Biomass gasification in a 100 kWth steam-oxygen blown circulating fluidized bed gasifier: Effects of operational conditions on product gas distribution and tar formation

Abstract Biomass gasification is one of the most promising technologies for converting biomass, a renewable source, into an easily transportable and usable fuel. Two woody biomass fuels Agrol and willow, and one agriculture residue Dry Distiller’s Grains with Solubles (DDGS), have been tested using an atmospheric pressure 100 kWth steam-oxygen blown circulating fluidized bed gasifier (CFB). The effects of operational conditions (e.g. steam to biomass ratio (SBR), oxygen to biomass stoichiometric ratio (ER) and gasification temperature) and bed materials on the composition distribution of the product gas and tar formation from these fuels were investigated. Experimental results show that there is a significant variation in the composition of the product gas produced. Among all the experiments, the averaged concentration of H 2 obtained from Agrol, willow and DDGS over the temperature range from 800 to 820 °C was around 24 vol.%, 28 vol.% and 20 vol.% on a N 2 free basis, respectively. A fairly high amount of H 2 S (∼2300 ppmv), COS (∼200 ppmv) and trace amounts of methyl mercaptan ( 2 free basis were obtained from DDGS. Due to a relatively high content of K and Cl in DDGS fuel, an alkali-getter (e.g. kaolin) was added to avoid agglomeration during gasification. Higher temperatures and SBR values were favorable for increasing the mole ratio of H 2 to CO and the tar decomposition but less advantageous for the formation of CH 4 . Meanwhile, higher temperatures and SBR values also led to higher gas yields, whereas a higher SBR caused a lower carbon conversion efficiency (CCE%), cold gas efficiency (CGE%) and heating values of the product gas due to a high steam content in the product gas. From solid phase adsorption (SPA) results, the total tar content obtained from Agrol was the highest at around 12.4 g/Nm 3 , followed by that from DDGS and willow gasification. The lowest tar content produced from Agrol, willow and DDGS using Austrian olivine (Bed 1) as bed materials was 5.7, 4.4 and 7.3 g/Nm 3 , values which were obtained at a temperature of 730, 820 and 730 °C, SBR of 1.52, 1.14 and 1.10, and ER of 0.36, 0.39 and 0.37, respectively.

[1]  José L. Figueiredo,et al.  Pyrolysis kinetics of lignocellulosic materials—three independent reactions model , 1999 .

[2]  J. R. Kim,et al.  Biomass gasification in a circulating fluidized bed , 2004 .

[3]  Changhou Liu,et al.  Steam gasification of biomass for hydrogen-rich gas in a free-fall reactor , 2007 .

[4]  José Corella,et al.  Biomass gasification in fluidized bed : where to locate the dolomite to improve gasification? , 1999 .

[5]  C. M. Kinoshita,et al.  An experimental investigation of hydrogen production from biomass gasification , 1998 .

[6]  A. Attar,et al.  The Rate and the Fundamental Mechanisms of the Reaction of Hydrogen Sulfide with the Basic Minerals in Coal , 1979 .

[7]  Animesh Dutta,et al.  Thermodynamic Equilibrium Model and Second Law Analysis of a Downdraft Waste Gasifier , 2007 .

[8]  M. Aznar,et al.  Biomass gasification in atmospheric and bubbling fluidized bed: effect of the type of gasifying agent on the product distribution , 1999 .

[9]  M. Aznar,et al.  Biomass Gasification in Fluidized Bed at Pilot Scale with Steam−Oxygen Mixtures. Product Distribution for Very Different Operating Conditions , 1997 .

[10]  Gerrit Brem,et al.  Review of Catalysts for Tar Elimination in Biomass Gasification Processes , 2004 .

[11]  P. M. Pelagagge,et al.  Economics of biomass energy utilization in combustion and gasification plants: effects of logistic variables , 2005 .

[12]  T. Schildhauer,et al.  Reactive bed materials for improved biomass gasification in a circulating fluidised bed reactor , 2008 .

[13]  Andrew Narvaez,et al.  Biomass gasification with air in an atmospheric bubbling fluidized bed. Effect of six operational variables on the quality of the produced raw gas , 1996 .

