Effect of the fiber’s temperature on lasing performance is investigated in high-power, cladding-pumped Er, Yb co-doped fiber laser system. A three-layer symmetric cylindrical model is applied to describe the temperature distribution of the fiber under natural air convection. Radial temperature distribution of the fiber is calculated with consideration of the quantum defect heat, the heat from the absorption of spontaneous emission, and the convection and radiation at the heat transfer boundaries. The steady-state theoretical model based on rate equations takes into account of the energy transfers between Er3+-ions and Yb3+-ions and a fraction of nonparticipatory Yb3+-ions. Shooting method and Newton iteration method are used to solve the boundary-value problems under different environmental temperatures, pump powers and reflectivities at the fiber ends. Numerical simulations are consistent with experimental results and show that increasing the fiber’s temperature is an effective strategy to suppress the 1 μm parasitic lasing and improve the lasing performance at 1.5 μm, a similar phenomenon is found with enhancing doping concentrations of the two ions and decreasing the reflectivities at the fiber ends. Our numerical results present a theoretical guideline for further improving the laser performance in terms of output power of ~1.5 μm in high-power Er,Yb-doped fiber laser systems.
[1]
D. Mccumber,et al.
Theory of Phonon-Terminated Optical Masers
,
1964
.
[2]
Jiping Ning,et al.
Numerical Investigation of the ASE and Power Scaling of Cladding-Pumped Er–Yb Codoped Fiber Amplifiers
,
2010,
IEEE Journal of Quantum Electronics.
[3]
R. Horley,et al.
Erbium:Ytterbium Codoped Large-Core Fiber Laser With 297-W Continuous-Wave Output Power
,
2007,
IEEE Journal of Selected Topics in Quantum Electronics.
[4]
Mali Gong,et al.
Numerical analysis of temperature distributions in Yb-doped double-clad fiber lasers with consideration of radiative heat transfer
,
2006
.
[5]
Amos A. Hardy,et al.
Modeling high-power Er/sup 3+/-Yb/sup 3+/ codoped fiber lasers
,
2003
.
[6]
Oleg Ryabushkin,et al.
Steady-state heating of active fibres under optical pumping
,
2011
.
[7]
M. Karasek,et al.
Optimum design of Er/sup 3+/-Yb/sup 3+/ codoped fibers for large-signal high-pump-power applications
,
1997
.
[8]
Todd S. Rose,et al.
Secondary energy transfer and nonparticipatory Yb 3+ ions in Er 3+ -Yb 3+ high-power amplifier fibers
,
2004
.
[9]
George C. Valley,et al.
Modeling Cladding-Pumped Er/Yb Fiber Amplifiers
,
2001
.