Design and validation of a hybrid laser/water-jet machining system for brittle materials

A unique laser/water-jet (LWJ) cutting head has been designed, built, and interfaced with a CO2 laser for cutting and scribing of hard and brittle ceramic materials. Alumina samples were used to validate the effectiveness of the LWJ cutting head in thermal fracture mode. The results were compared with vaporization mode (focused beam) as well as thermal fracture mode (defocused beam) of air-assisted laser cutting. The thermal fracture mode in both LWJ and air-assisted laser cutting required three to five times less energy input for material separation than the vaporization mode. However, the quality of the cut surfaces of the LWJ was superior to both vaporization and thermal fracture modes of air-assisted laser cutting in terms of kerf, recast zone, density of microcracks, undercutting, and spatter. The synergistic effects of laser and water-jet facilitated precise material separation and better cut quality through: thermal shock-induced fracture mode of material separation rather than energy-intensive ero...

[1]  Y. Liu,et al.  Experimental investigations of machining characteristics and removal mechanisms of advanced ceramics in high speed deep grinding , 2003 .

[2]  T. Elperin,et al.  Formation of Surface Microcrack for Separation of Nonmetallic Wafers Into Chips , 2000 .

[3]  A. E. Segall,et al.  Faster and Damage-Reduced Laser-Cutting of Thick Ceramics Using a Simultaneous Prescore Approach , 2005 .

[4]  J. C. Jaeger,et al.  Conduction of Heat in Solids , 1952 .

[5]  Jun Wang,et al.  The Cutting Performance in Multipass Abrasive Waterjet Machining of Industrial Ceramics , 2003 .

[6]  Michael Bass,et al.  Laser Materials Processing , 2018 .

[7]  Chwan-Huei Tsai,et al.  Fracture Mechanism of Laser Cutting With Controlled Fracture , 2003 .

[8]  C. Harper.  Handbook of Ceramics Glasses, and Diamonds , 2001 .

[9]  Y. Jaluria,et al.  An Introduction to Heat Transfer , 1950 .

[10]  J. Wang,et al.  A study of abrasive waterjet cutting of alumina ceramics with controlled nozzle oscillation , 2005 .

[11]  B. Li,et al.  Fracture control of unsupported ceramics during laser machining using a simultaneous prescore , 2005 .

[12]  Y. Shin,et al.  Experimental Evaluation of the Laser Assisted Machining of Silicon Nitride Ceramics , 1998, Manufacturing Science and Engineering.

[13]  B. Li,et al.  A thermal stress and failure model for laser cutting and forming operations , 2004 .

[14]  Chwan-Huei Tsai,et al.  Applying an On-line Crack Detection Technique For Laser Cutting by Controlled Fracture , 2001 .

[15]  N. Nishioka,et al.  Comparison of pulsed CO2 laser ablation at 10.6 μm and 9.5 μm , 1998 .

[16]  Jun Wang,et al.  Abrasive Waterjet Machining of Polymer Matrix Composites – Cutting Performance, Erosive Process and Predictive Models , 1999 .