Underground Upgrading of the Heavy Crude Oil in Content-Saturated Sandstone with Aquathermolysis in the Presence of an Iron Based Catalyst

Increasing the efficiency of thermal recovery methods is an important and relevant task. This study is devoted to reducing heavy components (resins and asphaltenes) and quality improvement of heavy oil by catalytic hydrothermal treatment. The object of this study is a bituminous sandstone sample from the Ashal’cha reservoir. The catalytic (iron tallate) hydrothermal simulation was carried out under reservoir conditions (200 °C, 30 bar). The composition and physicochemical characteristics of the products were studied using elemental and SARA analysis, MALDI, GC-MS, FT-IR. Moreover, the extracted rock is analyzed in XRD and DSA (Drop Shape Analyzer). The introduction of catalyst in combination with a hydrogen donor reduces the content of resins by 22.0%wt. with an increase in the share of saturated hydrocarbons by 27%wt. The destructive hydrogenation leads to a decrease in the sulfur content of upgrading products. This is crucial for the oil reservoirs of the Tatarstan Republic, as their crude oils are characterized by high sulfur content. According to the wettability data, the hydrophilicity of the rock surface increases due to inhibition of the coke formation after the introduction of the catalytic complex. Thus, the oil recovery factor can be increased due to the alteration of the oil-wetting properties of reservoir rocks.

[1]  C. Scott,et al.  In-Situ Upgrading In a Dolomite Porous Medium: A Kinetic Model Comparison and Nanocatalyst Deposition Study , 2021 .

[2]  G. Kayukova,et al.  Catalytic Hydrothermal Conversion of Heavy Oil in the Porous Media , 2021 .

[3]  K. Shchekoldin,et al.  Aquathermolysis of heavy oil in the presence of iron tallate and mineral components of reservoir rock , 2020, IOP Conference Series: Earth and Environmental Science.

[4]  A. Vakhin,et al.  The Composition and Structure of Ultra-Dispersed Mixed Oxide (II, III) Particles and Their Influence on In-Situ Conversion of Heavy Oil , 2020 .

[5]  I. Zakirov,et al.  The complex experimental research results on the solvent composition selection for bituminous oil production , 2019, Neftyanoe khozyaystvo - Oil Industry.

[6]  M. Khelkhal,et al.  Impact of Iron Tallate on the Kinetic Behavior of the Oxidation Process of Heavy Oils , 2019, Energy & Fuels.

[7]  Zhangxin Chen,et al.  Enhanced oil recovery techniques for heavy oil and oilsands reservoirs after steam injection , 2019, Applied Energy.

[8]  A. Vakhin,et al.  Effects of calcite and dolomite on conversion of heavy oil under subcritical condition , 2019, Petroleum Science and Technology.

[9]  A. Vakhin,et al.  The composition of aromatic destruction products of Domanic shale kerogen after aquathermolysis , 2019, Petroleum Science and Technology.

[10]  A. Ivanova,et al.  Composition of aquathermolysis catalysts forming in situ from oil-soluble catalyst precursor mixtures , 2018, Journal of Petroleum Science and Engineering.

[11]  Dong Liu,et al.  Catalytic Effects of Montmorillonite on Coke Formation during Thermal Conversion of Heavy Oil , 2018 .

[12]  G. Batalin,et al.  Modeling of cobalt-based catalyst use during CSS for low-temperature heavy oil upgrading , 2018 .

[13]  Zhangxin Chen,et al.  EOR Potential in the Post Steam Injection Era: Current and Future Trends , 2018 .

[14]  M. Parlaktuna,et al.  Effects of minerals on steam distillation during thermal heavy-oil recovery: An experimental investigation , 2018 .

[15]  A. Vakhin,et al.  Investigating the structure and composition of heavy oil under thermal-catalytic treatment in presence of carbonaceous minerals , 2018 .

[16]  A. S. Noskov,et al.  Studies of Catalytic Properties of Inorganic Rock Matrices in Redox Reactions , 2017 .

