A fractal-based quasi-dimensional combustion model for SI engines fuelled by hydrogen enriched compressed natural gas

Abstract A quasi-dimensional model based on the concepts of fractal geometry has been developed for an SI engine fuelled with natural gas/hydrogen blends. The fundamentals of the thermodynamic model, the fractal combustion model and related equations are introduced. This paper investigates the influence of manifold absolute pressure, equivalence ratio and hydrogen fraction on fractal dimension and improves the fractal dimension expression. Comparisons are conducted between the improved and original models by the prediction outcomes. After the determination of model constants by calibration, the model predictions of cylinder pressure histories and mass fraction burned of an HCNG engine are then compared with experimental data over a wide range of loads, equivalence ratios, engine speeds and hydrogen blending ratios. The pressure profiles show that predictions of the improved model match quite well with the experimental results except for the early combustion stage. The improved model is proved to be more suitable for predicting HCNG engine performance.

[1]  Ronald D. Matthews,et al.  Use of Fractal Geometry to Model Turbulent Combustion in SI Engines , 1992 .

[2]  G. Woschni.  A Universally Applicable Equation for the Instantaneous Heat Transfer Coefficient in the Internal Combustion Engine , 1967 .

[3]  Yu Wang,et al.  Development and validation of a quasi-dimensional combustion model for SI engines fuelled by HCNG with variable hydrogen fractions , 2008 .

[4]  C. R. Ferguson,et al.  A Turbulent Entrainment Model for Spark-Ignition Engine Combustion , 1977 .

[5]  Kirk Collier,et al.  Experimental study of a clean burning vehicle fuel , 1995 .

[6]  Matthew J. Hall,et al.  Combustion modeling in si engines with a peninsula-fractal combustion model , 1996 .

[7]  Bing Liu,et al.  Experimental investigation on performance and emissions of a spark-ignition engine fuelled with natural gas–hydrogen blends combined with EGR , 2009 .

[8]  Bing Liu,et al.  Experimental study on engine performance and emissions for an engine fueled with natural gas-hydrogen mixtures , 2006 .

[9]  Fanhua Ma,et al.  Study on the calibration coefficients of a quasi-dimensional model for HCNG engine , 2011 .

[10]  Ronald D. Matthews,et al.  Effects of Engine Speed on Combustion in SI Engines: Comparisons of Predictions of a Fractal Burning Model with Experimental Data , 1993 .

[11]  N. Kahraman,et al.  Internal combustion engines fueled by natural gas—hydrogen mixtures , 2004 .

[12]  James C. Keck,et al.  EXPERIMENTAL AND THEORETICAL INVESTIGATION OF TURBULENT BURNING MODEL FOR INTERNAL COMBUSTION ENGINES , 1974 .

[13]  Jae In Park,et al.  Performance Analysis and Valve Event Optimization for SI Engines Using Fractal Combustion Model , 2006 .

[14]  Eiji Tomita,et al.  Measurement and Simulation of Turbulent Flame Propagation in a Spark Ignition Engine by Using Fractal Burning Model , 2001 .

[15]  Andrea Catania,et al.  Development of an Improved Fractal Model for the Simulation of Turbulent Flame Propagation in SI Engines , 2005 .

[16]  Yong Li,et al.  Experimental study on thermal efficiency and emission characteristics of a lean burn hydrogen enriched natural gas engine , 2007 .

[17]  Yu Wang,et al.  A Quasi-Dimensional Combustion Model for SI Engines Fuelled by Hydrogen Enriched Compressed Natural Gas , 2008 .

[18]  Zuo-hua Huang,et al.  Experimental study on combustion characteristics of a spark-ignition engine fueled with natural gas–hydrogen blends combining with EGR , 2009 .

[19]  Ömer L. Gülder,et al.  Characterization of flame front surfaces in turbulent premixed methane/Air combustion , 1995 .

[20]  Enrico Mattarelli,et al.  A quasi-dimensional combustion model for performance and emissions of SI engines running on hydrogen–methane blends , 2010 .

[21]  Roger Sierens,et al.  A quasi-dimensional model for the power cycle of a hydrogen-fuelled ICE , 2007 .

[22]  A. Di Benedetto,et al.  Laminar burning velocity of hydrogen-methane/air premixed flames , 2007 .

[23]  Taewoo Lee,et al.  Direct comparison of turbulent burning velocity and flame surface properties in turbulent premixed flames , 2003 .

[24]  Fabian Mauss,et al.  Analytic approximations of burning velocities and flame thicknesses of lean hydrogen, methane, ethylene, ethane, acetylene, and propane flames , 1992 .

[25]  Giovanni Pede,et al.  Experimental tests of blends of hydrogen and natural gas in light-duty vehicles , 2008 .

[26]  Bing Liu,et al.  Combustion characteristics of a direct-injection engine fueled with natural gas–hydrogen blends under different ignition timings , 2007 .

[27]  F. Halter,et al.  Fractal characterisation of high-pressure and hydrogen-enriched CH4–air turbulent premixed flames , 2007 .

[28]  Ferenc Hamori,et al.  Exploring the limits of hydrogen assisted jet ignition , 2006 .

[29]  Domenic A. Santavicca,et al.  A fractal model of turbulent flame kernel growth , 1990 .

[30]  R. Sierens,et al.  Variable composition hydrogen/natural gas mixtures for increased engine efficiency and decreased emissions , 2000 .

[31]  Ronald D. Matthews,et al.  A fractal-based SI engine model: Comparisons of predictions with experimental data , 1991 .

[32]  Zuo-hua Huang,et al.  Measurements of laminar burning velocities for natural gas–hydrogen–air mixtures , 2006 .

[33]  Ömer L. Gülder,et al.  Flame front surface characteristics in turbulent premixed propane/air combustion , 2000 .