A CMOS switched transconductor mixer

A new CMOS active mixer topology can operate at low supply voltages by the use of switches exclusively connected to the supply voltages. Such switches require less voltage headroom and avoid gate-oxide reliability problems. Mixing is achieved by exploiting two transconductors with cross-coupled outputs, which are alternatingly activated by the switches. For ideal switching, the operation is equivalent to a conventional active mixer. This paper analyzes the performance of the switched transconductor mixer, in comparison with the conventional mixer, demonstrating competitive performance at a lower supply voltage. Moreover, the new mixer has a fundamental noise benefit, as noise produced by the switch-transistors and LO-port is common mode noise, which is rejected at the differential output. An experimental prototype with 12-dB conversion gain was designed and realized in standard 0.18-/spl mu/m CMOS to operate at only a 1-V supply. Experimental results show satisfactory mixer performance up to 4 GHz and confirm the fundamental noise benefit.

[1]  R.G. Meyer,et al.  Intermodulation distortion in current-commutating CMOS mixers , 2000, IEEE Journal of Solid-State Circuits.

[2]  M. Steyaert,et al.  A 2-V CMOS cellular transceiver front-end , 2000, IEEE Journal of Solid-State Circuits.

[3]  M. Tiebout,et al.  A 50 GHz direct injection locked oscillator topology as low power frequency divider in 0.13 /spl mu/m CMOS , 2003, ESSCIRC 2004 - 29th European Solid-State Circuits Conference (IEEE Cat. No.03EX705).

[4]  M. Tiebout,et al.  A 1V fully integrated CMOS transformer based mixer with 5.5dB gain, 14.5dB SSB noise figure and 0dBm input IP3 , 2003, ESSCIRC 2004 - 29th European Solid-State Circuits Conference (IEEE Cat. No.03EX705).

[5]  Qiang Li,et al.  Soft breakdown and hot carrier reliability of CMOS RF mixer and redesign , 2002, 2002 IEEE Radio Frequency Integrated Circuits (RFIC) Symposium. Digest of Papers (Cat. No.02CH37280).

[6]  Bumman Kim,et al.  Linearity analysis of CMOS for RF application , 2002, 2002 IEEE MTT-S International Microwave Symposium Digest (Cat. No.02CH37278).

[7]  Hiroshi Iwai,et al.  CMOS technology-year 2010 and beyond , 1999, IEEE J. Solid State Circuits.

[8]  Michiel Steyaert,et al.  Switched-opamp: an approach to realize full CMOS switched-capacitor circuits at very low power supply voltages , 1994, IEEE J. Solid State Circuits.

[9]  B. Nauta,et al.  A 1 Volt switched transconductor mixer in 0.18 /spl mu/m CMOS , 2003, 2003 Symposium on VLSI Circuits. Digest of Technical Papers (IEEE Cat. No.03CH37408).

[10]  Eric A. M. Klumperink,et al.  Systematic comparison of HF CMOS transconductors , 2003, IEEE Trans. Circuits Syst. II Express Briefs.

[11]  A.A. Abidi,et al.  Noise in RF-CMOS mixers: a simple physical model , 2000, IEEE Journal of Solid-State Circuits.

[12]  E. Klumperink,et al.  Modeling random telegraph noise under switched bias conditions using cyclostationary RTS noise , 2003 .

[13]  Robert G. Meyer,et al.  Noise in current-commutating CMOS mixers , 1999, IEEE J. Solid State Circuits.

[14]  R. van Langevelde,et al.  Accurate drain conductance modeling for distortion analysis in MOSFETs , 1997, International Electron Devices Meeting. IEDM Technical Digest.