A quantum corrected energy-transport model for nanoscale semiconductor devices

An energy transport model coupled with the density gradient method as quantum mechanical corrections is proposed and numerically investigated. This new model is comprehensive in both physical and mathematical aspects. It is capable of describing hot electron transport as well as significant quantum mechanical effects for advanced devices with dimensions comparable to the de Broglie wave-length. The model is completely self-adjoint for all state variables and hence provides many appealing mathematical features such as global convergence, fast iterative solution, and highly parallelizable. Numerical simulations on diode and MOSFET with the gate length down to 34 nm using this model have been performed and compared with that using the classical transport model. It is shown that the I-V characteristics of this short-channel device is significantly corrected by the density-gradient equations with current drive reduced by up to 60% comparing with that of the classical model along. Moreover, a 2D quantum layer, which is only a fraction of the length scale of inversion layer, is also effectively captured by this new model with very fine mesh near the interface produced by an adaptive finite element method.

[1]  G. Iafrate,et al.  Quantum correction to the equation of state of an electron gas in a semiconductor. , 1989, Physical review. B, Condensed matter.

[2]  Ansgar Jüngel,et al.  Numerical Discretization of Energy-Transport Models for Semiconductors with Nonparabolic Band Structure , 2000, SIAM J. Sci. Comput..

[3]  M. Ancona,et al.  Macroscopic physics of the silicon inversion layer. , 1987, Physical review. B, Condensed matter.

[4]  Jinn-Liang Liu,et al.  On Weak Residual Error Estimation , 1996, SIAM J. Sci. Comput..

[5]  Ren-Chuen Chen,et al.  Monotone iterative methods for the adaptive finite element solution of semiconductor equations , 2003 .

[6]  Andreas Unterreiter,et al.  The Stationary Current { VoltageCharacteristics of the Quantum DriftDi usion ModelRen , 1999 .

[7]  Zhiping Yu,et al.  Multi-dimensional Quantum Effect Simulation Using a Density-Gradient Model and Script-Level Programming Techniques , 1998 .

[8]  H. Lifka,et al.  Influence of high substrate doping levels on the threshold voltage and the mobility of deep-submicrometer MOSFETs , 1992 .

[9]  Y. Apanovich,et al.  Steady-state and transient analysis of submicron devices using energy balance and simplified hydrodynamic models , 1994, IEEE Trans. Comput. Aided Des. Integr. Circuits Syst..

[10]  M. R. Pinto,et al.  Electron and hole quantization and their impact on deep submicron silicon p- and n-MOSFET characteristics , 1997 .

[11]  H. L. Grubin,et al.  Electron Transport Using the Quantum Corrected Hydrodynamic Equations , 1995 .

[12]  Ren-Chuen Chen,et al.  Object-oriented programming of adaptive finite element and finite volume methods , 1996 .

[13]  Carl L. Gardner,et al.  The Quantum Hydrodynamic Model for Semiconductor Devices , 1994, SIAM J. Appl. Math..

[14]  H. Abebe,et al.  Quantum Mechanical Effects Correction Models for Inversion Charge and Current-Voltage (I-V) Characteristics of the MOSFET Device , 2003 .

[15]  T. Elsaesser,et al.  Intraband transitions of hot electrons studied by picosecond infrared pulses — a novel probe of hot phonons in polar semiconductors , 1989 .

[16]  Zhiping Yu,et al.  Circuit/device modeling at the quantum level , 1998 .

[17]  Ren-Chuen Chen,et al.  An iterative method for adaptive finite element solutions of an energy transport model of semiconductor devices , 2003 .

[18]  D. Bohm,et al.  The Aharonov-Bohm effect and the quantum potential , 1982 .

[19]  Kincho H. Law,et al.  A finite element formulation for the hydrodynamic semiconductor device equations , 1993 .

[20]  J. C. Ebergen.  VLSI design , 1992, IEEE Des. Test Comput..

[21]  The Use of Quantum Potentials for Confinement in Semiconductor Devices , 2002 .

[22]  Zhou,et al.  Form of the quantum potential for use in hydrodynamic equations for semiconductor device modeling. , 1993, Physical review. B, Condensed matter.

[23]  M. Orlowski,et al.  Carrier transport near the Si/SiO2 interface of a MOSFET , 1989 .

[24]  Robert W. Dutton,et al.  Density-gradient analysis of MOS tunneling , 2000 .

[25]  Zhiping Yu,et al.  Efficient Multi-Dimensional Simulation of Quantum Confinement Effects in Advanced MOS Devices , 2000 .

[26]  Wolfgang Fichtner,et al.  On density-gradient modeling of tunneling through insulators , 2002, International Conferencre on Simulation of Semiconductor Processes and Devices.

[27]  Massimo Rudan,et al.  Numerical solution of the hydrodynamic model for a one-dimensional semiconductor device , 1987 .

[28]  Jerry G. Fossum,et al.  Simplified energy-balance model for pragmatic multi-dimensional device simulation , 1997 .

[29]  Gerhard Klimeck,et al.  Single and multiband modeling of quantum electron transport through layered semiconductor devices , 1997 .

[30]  L. Shifren,et al.  Correspondence between quantum and classical motion: comparing Bohmian mechanics with a smoothed effective potential approach , 2000 .

[31]  Plummer,et al.  Comparison of self-consistency iteration options for the Wigner function method of quantum device simulation. , 1996, Physical review. B, Condensed matter.

[32]  Robert W. Dutton,et al.  Modeling of MOS scaling with emphasis on gate tunneling and source/drain resistance , 2000 .

[33]  H. L. Grubin,et al.  Quantum moment balance equations and resonant tunnelling structures , 1989 .

[34]  Tien-Sheng Chao,et al.  A new parallel adaptive finite volume method for the numerical simulation of semiconductor devices , 2001 .

[35]  G. G. Stokes.  "J." , 1890, The New Yale Book of Quotations.

[36]  Donald J. Rose,et al.  Numerical methods for the hydrodynamic device model: subsonic flow , 1989, IEEE Trans. Comput. Aided Des. Integr. Circuits Syst..