Investigation of the behaviour of selected ultrasonic guided wave modes to inspect rails for long-range testing and monitoring

Long-range ultrasonic testing (LRUT) uses guided waves in the kilohertz range to inspect many metres of an elongated component from a single point of access. This has considerable advantages for the rapid testing of long lengths for the detection of potentially harmful defects. This technique is well developed for structures that have a simple geometry, such as plates, rods, and pipes. However, this is a relatively new technology and there is still much to learn about the behaviour of guided waves and their application in complex structures, such as railway rails. The aim of this work was to identify suitable ultrasonic-guided wave modes that can detect common types of defects in each part of a rail (i.e. the head, web, and foot). The investigation was carried out using finite-element analysis and was validated experimentally. The findings of this research demonstrated the ability to detect transverse defects as small as 2 mm and 5 mm in the head and foot, respectively.

[1]  J. Rose,et al.  Calculation for Guided Waves in Pipes and Rails , 2004 .

[2]  L. Gavric.  Computation of propagative waves in free rail using a finite element technique , 1995 .

[3]  David Thompson,et al.  Investigations of propagating wave types in railway tracks at high frequencies , 2008 .

[4]  David Thompson,et al.  EXPERIMENTAL ANALYSIS OF WAVE PROPAGATION IN RAILWAY TRACKS , 1997 .

[5]  Peter Cawley,et al.  Defect detection in rails using ultrasonic surface waves , 2007 .

[6]  Roderick A. Smith,et al.  Railway fatigue failures: an overview of a long standing problem , 2005 .

[7]  P.D. Wilcox,et al.  A rapid signal processing technique to remove the effect of dispersion from guided wave signals , 2003, IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.

[8]  Paul D. Wilcox,et al.  LONG RANGE INSPECTION OF RAIL USING GUIDED WAVES , 2003 .

[9]  P. Wilcox,et al.  The effect of load on guided wave propagation. , 2007, Ultrasonics.

[10]  Ivan Bartoli,et al.  Modeling guided wave propagation with application to the long-range defect detection in railroad tracks , 2005 .

[11]  T. Heckel,et al.  Advantage of a combined ultrasonic and eddy current examination for railway inspection trains , 2007 .

[12]  J. Rose,et al.  Guided wave dispersion curves for a bar with an arbitrary cross-section, a rod and rail example. , 2003, Ultrasonics.

[13]  Paul D. Wilcox,et al.  Guided wave testing of rail , 2003 .

[14]  Laurence J. Jacobs,et al.  Modeling elastic wave propagation in waveguides with the finite element method , 1999 .

[15]  S. L. Grassie,et al.  Rail defects: an overview , 2003 .

[16]  R. M. Sanderson,et al.  The application of finite element modelling to guided ultrasonic waves in rails , 2002 .

[17]  Joseph L. Rose,et al.  A guided wave approach to defect detection under shelling in rail , 2009 .

[18]  Michele Meo,et al.  A new damage detection technique based on wave propagation for rails , 2006 .