6 – Advances in mechanics

[1]  G. V. Stabler.  The Fundamental Geometry of Cutting Tools , 1951 .

[2]  T. Childs,et al.  Elastic effects in metal cutting chip formation , 1980 .

[3]  E. Usui,et al.  The Theory of Plasticity Applied to Machining With Cut-Away Tools , 1964 .

[4]  Fumio Hashimoto,et al.  The Mechanism of Three-dimensional Cutting Operations (Part 4) , 1966 .

[5]  E. Usui,et al.  Analytical Prediction of Three Dimensional Cutting Process—Part 2: Chip Formation and Cutting Force with Conventional Single-Point Tool , 1978 .

[6]  P.L.B. Oxley,et al.  Prediction of Chip Flow Direction and Cutting Forces in Oblique Machining with Nose Radius Tools , 1995 .

[7]  F. Hashimoto,et al.  The mechanics of Three-dimensional Cutting Operations , 1960 .

[8]  P. Oxley,et al.  An Experimental Investigation of the Influence of Strain-Rate and Temperature on the Flow Stress Properties of a Low Carbon Steel Using a Machining Test: , 1970 .

[9]  T. Shi,et al.  Slip-line solution for orthogonal cutting with a chip breaker and flank wear , 1991 .

[10]  M. E. Merchant.  Mechanics of the Metal Cutting Process. II. Plasticity Conditions in Orthogonal Cutting , 1945 .

[11]  E. Usui,et al.  Analytical Prediction of Three Dimensional Cutting Process , 1978 .

[12]  P. Oxley,et al.  An Experimental Investigation of the Influence of Speed and Scale on the Strain-Rate in a Zone of Intense Plastic Deformation , 1969 .

[13]  R. N. Roth,et al.  Slip-Line Field Analysis for Orthogonal Machining Based upon Experimental Flow Fields: , 1972 .

[14]  P. Dewhurst.  On the non-uniqueness of the machining process , 1978, Proceedings of the Royal Society of London. A. Mathematical and Physical Sciences.

[15]  P. Oxley.  Mechanics of metal cutting , 1961 .

[16]  W. F. Hastings,et al.  A machining theory for predicting chip geometry, cutting forces etc. from work material properties and cutting conditions , 1980, Proceedings of the Royal Society of London. A. Mathematical and Physical Sciences.

[17]  Masami Masuko,et al.  Analytical Prediction of Three Dimensional Cutting Process—Part 1: Basic Cutting Model and Energy Approach , 1978 .

[18]  Hideaki Kudo,et al.  Some new slip-line solutions for two-dimensional steady-state machining , 1965 .

[19]  W. B. Palmer,et al.  Mechanics of Orthogonal Machining , 1959 .