Feedback-Controlled MEMS Force Sensor for Characterization of Microcantilevers

This paper outlines the design and characterization of a setup used to measure the stiffness of microcantilevers and other small mechanical devices. Due to the simplicity of fabrication, microcantilevers are used as the basis for a variety of mechanical sensor designs. In a range of applications, knowledge of the stiffness of microcantilevers is essential for the accurate calibration of the sensors in which they are used. Stiffness is most commonly identified through measurement of the microcantilever's resonance frequency, which is applied to an empirically derived model. This paper uses a microelectromechanical system (MEMS)-based force sensor to measure the forces produced by a microcantilever when deformed and a piezoelectric tube-based nanopositioner to displace the microcantilever. A method of calibrating the force sensor is presented that takes advantage of the lumped nature of the mechanical system and the nonlinearity of MEMS electrostatic drives.

[1]  Jagannathan Rajagopalan,et al.  MEMS sensors and microsystems for cell mechanobiology , 2011, Journal of micromechanics and microengineering : structures, devices, and systems.

[2]  Toshiyuki Tsuchiya,et al.  Mechanical calibration of MEMS springs with sub-micro-Newton force resolution , 2008 .

[3]  Yu Sun,et al.  Nanonewton force-controlled manipulation of biological cells using a monolithic MEMS microgripper with two-axis force feedback , 2008 .

[4]  J. Bechhoefer,et al.  Calibration of atomic‐force microscope tips , 1993 .

[5]  Richard S Gates,et al.  Precise atomic force microscope cantilever spring constant calibration using a reference cantilever array. , 2007, The Review of scientific instruments.

[6]  K. Neuman,et al.  Single-molecule force spectroscopy: optical tweezers, magnetic tweezers and atomic force microscopy , 2008, Nature Methods.

[7]  Jonathan S. Colton,et al.  Characterization of microcantilevers solely by frequency response acquisition , 2005 .

[8]  S. Koch,et al.  Micromachined piconewton force sensor for biophysics investigations , 2006 .

[9]  S. O. Reza Moheimani,et al.  A Feedback Controlled MEMS Nanopositioner for On-Chip High-Speed AFM , 2014, Journal of Microelectromechanical Systems.

[10]  S. Roundy,et al.  Marvelous MEMS , 2006, IEEE Circuits and Devices Magazine.

[11]  B. Nelson,et al.  A Six-Axis MEMS Force–Torque Sensor With Micro-Newton and Nano-Newtonmeter Resolution , 2009, Journal of Microelectromechanical Systems.

[12]  B. Nelson,et al.  Monolithically Fabricated Microgripper With Integrated Force Sensor for Manipulating Microobjects and Biological Cells Aligned in an Ultrasonic Field , 2007, Journal of Microelectromechanical Systems.

[13]  H. Butt,et al.  Force measurements with the atomic force microscope: Technique, interpretation and applications , 2005 .

[14]  Farrokh Ayazi,et al.  Micromachined inertial sensors , 1998, Proc. IEEE.

[15]  周治平,et al.  High resolution interface circuit for closed-loop accelerometer , 2011 .

[16]  M. Sepaniak,et al.  Cantilever transducers as a platform for chemical and biological sensors , 2004 .

[17]  Volker Kempe,et al.  Inertial MEMS: Principles and Practice , 2011 .

[18]  A. Passian,et al.  Microcantilever Biosensors , 2007, 2007 IEEE Sensors.

[19]  M T A Saif,et al.  Linear High-Resolution BioMEMS Force Sensors With Large Measurement Range , 2010, Journal of Microelectromechanical Systems.

[20]  Nicholas G. Dagalakis,et al.  AFM characterization of nanopositioner in-plane stiffnesses , 2010 .

[21]  Jaydev P Desai,et al.  MEMS based Low Cost Piezoresistive Microcantilever Force Sensor and Sensor Module. , 2014, Materials science in semiconductor processing.

[22]  J. Sader,et al.  Method for the calibration of atomic force microscope cantilevers , 1995 .

[23]  Gang Zhang,et al.  A post-CMOS micromachined lateral accelerometer , 2002 .

[24]  J. Rao,et al.  Nanomechanical analysis of cells from cancer patients. , 2007, Nature nanotechnology.

[25]  S. O. R. Moheimani,et al.  Design and Analysis of Nonuniformly Shaped Heaters for Improved MEMS-Based Electrothermal Displacement Sensing , 2013, Journal of Microelectromechanical Systems.

[26]  Stephen F. Bart,et al.  An Integrated Force-balanced Capacitive Accelerometer For Low-G Applications , 1995, Proceedings of the International Solid-State Sensors and Actuators Conference - TRANSDUCERS '95.

[27]  Chang Liu,et al.  Foundations of MEMS , 2006 .

[28]  U.C. Wejinya,et al.  Closed-loop optimal control-enabled piezoelectric microforce sensors , 2006, IEEE/ASME Transactions on Mechatronics.

[29]  Clarence W. de Silva,et al.  Recent advances in MEMS sensor technology – biomedical applications , 2012, IEEE Instrumentation & Measurement Magazine.

[30]  Richard S Gates,et al.  Accurate spring constant calibration for very stiff atomic force microscopy cantilevers. , 2013, The Review of scientific instruments.

[31]  C. Lim,et al.  AFM indentation study of breast cancer cells. , 2008, Biochemical and biophysical research communications.

[32]  Dannis Michel Brouwer,et al.  Single-mask thermal displacement sensor in MEMS , 2010 .

[33]  S O Reza Moheimani,et al.  Invited review article: accurate and fast nanopositioning with piezoelectric tube scanners: emerging trends and future challenges. , 2008, The Review of scientific instruments.

[34]  S. O. Reza Moheimani,et al.  Zero displacement microelectromechanical force sensor using feedback control , 2014 .