C-Co-W Ternary Phase Diagram Evaluation

[1]  K. Frisk,et al.  Effect of Cr and V on phase equilibria in Co–WC based hardmetals , 2008 .

[2]  M. Nygren,et al.  Homogeneous WC–Co-Cemented Carbides from a Cobalt-Coated WC Powder Produced by a Novel Solution-Chemical Route , 2007 .

[3]  I. Shon,et al.  Fabrication of WC–8 wt.%Co hard materials by two rapid sintering processes , 2007 .

[4]  J. Vleugels,et al.  Computer simulating the diffusion behavior of V and W in Co binder layer of WC–Co cemented carbide , 2007 .

[5]  A. Griffo,et al.  Kinetics of cobalt gradient formation during the liquid phase sintering of functionally graded WC-Co , 2007 .

[6]  R. Sundaresan,et al.  Microstructure and mechanical properties of nanocrystalline WC–12Co consolidated by spark plasma sintering , 2007 .

[7]  P. Krakhmalev.  Effect of microstructure on edge wear mechanisms in WC-Co, WOM 2007 , 2007 .

[8]  F. Delannay,et al.  Equilibrium Distribution of Liquid during Sintering of Assemblies of WC/Co Cermets , 2007 .

[9]  G. Hilmas,et al.  Strength of functionally designed cellular cemented carbides produced by coextrusion , 2006 .

[10]  G. Shao,et al.  The effect of tungsten buffer layer on the stability of diamond with tungsten carbide–cobalt nanocomposite powder during spark plasma sintering , 2006 .

[11]  W. Schubert,et al.  WC grain growth during the early stages of sintering , 2006 .

[12]  W. Schubert,et al.  Hardmetals with “rounded” WC grains , 2006 .

[13]  J. Fuh,et al.  Effects of lower cobalt binder concentrations in sintering of tungsten carbide , 2006 .

[14]  Shinhoo Kang,et al.  Sintering of nano-sized WC–Co powders produced by a gas reduction–carburization process , 2006 .

[15]  M. Rosinski,et al.  Nanocrystalline Cemented Carbides Sintered by the Pulse Plasma Method , 2006 .

[16]  H. Andren,et al.  Microstructural changes during wear by plastic deformation of cemented carbide and cermet cutting inserts , 2006 .

[17]  Xuanhui Qu,et al.  Spark plasma sintering on nanometer scale WC–Co powder , 2005 .

[18]  Suk‐Joong L. Kang,et al.  Enhanced Densification of Liquid‐Phase‐Sintered WC–Co by Use of Coarse WC Powder: Experimental Support for the Pore‐Filling Theory , 2005 .

[19]  M. Anglada,et al.  Loading mode effects on the fracture toughness and fatigue crack growth resistance of WC¿Co cemented carbides , 2005 .

[20]  Zuhair A. Munir,et al.  Rapid sintering of ultra-fine WC-10 wt% Co by high-frequency induction heating , 2005 .

[21]  Hua Li,et al.  Microstructure modifications and phase transformation in plasma-sprayed WC–Co coatings following post-spray spark plasma sintering , 2005 .

[22]  J. Ågren,et al.  Rearrangement and pore size evolution during WC-Co sintering below the eutectic temperature , 2005 .

[23]  K. Frisk,et al.  A revised thermodynamic description of the Co-W-C system , 2005 .

[24]  G. Shao,et al.  Mechanical properties, phases and microstructure of ultrafine hardmetals prepared by WC–6.29Co nanocrystalline composite powder , 2005 .

[25]  Suk‐Joong L. Kang,et al.  Formation of Grain Boundaries in Liquid‐Phase‐Sintered WC–Co Alloys , 2005 .

[26]  R. Roy,et al.  Comparison between microwave and conventional sintering of WC/Co composites , 2005 .

[27]  Jianfei Sun,et al.  The effect of phosphorus additions on densification, grain growth and properties of nanocrystalline WC-Co composites , 2004 .

[28]  F. Delannay,et al.  Cold compaction and solid-state sintering of WC-Co-based structures: Experiments and modeling , 2004 .

[29]  T. Velikanova,et al.  Ordering in the carbide W2C and phase equilibria in the tungsten — carbon system in the region of its existence , 2004 .

[30]  A. Petersson.  Sintering shrinkage of WC-Co and WC-(Ti,W)C-Co materials with different carbon contents , 2004 .

[31]  S. Azem,et al.  Effect of carbon content on the reactive sintering of mixed W-Co-C powders , 2004 .

[32]  J. Ågren,et al.  Constitutive behaviour of WC–Co materials with different grain size sintered under load , 2004 .

[33]  I. Shon,et al.  Synthesis of WC and dense WC–5 vol.% Co hard materials by high-frequency induction heated combustion , 2004 .

[34]  E. Lavernia,et al.  Growth Inhibition of Nano WC particles in WC-Co Alloys during Liquid-Phase Sintering , 2003 .