[17]  M. Portillo.  INFLUENCE OF ROCK MATRIX IN KINETICS OXIDATION FOR HEAVY OILS , 2017 .

[18]  P. Pereira-Almao,et al.  In- Situ Heavy Oil Upgrading through Ultra-Dispersed Nano-Catalyst Injection in Naturally Fractured Reservoirs: Experimental Section , 2016 .

[19]  G. Kayukova,et al.  Influence of rock-forming and catalytic additives on transformation of highly viscous heavy oil , 2016, Petroleum Chemistry.

[20]  Y. Ganeeva,et al.  Phase composition of asphaltenes , 2014, Journal of Thermal Analysis and Calorimetry.

[21]  N. Petrukhina,et al.  Thermodynamic parameters of conversion reactions of some heavy oil components under the action of steam and heat , 2012, Chemistry and Technology of Fuels and Oils.

[22]  G. Kayukova,et al.  Hydrothermal transformations of asphaltenes , 2012, Petroleum Chemistry.

[23]  G. Kayukova,et al.  Composition of the high-molecular-mass components of oil- and bitumen-bearing rocks and their hydrothermal transformation products , 2011 .

[24]  R. Hashemi,et al.  Experimental Study of Simultaneous Athabasca Bitumen Recovery and Upgrading Using Ultradispersed Catalysts Injection , 2011 .

[25]  Jing He,et al.  GC-MS used in study on the mechanism of the viscosity reduction of heavy oil through aquathermolysis catalyzed by aromatic sulfonic H3PMo12O40 , 2010 .

[26]  Jorge Ancheyta,et al.  Catalytic Aquathermolysis Used for Viscosity Reduction of Heavy Crude Oils: A Review , 2010 .

[27]  J. Zacharia,et al.  Issues with Comparing SARA Methodologies , 2007 .

[28]  G. Kayukova,et al.  Transformation of residual oil in producing formations of the Romashkino oil field during hydrothermal treatment , 2007 .

[29]  L. Zhong,et al.  In Situ Upgrading Heavy Oil by Aquathermolytic Treatment under Steam Injection Conditions , 2005 .

[30]  Yi Zhang,et al.  The catalytic effects of minerals on aquathermolysis of heavy oils , 2004 .

[31]  Lilly Shen,et al.  An experimental study of oil recovery from sewage sludge by low-temperature pyrolysis in a fluidised-bed , 2003 .

[32]  C. Ovalles,et al.  Upgrading of Extra-Heavy Crude Using Hydrogen Donor under Steam Injection Conditions. Characterization by Pyrolysis GC-MS of the Asphaltenes and Effects of a Radical Initiator , 2003 .

[33]  Gordadze Gn,et al.  Generation of saturated biomarker hydrocarbons in the thermolysis of petroleum resins and asphaltenes , 2003 .

[34]  Yongjian Liu and,et al.  The Effect of Hydrogen Donor Additive on the Viscosity of Heavy Oil during Steam Stimulation , 2002 .

[35]  S. Harayama,et al.  Petroleum biodegradation in marine environments. , 1999, Journal of molecular microbiology and biotechnology.

[36]  Yongchun Tang,et al.  Comparison of rate constants for some molecular tracers generated during artificial maturation of kerogens : influence of kerogen type , 1997 .

[37]  P. Clark,et al.  Studies on the Upgrading of Bituminous Oils with Water and Transition Metal Catalysts , 1994 .

[38]  A. Katritzky,et al.  Aqueous organic chemistry. 1. Aquathermolysis: comparison with thermolysis in the reactivity of aliphatic compounds , 1990 .

[39]  A. Katritzky,et al.  Aqueous organic chemistry. 2. Crosslinked cyclohexyl phenyl compounds , 1990 .

[40]  E. C. Sanford,et al.  Mild hydrocracking of bitumen-derived coker and hydrocracker heavy gas oils: kinetics, product yields, and product properties , 1989 .

[41]  Henry J. Ramey,et al.  A Current Look at Thermal Recovery , 1969 .