[14]  Kj Krzysztof Ptasinski,et al.  A review of the primary measures for tar elimination in biomass gasification processes , 2003 .

[15]  L. T. Fan,et al.  Fluidized-bed steam gasification of rice hull , 1992 .

[16]  Jacopo Giuntoli,et al.  Quantitative and kinetic TG-FTIR study of biomass residue pyrolysis: Dry distiller's grains with solubles (DDGS) and chicken manure , 2009 .

[17]  David D Jones,et al.  Steam-air fluidized bed gasification of distillers grains: Effects of steam to biomass ratio, equivalence ratio and gasification temperature. , 2009, Bioresource technology.

[18]  C. M. Kinoshita,et al.  Tar formation under different biomass gasification conditions , 1994 .

[19]  A. Mohamed,et al.  Gasification of lignocellulosic biomass in fluidized beds for renewable energy development: A review , 2010 .

[20]  José Corella,et al.  Commercial steam reforming catalysts to improve biomass gasification with steam-oxygen mixtures. 2: Catalytic tar removal , 1998 .

[21]  Isabel Cabrita,et al.  The study of reactions influencing the biomass steam gasification process , 2003 .

[22]  S. Channiwala,et al.  A UNIFIED CORRELATION FOR ESTIMATING HHV OF SOLID, LIQUID AND GASEOUS FUELS , 2002 .

[23]  S. Rapagnà.  Steam-gasification of biomass in a fluidised-bed of olivine particles. , 2000 .

[24]  Chuang-zhi Wu,et al.  Hydrogen-rich gas production from biomass air and oxygen/steam gasification in a downdraft gasifier , 2007 .

[25]  Kalyan Annamalai,et al.  Adiabatic fixed bed gasification of dairy biomass with air and steam , 2010 .

[26]  Claes Brage,et al.  Use of amino phase adsorbent for biomass tar sampling and separation , 1997 .

[27]  A.H.M. Verkooijen,et al.  Effect of Magnesite as Bed Material in a 100 kWth Steam−Oxygen Blown Circulating Fluidized-Bed Biomass Gasifier on Gas Composition and Tar Formation , 2009 .

[28]  C. M. Kinoshita,et al.  Experimental analysis of biomass gasification with steam and oxygen , 1992 .

[29]  Jie Feng,et al.  Formation of tar and its characterization during air–steam gasification of sawdust in a fluidized bed reactor , 2010 .

[30]  André Faaij,et al.  Bio-energy in Europe: changing technology choices , 2006 .

[31]  Kunio Yoshikawa,et al.  High temperature steam-only gasification of woody biomass , 2010 .

[32]  José Corella,et al.  Biomass Gasification with Steam and Oxygen Mixtures at Pilot Scale and with Catalytic Gas Upgrading. Part I: Performance of the Gasifier , 1997 .

[33]  B. Kelleher,et al.  Review of literature on catalysts for biomass gasification , 2001 .

[34]  K. Cen,et al.  Biomass-oxygen gasification in a high-temperature entrained-flow gasifier. , 2009, Biotechnology advances.

[35]  Jie Chang,et al.  Biomass air-steam gasification in a fluidized bed to produce hydrogen-rich gas , 2003 .

[36]  Adam Klimanek,et al.  Enhanced Yield of Hydrogen From Wastes Using High Temperature Steam Gasification , 2006 .

[37]  Anders Nordin,et al.  Bed Agglomeration Characteristics during Fluidized Bed Combustion of Biomass Fuels , 2000 .

[38]  K. Sjöström,et al.  Tar evolution profiles obtained from gasification of biomass and coal , 2000 .

[39]  R. Warnecke,et al.  Gasification of biomass: comparison of fixed bed and fluidized bed gasifier , 2000 .

[40]  Heejoon Kim,et al.  The reduction and control technology of tar during biomass gasification/pyrolysis: An overview , 2008 .

[41]  Yijun Zhao,et al.  Characteristics of rice husk gasification in an entrained flow reactor. , 2009, Bioresource technology.