[35]  G. Ha,et al.  Synthesis of ultrafine WC/Co powder by mechanochemical process , 2002 .

[36]  K. Frisk,et al.  Experimental study of invariant equilibria in the Co-W-C and Co-W-C-Me (Me = Ti, Ta, Nb) systems , 2001 .

[37]  A. Griffo,et al.  A dual composite of WC-Co , 1999 .

[38]  A. Pawłowski,et al.  Influence of Carbon on Discontinuous Preeipitation in Co-32 Mass’ W Alloy , 1995 .

[39]  E. Olevsky,et al.  The analysis of the electric heating of the WC-Co hard-alloy under consideration of the dependence of it's characteristics on the temperature , 1993 .

[40]  Y. Kuroshima,et al.  Failure of tungsten carbide-cobalt alloy tools in machining of carbon materials , 1993 .

[41]  A. F. Guillermet.  Composition Dependence of the Curie Temperature of Co-W-C Alloys Predicted from Thermodynamic Data/ Vorhersage der Konzentrationsabhängigkeit der Curie-Temperatur aufgrund thermodynamischer Daten , 1989 .

[42]  M. Hellsing.  High resolution microanalysis of binder phase in as sintered WC–Co cemented carbides , 1988 .

[43]  Armando Fernändez Guillermet.  Thermodynamic Analysis of the Co-C System , 1987 .

[44]  E. A. Almond,et al.  The influence of composition, phase transformation and varying the relative F.C.C. and H.C.P. phase contents on the properties of dilute CoWC alloys , 1984 .

[45]  P. Rogl,et al.  Structural chemistry of complex carbides and related compounds , 1982 .

[46]  E. Lugscheider,et al.  n-Carbide in den Systemen Co-W-C und Fe-W-C , 1982 .

[47]  L. Akesson.  Thermodynamic and sintering studies in the CoWC system , 1979 .

[48]  B. Uhrenius,et al.  Phase equilibria, isothermal reactions, and a thermodynamic study in the Co-W-C system at 1150°C , 1978 .

[49]  B. O. Haglund,et al.  Determination of the linear expansion coefficient of CoWC η-carbides using a high temperature X-ray diffraction technique , 1977 .

[50]  I. Joffe,et al.  Magnetic properties of CoW alloys in relation to sintered WCCO compacts , 1973 .

[51]  H. Jonsson.  STUDIES OF THE BINDER PHASE IN WC-Co CEMENTED CARBIDES HEAT-TREATED AT 650°C* , 1972 .

[52]  H. Doi,et al.  Plastic Deformation and Fracture in Tension of WC-Co Alloys , 1971 .

[53]  H. Exner,et al.  A REVIEW OF PARAMETERS INFLUENCING SOME MECHANICAL PROPERTIES OF TUNGSTEN CARBIDE–COBALT ALLOYS , 1970 .

[54]  J. D. Wood,et al.  Elevated temperature compressive creep behavior of tungsten carbide-cobalt alloys , 1968 .

[55]  N. Schönberg.  The structure of the Co3W2C4 phase , 1954 .

[56]  K. Schröter,et al.  Zur Kenntnis der Vorgänge bei der Sinterung von Hartmetallegierungen , 1950 .

[57]  C. Jia,et al.  Hot pressing of nanometer WC–Co powder , 2007 .

[58]  I. Shon,et al.  Consolidation of ultra fine WC and WC–Co hard materials by pulsed current activated sintering and its mechanical properties , 2007 .

[59]  S. Luyckx,et al.  The dependence of the contiguity of WC on Co content and its independence from WC grain size in WC–Co alloys , 2006 .

[60]  G. Rohrer,et al.  Modeling the relationship between microstructural features and the strength of WC–Co composites , 2006 .

[61]  D. Mari,et al.  Effect of TaC on plastic deformation of WC-Co and Ti(C,N)-WC-Co , 2006 .

[62]  Bryan Roebuck,et al.  Extrapolating hardness-structure property maps in WC/Co hardmetals , 2006 .

[63]  D. Mari,et al.  Mechanisms of plastic deformation of WC–Co and Ti(C, N)–WC–Co , 2006 .

[64]  K. Ravichandran.  Fracture toughness of two phase WC-Co cermets , 1994 .

[65]  M. Kumazawa.  Mechanism of Crystal Growth and Coalescence of Tungsten Carbide in the Presence of Cobalt Liquid Phase , 1990 .

[66]  T. Nishizawa,et al.  Effect of Magnetic Transition on the Solubility of Alloying Elements in BCC Iron and FCC Cobalt , 1981 .

[67]  A. Hårsta,et al.  A neutron powder diffraction study of the kappa phase in the Fe-W-C system , 1977 .

[68]  Hisashi Suzuki.  VARIATIONS IN SOME PROPERTIES OF SINTERED TUNGSTEN CARBIDE-COBALT ALLOYS WITH PARTICLE SIZE AND BINDER COMPOSITION , 1966 .