New two-inductor boost converter with auxiliary transformer

A new, two-inductor, two-switch boost converter topology and its variations suitable for applications with a large difference between the input and output voltage are described. The output voltage regulation of the proposed converters is achieved in a wide load and input-voltage range with constant-frequency control by employing an auxiliary transformer that couples the current paths of the two boost inductors.

[1]  Milan M. Jovanovic,et al.  Evaluation of input current in the critical mode boost PFC converter for distributed power systems , 2001, APEC 2001. Sixteenth Annual IEEE Applied Power Electronics Conference and Exposition (Cat. No.01CH37181).

[2]  Fred C. Lee,et al.  Isolated boost circuit for power factor correction , 1993, Proceedings Eighth Annual Applied Power Electronics Conference and Exposition,.

[3]  Peter J. Wolfs.  A current-sourced DC-DC converter derived via the duality principle from the half-bridge converter , 1993, IEEE Trans. Ind. Electron..

[4]  G. Ivensky,et al.  An isolated DC-DC converter using two zero current switched IGBTs in a symmetrical topology , 1994, Proceedings of 1994 Power Electronics Specialist Conference - PESC'94.

[5]  P. Henrard,et al.  Minimization of conduction losses in the boost converter with galvanic isolation , 2001 .

[6]  M. S. Elmore.  Input current ripple cancellation in synchronized, parallel connected critically continuous boost converters , 1996, Proceedings of Applied Power Electronics Conference. APEC '96.

[8]  I. Barbi,et al.  A comparison between two current-fed push-pull DC-DC converters-analysis, design and experimentation , 1996, Proceedings of Intelec'96 - International Telecommunications Energy Conference.

[9]  Johann W. Kolar,et al.  Self-adjusting input current ripple cancellation of coupled parallel connected hysteresis-controlled boost power factor correctors , 1995, Proceedings of PESC '95 - Power Electronics Specialist Conference.

[10]  P ? ? ? ? ? ? ? % ? ? ? ? , 1991 .

[11]  Z. I. Kovatchev.  Design of a 1,2 kW inverter building block for telecommunication supply systems , 2002, 24th Annual International Telecommunications Energy Conference.

[12]  Milan M. Jovanovic,et al.  A comparative study of soft-switched CCM boost rectifiers and interleaved variable-frequency DCM boost rectifier , 2000, APEC 2000. Fifteenth Annual IEEE Applied Power Electronics Conference and Exposition (Cat. No.00CH37058).