[19]  Hongxing Yang,et al.  An experimental study of the thermal performance of a novel photovoltaic double-skin facade in Hong Kong , 2013 .

[20]  Zhang Lin,et al.  Innovative solar windows for cooling-demand climate , 2010 .

[21]  G. J. Yu,et al.  Analysis of thermal and electrical performance of semi-transparent photovoltaic (PV) module , 2010 .

[22]  Andreas K. Athienitis,et al.  Optimization of the performance of double-façades with integrated photovoltaic panels and motorized blinds , 2006 .

[23]  E. Gratia,et al.  Guidelines for improving natural daytime ventilation in an office building with a double-skin facade , 2007 .

[24]  Matthias Haase,et al.  Design Considerations for Double-Skin Facades in Hot and Humid Climates , 2006 .

[25]  Hongxing Yang,et al.  Performance of ventilated double-sided PV façade compared with conventional clear glass façade , 2013 .

[26]  Th. Frank,et al.  Thermal simulation of buildings with double-skin façades , 2005 .

[27]  Wei He,et al.  Performance evaluation of a PV ventilated window applying to office building of Hong Kong , 2007 .

[28]  Hongxing Yang,et al.  Numerical evaluation of the mixed convective heat transfer in a double-pane window integrated with see-through a-Si PV cells with low-e coatings , 2010 .

[29]  S. C. Solanki,et al.  Photovoltaic modules and their applications: A review on thermal modelling , 2011 .