RF characterization and modeling of various wire bond transitions

This paper presents radio-frequency (RF) characterization and modeling of various wire bond transitions between chips and packages. Test modules composed of Si chips and alumina packages are fabricated in conductor-backed (CB) structures, and they are characterized at frequencies up to 20 GHz. It is shown that the parallel plate resonance of the CB coplanar waveguide (CPW) persists in wire bonding transitions, and narrower-ground CPW-CPW transitions show better characteristics than wider-ground CPW-CPW transitions. The results of three-dimensional full-wave electromagnetic simulation on the test modules reproduce the measured results with a reasonable accuracy. Simple equivalent circuit modeling can reproduce the measured results of the narrower ground CPW transition with no resonance structures. Finally, the effects of bond wire length and impedance mismatch on RF performance are investigated.

[1]  G. Ponchak,et al.  Characterization of Asymmetric Coplanar , 1993 .

[2]  Sung-Jin Kim,et al.  Suppression of leakage resonance in coplanar MMIC packages using a Si sub-mount layer , 2000 .

[3]  Xiaoning Qi,et al.  A fast 3D modeling approach to electrical parameters extraction of bonding wires for RF circuits , 2000 .

[4]  Roberto Sorrentino,et al.  Modeling and characterization of the bonding-wire interconnection , 2001 .

[5]  Tatsuo Itoh,et al.  Leakage phenomena in multilayered conductor-backed coplanar waveguides , 1993 .

[6]  G. Leonhardt,et al.  Electromagnetic simulation of bonding wires and comparison with wide band measurements , 2000 .

[7]  G. Ponchak,et al.  Excitation of coupled slotline mode in finite-ground CPW with unequal ground-plane widths , 2005, IEEE Transactions on Microwave Theory and Techniques.

[8]  Tatsuo Itoh,et al.  Non-leaky coplanar (NLC) waveguides with conductor backing , 1995 .

[9]  Manos M. Tentzeris,et al.  Experimental modeling, repeatability investigation and optimization of microwave bond wire interconnects , 2001 .

[10]  Gabriel M. Rebeiz,et al.  Mode conversion at GCPW-to-microstrip-line transitions , 2000 .

[11]  J. Papapolymerou,et al.  Wideband coplanar waveguide RF probe pad to microstrip transitions without via holes , 2003, IEEE Microwave and Wireless Components Letters.

[12]  W. H. Haydl.  Resonance phenomena and power loss in conductor-backed coplanar structures , 2000 .

[13]  Nirod K. Das,et al.  Methods of suppression or avoidance of parallel-plate power leakage from conductor-backed transmission lines , 1996 .

[14]  Ching-Kuang C. Tzuang,et al.  Transmission characteristics of finite-width conductor-backed coplanar waveguide , 1993 .

[15]  George E. Ponchak,et al.  Finite ground coplanar waveguide (FGC) low loss, low coupling 90-degree crossover junctions , 2002 .

[16]  J. J. Hughes,et al.  A Simple Technique for the Accurate Determination of the Microwave Dielectric Constant for Microwave Integrated Circuit Substrates (Correspondence) , 1971 .

[17]  T. Tischler,et al.  Modeling dispersion and radiation characteristics of conductor-backed CPW with finite ground width , 2000, IMS 2000.

[18]  P. Garrou,et al.  Wafer level chip scale packaging (WL-CSP): an overview , 2000, ECTC 2000.

[19]  R. W. Jackson,et al.  Mode conversion at discontinuities in finite-width conductor-backed coplanar waveguide , 1989 .