Review of Condition Monitoring of Rolling Element Bearing Using Vibration Analysis and Other Techniques

[1]  C. A. Papadopoulos,et al.  Hysteretic Damping and Stress Evaluation of Rotor-Bearing Systems in the Resonance Zone , 2014 .

[2]  Buyung Kosasih,et al.  An application of nonlinear feature extraction - A case study for low speed slewing bearing condition monitoring and prognosis , 2013, 2013 IEEE/ASME International Conference on Advanced Intelligent Mechatronics.

[3]  Janko Slavič,et al.  Typical bearing-fault rating using force measurements: application to real data , 2011 .

[4]  Wu Yunxin,et al.  Fault Diagnosis of Rolling Element Bearing Based on Vibration Frequency Analysis , 2011, 2011 Third International Conference on Measuring Technology and Mechatronics Automation.

[5]  Nizami Aktürk,et al.  Experimental diagnostics of ball bearings using statistical and spectral methods , 2009 .

[6]  Robert B. Randall,et al.  The spectral kurtosis: application to the vibratory surveillance and diagnostics of rotating machines , 2006 .

[7]  K. Loparo,et al.  HMM-Based Fault Detection and Diagnosis Scheme for Rolling Element Bearings , 2005 .

[8]  Fabrice Bolaers,et al.  Advanced detection of rolling bearing spalling from de-noising vibratory signals , 2004 .

[9]  A. Mohanty,et al.  APPLICATION OF DISCRETE WAVELET TRANSFORM FOR DETECTION OF BALL BEARING RACE FAULTS , 2002 .

[10]  Shih-Fu Ling,et al.  Bearing failure detection using matching pursuit , 2002 .

[11]  Thomas R. Kurfess,et al.  Vibration analysis for Bearing outer race condition diagnostics , 1999 .

[12]  N. Tandon,et al.  A review of vibration and acoustic measurement methods for the detection of defects in rolling element bearings , 1999 .

[13]  Chris K. Mechefske,et al.  OBJECTIVE MACHINERY FAULT DIAGNOSIS USING FUZZY LOGIC , 1998 .

[14]  Bo Li,et al.  Detection of common motor bearing faults using frequency-domain vibration signals and a neural network based approach , 1998, Proceedings of the 1998 American Control Conference. ACC (IEEE Cat. No.98CH36207).

[15]  C. Sujatha,et al.  Using neural networks for the diagnosis of localized defects in ball bearings , 1997 .

[16]  Ibrahim Esat,et al.  ARTIFICIAL NEURAL NETWORK BASED FAULT DIAGNOSTICS OF ROTATING MACHINERY USING WAVELET TRANSFORMS AS A PREPROCESSOR , 1997 .

[17]  Steven Y. Liang,et al.  BEARING CONDITION DIAGNOSTICS VIA VIBRATION AND ACOUSTIC EMISSION MEASUREMENTS , 1997 .

[18]  T. I. Liu,et al.  Intelligent monitoring of ball bearing conditions , 1992 .

[19]  B. C. Nakra,et al.  Comparison of vibration and acoustic measurement techniques for the condition monitoring of rolling element bearings , 1992 .

[20]  B. C. Nakra,et al.  TECHNICAL ARTICLE practical articles in shock and vibration technology: Vibration and Acoustic Monitoring Techniques for the Detection of Defects in Rolling Element Bearings -- a Review , 1992 .

[21]  J. Mathew,et al.  Time domain methods for monitoring the condition of rolling element bearings , 1985 .

[22]  J. Mathew,et al.  The condition monitoring of rolling element bearings using vibration analysis , 1984 .

[23]  P. D. McFadden,et al.  Vibration monitoring of rolling element bearings by the high-frequency resonance technique — a review , 1984 .

[24]  Roger F. Dwyer,et al.  Detection of non-Gaussian signals by frequency domain Kurtosis estimation , 1983, ICASSP.

[25]  J. D. Smith,et al.  Vibration monitoring of bearings at low speeds , 1982 .

[26]  D. W. Thomas,et al.  Bearing Fault Detection Using Adaptive Noise Cancelling , 1982 .

[27]  D. W. Thomas,et al.  Effect of Inter-Modulation and Quasi-Periodic Instability in the Diagnosis of Rolling Element Incipient Defect , 1982 .

[28]  J. I. Taylor,et al.  Identification of Bearing Defects by Spectral Analysis , 1980 .

[29]  L. D. Meyer,et al.  An Analytic Model for Ball Bearing Vibrations to Predict Vibration Response to Distributed Defects , 1980 .

[30]  C. S. Sunnersjö.  Varying compliance vibrations of rolling bearings , 1978 .

[31]  R. M. Stewart,et al.  Detection of Rolling Element Bearing Damage by Statistical Vibration Analysis , 1978 .

[32]  J. Meacher,et al.  Design and fabrication of prototype system for early warning of impending bearing failure , 1974 .

[33]  D. E. Butler,et al.  The Shock-pulse method for the detection of damaged rolling bearings , 1973 .

[34]  Deepak Paliwal,et al.  Wavelet and Scalar Indicator based Fault Assessment Approach for Rolling Element Bearings , 2014 .

[35]  A. Yigit,et al.  Analysis of Rolling Element Bearing Faults Via Curve Length Transform , 2014 .

[36]  N. Tandon,et al.  A comparison of some condition monitoring techniques for the detection of defect in induction motor ball bearings , 2007 .

[37]  N. Tandon,et al.  A Theoretical Model to Predict Vibration Response of Rolling Bearings to Distributed Defects Under Radial Load , 1998 .

[38]  Mohd Jailani Mohd Nor,et al.  Statistical analysis of sound and vibration signals for monitoring rolling element bearing condition , 1998 .

[39]  N. Tandon,et al.  A comparison of some vibration parameters for the condition monitoring of rolling element bearings , 1994 .

[40]  B. C. Nakra,et al.  Detection of defects in rolling element bearings by vibration monitoring , 1993 .

[41]  Ming Sang. Lai,et al.  Detection of developing bearing failures by means of vibration analysis. , 1990 .

[42]  J. Mathew,et al.  Frequency domain methods for monitoring the condition of rolling element bearings , 1985 .

[43]  Har Prashad,et al.  Diagnostic monitoring of rolling-element bearings by high-frequency resonance technique© , 1985 .

[44]  B. Datner,et al.  Analysis of Roller/Ball Bearing Vibrations , 1979 .

[45]  T. E. Tallian,et al.  Progress in Rolling Bearing Vibration Research and Control , 1965 .