Wall thickness monitoring method for wax pattern of hollow turbine blade

[1]  Fei Li,et al.  Influence of complex structure on the shrinkage of part in investment casting process , 2015 .

[2]  J. Zamani,et al.  An Experimental Comparison on Dimensional Accuracy of Wax Patterns of Gas Turbine Blades Produced by Rapid Tooling , 2014 .

[3]  Kun Jiang,et al.  A multi-objective optimization and decision algorithm for locator layout continuous searching in checking fixture design , 2012, The International Journal of Advanced Manufacturing Technology.

[4]  Pradeep Kumar Jha,et al.  Multi-characteristic optimization of wax patterns in the investment casting process using grey–fuzzy logic , 2013 .

[5]  Pradeep Kumar Jha,et al.  Developments in investment casting process—A review , 2012 .

[6]  Kun Bu,et al.  Geometric parameter-based optimization of the die profile for the investment casting of aerofoil-shaped turbine blades , 2011 .

[7]  Sarika Mishra,et al.  Reverse Solidification Path Methodology for Dewaxing Ceramic Shells in Investment Casting Process , 2010 .

[8]  Dinghua Zhang,et al.  Cavity optimization for investment casting die of turbine blade based on reverse engineering , 2010 .

[9]  Supapan Chaiprapat,et al.  Modeling of positional variability of a fixtured workpiece due to locating errors , 2008 .

[10]  A. Behravesh,et al.  An experimental investigation on dimensional stability of injected wax patterns of gas turbine blades , 2007 .

[11]  Yan Wang,et al.  Optimisation of machining fixture layout under multi-constraints , 2006 .

[12]  Adrian S. Sabau,et al.  Material properties for predicting wax pattern dimensions in investment casting , 2003 .

[13]  Prasad K. Yarlagadda,et al.  Statistical Analysis of Accuracy of Wax Patterns Used in Investment Casting Process , 2003 .

[14]  Michael Yu Wang,et al.  Characterizations of localization accuracy of fixtures , 2002, IEEE Trans. Robotics Autom..

[15]  Michael Yu Wang,et al.  Multi-objective optimal fixture layout design , 2002 .

[16]  Syed H. Masood,et al.  An Investigation of Wax Patterns for Accuracy Improvement in Investment Cast Parts , 2001 .

[17]  M. Y. Wang,et al.  An optimum design for 3-D fixture synthesis in a point set domain , 2000, IEEE Trans. Robotics Autom..

[18]  E. C. De Meter,et al.  Tolerance Analysis of Machining Fixture Locators , 1999 .

[19]  S. Jack Hu,et al.  A Variational Method of Robust Fixture Configuration Design for 3-D Workpieces , 1997 .

[20]  H. Harry Asada,et al.  Kinematic analysis of workpart fixturing for flexible assembly with automatically reconfigurable fixtures , 1985, IEEE J. Robotics Autom..

[21]  P. Eng.,et al.  AIRFOIL THICKNESS AS A LIFE LIMITING FACTOR OF GAS TURBINE BLADES , 2013 .

[22]  R Pradyumna,et al.  CERAMIC CORES FOR TURBINE BLADES : A TOOLING PERSPECTIVE , 2012 .

[23]  Andrew Y. C. Nee,et al.  Robust fixture layout with the multi-objective non-dominated ACO/GA approach , 2011 .

[24]  Lucy Siu-Bik King,et al.  Theoretical approach for generating optimal fixturing locations for prismatic workparts in automated assembly , 1993 .