Amorphous silicon two-color microbolometer for uncooled IR detection

This paper describes the modeling and design of two-color microbolometers for uncooled infrared (IR) detection. The goal is to develop a high resolution IR detector array that can measure the actual temperature and color of an object based on two spectral wavelength regions. The microbolometer consists of high temperature amorphous silicon (a-Si:H) thin film layer held above the substrate by Si/sub 3/N/sub 4/ bridge. A thin NiCr absorber with sheet resistance of 377 /spl Omega//sqr is used to enhance the optical absorption in the medium and long IR wavelength windows. A tunable micromachined Al-mirror was suspended underneath the detector. The mirror is switched between two positions by the application of an electrostatic voltage. The switching of the mirror between the two positions enables the creation of two wavelength response windows, 3-5 and 8-12 /spl mu/m. A comparison of the two response wavelength windows enables the determination of the actual temperature of a viewed scene obtained by an IR camera. The microbolometer is designed with a low thermal mass of 1.65/spl times/10/sup -9/ J/K and a low thermal conductance of 2.94/spl times/10/sup -7/ W/K to maximize the responsivity R/sub v/ to a value as high as 5.91/spl times/10/sup 4/ W/K and detectivity D/sup */ to a value as high as 2.34/spl times/10/sup 9/ cm Hz/sup 1/2//W at 30 Hz. The corresponding thermal time constant is equal to 5.62 ms. Hence, these detectors could be used for 30-Hz frame rate applications. The extrapolated noise equivalent temperature difference is 2.34 mK for the 8-12 /spl mu/m window and 23 mK for the 3-5 /spl mu/m window. The calculated absorption coefficients in the medium and long IR wavelength windows before color mixing are 66.7% and 83.7%. However, when the color signals are summed at the output channel, the average achieved absorption was 75%.

[1]  O. Degani,et al.  Pull-in study of an electrostatic torsion microactuator , 1998 .

[2]  Daniel F. Murphy,et al.  320 x 240 silicon microbolometer uncooled IR FPAs with on-chip offset correction , 1996, Defense + Commercial Sensing.

[3]  Charles A. Marshall,et al.  A summary of applications of uncooled microbolometer sensors , 1999, 1999 IEEE Aerospace Conference. Proceedings (Cat. No.99TH8403).

[4]  E. Dereniak,et al.  Infrared Detectors and Systems , 1996 .

[5]  G. Stemme,et al.  Thermal characterization of surface-micromachined silicon nitride membranes for thermal infrared detectors , 1997 .

[6]  John F. Brady,et al.  Low-cost low-power uncooled a-Si-based micro infrared camera for unattended ground sensor applications , 1999, Defense, Security, and Sensing.

[7]  Paul W. Kruse,et al.  Chapter 2 Principles of Uncooled Infrared Focal Plane Arrays , 1997 .

[8]  R. Andrew Wood,et al.  Micromachined bolometer arrays achieve low-cost imaging , 1993 .

[9]  Jean-Louis Ouvrier-Buffet,et al.  Amorphous-silicon-based uncooled microbolometer IRFPA , 1999, Defense, Security, and Sensing.

[10]  Donald P. Butler,et al.  Semiconducting YBaCuO microbolometers for uncooled broadband IR sensing , 2001, SPIE Defense + Commercial Sensing.

[11]  Piet De Moor,et al.  Optimization of design and technology for uncooled poly-SiGe microbolometer arrays , 2002, SPIE Defense + Commercial Sensing.

[12]  Jean-Louis Ouvrier-Buffet,et al.  320x240 microblometer uncooled IRFPA , 2000, Defense, Security, and Sensing.

[13]  Mahmoud Almasri,et al.  Uncooled multimirror broad-band infrared microbolometers , 2002 .

[14]  F. Hooge.  1/ƒ noise is no surface effect , 1969 .

[15]  Donald P. Butler,et al.  Semiconducting YBCO bolometers for uncooled IR detection , 2000, Defense, Security, and Sensing.

[16]  Thomas B. Breen,et al.  Even more applications of uncooled microbolometer sensors , 1999, Defense, Security, and Sensing.

[17]  D P Butler,et al.  Two-color thermal detector with thermal chopping for infrared focal-plane arrays. , 2001, Applied optics.

[18]  A. Tanaka,et al.  Silicon IC Process Compatible Bolometer Infrared Focal Plane Array , 1995, Proceedings of the International Solid-State Sensors and Actuators Conference - TRANSDUCERS '95.

[19]  Gamani Karunasiri,et al.  Performance of titanium and amorphous germanium microbolometer infrared detectors , 1999, Other Conferences.

[20]  Daniel F. Murphy,et al.  Microbolometer uncooled infrared camera with 20-mK NETD , 1998, Defense, Security, and Sensing.

[21]  Olaf Reinhold,et al.  Progress of the Swedish-Australian research collaboration on uncooled smart IR sensors , 1998, Optics & Photonics.

[22]  John E. Gray,et al.  Semiconducting YBaCuO as infrared-detecting bolometers , 1998, Optics & Photonics.

[23]  Paul W. Kruse.  Design of uncooled infrared imaging arrays , 1996, Defense + Commercial Sensing.

[24]  J. Wauters,et al.  Doped silicon creates new bolometer material , 1997 .

[25]  Neal R. Butler,et al.  Recent developments in uncooled IR technology , 2000, Defense, Security, and Sensing.

[26]  P. Kruse,et al.  Uncooled infrared imaging arrays and systems , 1997 .