Numerical simulation of ventilation air flow in underground mine workings

In recent years, Computational Fluid Dynamics, CFD, has been commonly utilized in the mining industry to model the fluid flow behavior in underground mine workings. This paper uses CFD modeling to simulate the airflow behavior in underground crosscut regions, where brattice sails are used to direct the airflow into these regions. Brattice sails are cost effective ventilation control devices for temporary or permanent use in underground mining. They can be used to deflect air into the unventilated areas such as crosscut regions. Their design and installation is a fundamental issue for maintaining a sufficient supply of fresh air and achieving effective air circulation and contaminant removal. At the same time, they should have little impact on the mine ventilation system. This paper presents the results of a two-dimensional CFD model, which examines the effects of brattice length on fluid flow behavior in the crosscut regions. The results of this study will assist in understanding the ventilation air behavior and in determining the optimum size of brattice curtain (sails), which provide a highly effective contaminant removal from the unventilated mine areas. This, in turn, helps the mine ventilation designers to meet the mine safety requirements.

[1]  Gerrit V R Goodman,et al.  Use of a Directional Spray System Design to Control Respirable Dust and Face Gas Concentrations Around a Continuous Mining Machine , 2004, Journal of occupational and environmental hygiene.

[2]  Edward D. Thimons,et al.  Using Ultrasonic Anemometers to Evaluate Factors Affecting Face Ventilation Effectiveness , 1900 .

[3]  Wenhua Wan,et al.  A Convection-Based Model of Diesel Particulate Matter Occurrences in Mines , 1996 .

[4]  S. Patankar.  Numerical Heat Transfer and Fluid Flow , 2018, Lecture Notes in Mechanical Engineering.

[5]  Ian Lowndes,et al.  The ventilation of an underground crushing plant , 2004 .

[6]  Jerry C. Tien,et al.  Face Ventilation During Cross-Cut Development in a Room-And-Pillar Operation , 1988 .

[7]  Edward D. Thimons,et al.  Ventilating the Box Cut of a Two-Pass 40-ft Extended Cut , 1999 .

[8]  T. W. Beck,et al.  The effects of water spray placement for controlling respirable dust and face methane concentrations , 2007 .

[9]  David Hargreaves,et al.  The computational modeling of the ventilation flows within a rapid development drivage , 2007 .

[10]  D. J. Brunner,et al.  Examples of the application of computational fluid dynamics simulation to mine and tunnel ventilation , 1995 .

[11]  Jamey Jacob,et al.  New approaches to mine-face ventilation , 2003 .

[12]  Chia-Jung Hsu.  Numerical Heat Transfer and Fluid Flow , 1981 .

[13]  K. E. Torrance,et al.  Upstream-weighted differencing schemes and their application to elliptic problems involving fluid flow , 1974 .