3D simulation of hydrogen production by ammonia decomposition in a catalytic membrane reactor

Abstract Ammonia decomposition in an integrated Catalytic Membrane Reactor for hydrogen production was studied by numerical simulation. The process is based on anhydrous NH 3 thermal dissociation inside a small size reactor (30 cm 3 ), filled by a Ni/Al 2 O 3 catalyst. The reaction is promoted by the presence of seven Pd coated tubular membranes about 203 mm long, with an outer diameter of 1.98 mm, which shift the NH 3 decomposition towards the products by removing hydrogen from the reaction area. The system fluid-dynamics was implemented into a 2D and 3D geometrical model. Ammonia cracking reaction over the Ni/Al 2 O 3 catalyst was simulated using the Temkin–Pyzhev equation. Introductory 2D simulations were first carried out for a hypothetic system without membranes. Because of reactor axial symmetry, different operative pressures, temperatures and input flows were evaluated. These introductory results showed an excellent ammonia conversion at 550 °C and 0.2 MPa for an input flow of 1.1 mg/s, with a residual NH 3 of only a few ppm. 3D simulations were then carried out for the system with membranes. Hydrogen adsorption throughout the membranes has been modeled using the Sievert’s law for the dissociative hydrogen flux. Several runs have been carried out at 1 MPa changing the temperature between 500 °C and 600 °C to point out the conditions for which the permeated hydrogen flux is the highest. With temperatures higher than 550 °C we obtained an almost complete ammonia conversion already before the membrane area. The working temperature of 550 °C resulted to be the most suitable for the reactor geometry. A good matching between membrane permeation and ammonia decomposition was obtained for an NH 3 input flow rate of 2.8 mg/s. Ammonia reaction shift due to the presence of H 2 permeable membranes in the reactor significantly fostered the dissociation: for the 550 °C case we obtained a conversion rate improvement of almost 18%.

[1]  Kristopher Gardner,et al.  An analysis of hydrogen production from ammonia hydride hydrogen generators for use in military fuel cell environments , 2004 .

[2]  J. Nørskov,et al.  Ammonia synthesis and decomposition on a Ru-based catalyst modeled by first-principles , 2009 .

[3]  Andreas Züttel,et al.  Hydrogen storage methods , 2004, Naturwissenschaften.

[4]  Roland Dittmeyer,et al.  Membrane reactors for hydrogenation and dehydrogenation processes based on supported palladium , 2001 .

[5]  M.E.E. Abashar,et al.  Integrated catalytic membrane reactors for decomposition of ammonia , 2002 .

[6]  Jacob N. Chung,et al.  Numerical modeling of hydrogen production from ammonia decomposition for fuel cell applications , 2010 .

[7]  John P. Collins,et al.  A mathematical model of a catalytic membrane reactor for the decomposition of NH3 , 1993 .

[8]  J. Nørskov,et al.  Why the optimal ammonia synthesis catalyst is not the optimal ammonia decomposition catalyst , 2005 .

[9]  Ibrahim S. Al-Mutaz,et al.  Investigation of low temperature decomposition of ammonia using spatially patterned catalytic membrane reactors , 2002 .

[10]  Ruzhu Wang,et al.  A review on transportation of heat energy over long distance: Exploratory development , 2009 .

[11]  R. E. Hayes,et al.  Introduction to Catalytic Combustion , 1998 .

[12]  W. Arabczyk,et al.  Study of the ammonia decomposition over iron catalysts , 1999 .

[13]  Jianli Hu,et al.  An overview of hydrogen production technologies , 2009 .

[14]  Richard I. Masel,et al.  Development of a microreactor for the production of hydrogen from ammonia , 2004 .

[15]  R. Buxbaum,et al.  Power output and load following in a fuel cell fueled by membrane reactor hydrogen , 2003 .

[16]  D. Goodman,et al.  Catalytic ammonia decomposition: COx-free hydrogen production for fuel cell applications , 2001 .

[17]  R. Metkemeijer,et al.  Comparison of ammonia and methanol applied indirectly in a hydrogen fuel cell , 1994 .

[18]  William J. Thomson,et al.  Ammonia decomposition kinetics over Ni-Pt/Al2O3 for PEM fuel cell applications , 2002 .

[19]  R. Hughes,et al.  Elimination of Ammonia from Coal Gasification Streams by Using a Catalytic Membrane Reactor , 1995 .

[20]  O. Hansen,et al.  Promoted Ru on high-surface area graphite for efficient miniaturized production of hydrogen from ammonia , 2006 .

[21]  R. Buxbaum.  MEMBRANE REACTOR ADVANTAGES FOR METHANOL REFORMING AND SIMILAR REACTIONS , 1999 .

[22]  Z. Prete,et al.  Theoretical analysis of a pure hydrogen production separation plant for fuel cells dynamical applications , 2006 .