Determination of the centre of mass kinematics in alpine skiing using differential global navigation satellite systems

Abstract In the sport of alpine skiing, knowledge about the centre of mass (CoM) kinematics (i.e. position, velocity and acceleration) is essential to better understand both performance and injury. This study proposes a global navigation satellite system (GNSS)-based method to measure CoM kinematics without restriction of capture volume and with reasonable set-up and processing requirements. It combines the GNSS antenna position, terrain data and the accelerations acting on the skier in order to approximate the CoM location, velocity and acceleration. The validity of the method was assessed against a reference system (video-based 3D kinematics) over 12 turn cycles on a giant slalom skiing course. The mean (± s) position, velocity and acceleration differences between the CoM obtained from the GNSS and the reference system were 9 ± 12 cm, 0.08 ± 0.19 m · s-1 and 0.22 ± 1.28 m · s-2, respectively. The velocity and acceleration differences obtained were smaller than typical differences between the measures of several skiers on the same course observed in the literature, while the position differences were slightly larger than its discriminative meaningful change. The proposed method can therefore be interpreted to be technically valid and adequate for a variety of biomechanical research questions in the field of alpine skiing with certain limitations regarding position.

[1]  Alain Geiger,et al.  The Effect of Different Global Navigation Satellite System Methods on Positioning Accuracy in Elite Alpine Skiing , 2014, Sensors.

[2]  P Haugen,et al.  The application of principal component analysis to quantify technique in sports , 2014, Scandinavian journal of medicine & science in sports.

[3]  Jörg Spörri,et al.  Mechanics of turning and jumping and skier speed are associated with injury risk in men's World Cup alpine skiing: a comparison between the competition disciplines , 2014, British Journal of Sports Medicine.

[4]  Jörg Spörri,et al.  Verletzungsprävention innerhalb eines internationalen Sportverbandes – Eine Prozessbeschreibung am Beispiel des alpinen Skirennsports , 2013 .

[5]  Erich Müller,et al.  Determination of External Forces in Alpine Skiing Using a Differential Global Navigation Satellite System , 2013, Sensors.

[6]  B. Nemec,et al.  Aerodynamic drag is not the major determinant of performance during giant slalom skiing at the elite level , 2013, Scandinavian journal of medicine & science in sports.

[7]  Erich Müller,et al.  Turn Characteristics of a Top World Class Athlete in Giant Slalom: A Case Study Assessing Current Performance Prediction Concepts , 2012 .

[8]  Erich Müller,et al.  Course setting and selected biomechanical variables related to injury risk in alpine ski racing: an explorative case study , 2012, British Journal of Sports Medicine.

[9]  M. Supej,et al.  Mechanical parameters as predictors of performance in alpine World Cup slalom racing , 2011, Scandinavian journal of medicine & science in sports.

[10]  Matej Supej,et al.  A New Time Measurement Method Using a High-End Global Navigation Satellite System to Analyze Alpine Skiing , 2011, Research quarterly for exercise and sport.

[11]  Erich Müller,et al.  Collecting kinematic data on a ski/snowboard track with panning, tilting, and zooming cameras: Is there sufficient accuracy for a biomechanical analysis? , 2010, Journal of sports sciences.

[12]  Matej Supej,et al.  3D measurements of alpine skiing with an inertial sensor motion capture suit and GNSS RTK system , 2010, Journal of sports sciences.

[13]  R. Bahr,et al.  Injuries among male and female World Cup alpine skiers , 2009, British Journal of Sports Medicine.

[14]  Jürgen Edelmann-Nusser,et al.  Biomechanical analysis in freestyle snowboarding: Application of a full‐body inertial measurement system and a bilateral insole measurement system , 2009 .

[15]  C. Brezinski,et al.  Numerical Methods for Engineers and Scientists , 2008 .

[16]  Gerald V. Smith,et al.  Mechanical Energy Dissipation and Performance in Alpine Ski Racing: 1247 , 2008 .

[17]  Wyatt Page,et al.  Fusion motion capture: A prototype system using inertial measurement units and GPS for the biomechanical analysis of ski racing , 2008 .

[18]  Jan Skaloud,et al.  Synergy of CP-DGPS, Accelerometry and Magnetic Sensors for Precise Trajectography in Ski Racing , 2003 .

[19]  Erich Müller,et al.  Biomechanical aspects of new techniques in alpine skiing and ski-jumping , 2003, Journal of sports sciences.

[20]  P. Leva Adjustments to Zatsiorsky-Seluyanov's segment inertia parameters. , 1996 .

[21]  K. M. Jackson,et al.  Fitting of Mathematical Functions to Biomechanical Data , 1979, IEEE Transactions on Biomedical Engineering.

[22]  J M Morawski,et al.  Control systems approach to a ski-turn analysis. , 1973, Journal of biomechanics.

[23]  F. Meyer,et al.  Biomechanical analysis of alpine skiers performing giant slalom turns , 2012 .

[24]  R. Reid,et al.  A kinematic and kinetic study of alpine skiing technique in slalom , 2010 .

[25]  Julien Favre,et al.  Knee joint kinematics measurement in alpine skiing based on inertial sensors , 2010 .

[26]  Ph. Limpach,et al.  Trajectographie de courses de ski alpin avec GPS , 2003 .

[27]  Vladimir M. Zatsiorsky,et al.  Kinetics of Human Motion , 2002 .

[28]  Christian Raschner,et al.  Carving turns versus traditional parallel turns - a comparative biomechanical analysis , 2000 .

[29]  M. D. Berg Computational geometry: algorithms and applications , 1997 .

[30]  Claude Brezinski,et al.  Numerical Methods for Engineers and Scientists , 1992 .