A real time human–machine interface for an ultrahigh temperature MEMS sensor–igniter

Abstract The progress of numerous emerging technologies is currently hampered by a disconnect between material science and engineering applications. The potential of nano-scale engineering can not be fully exploited as long as basic material science and engineering are not integrated. This paper is concerned with the development of a novel computational methodology that unites fundamental materials science, mechanical design, reliability analysis, and system level performance assessment in an interactive environment called the human–machine interface (HMI). The HMI serves as a real time display of the performance and the status of the device, e.g. the remaining life, and provides a simulation platform for design and optimization. The architecture and performance of the HMI is demonstrated by the example of an ultrahigh temperature MEMS sensor–igniter. The device is fabricated from a novel polymer derived ceramic (PDC) called silicon carbonitride (SiCN). The HMI methodology is portable to health monitoring of other high temperature systems such as gas turbine engines, missile systems, and high temperature processing of advanced materials.

[1]  Rishi Raj,et al.  An Interdisciplinary Framework for the Design and Life Prediction of Engineering Systems , 2000 .

[2]  H. Kleebe,et al.  Newtonian Viscosity of Amorphous Silicon Carbonitride at High Temperature , 2005 .

[3]  D. Frangopol,et al.  A system level partitioning approach for analyzing the origins of variability in life prediction of tungsten filaments for incandescent lamps , 1999 .

[4]  M. Christ,et al.  High-temperature deformation of amorphous Si–C–N and Si–B–C–N ceramics derived from polymers , 2002 .

[5]  F. Aldinger,et al.  Compression creep behaviour of precursor-derived SiCN Ceramics , 1999 .

[6]  Sandeep R. Shah,et al.  Oxidation Kinetics of an Amorphous Silicon Carbonitride Ceramic , 2004 .

[7]  V. Bright,et al.  Processing and characterization of silicon carbon-nitride ceramics: application of electrical properties towards MEMS thermal actuators☆ , 2003 .

[8]  Ganesh Subbarayan,et al.  A METHODOLOGY FOR INTEGRATING MATERIALS SCIENCE WITH SYSTEM ENGINEERING , 1999 .

[9]  V. Bright,et al.  Fabrication of SiCN MEMS by photopolymerization of pre-ceramic polymer , 2002 .

[10]  D. Balzar,et al.  Structure and Electronic Transport Properties of Si‐(B)‐C‐N Ceramics , 2004 .

[11]  Rishi Raj,et al.  Life Prediction of Tungsten Filaments in Incandescent Lamps , 1978 .

[12]  R. Raj,et al.  Introduction to the Special Topical Issue on Ultrahigh‐Temperature Polymer‐Derived Ceramics , 2004 .

[13]  V. Bright,et al.  Ceramic MEMS new materials, innovative processing and future applications , 2001 .

[14]  Victor M. Bright,et al.  Fabrication of SiCN ceramic MEMS using injectable polymer-precursor technique , 2001 .