Analysis of a Latent Thermocline Energy Storage System for Concentrating Solar Power Plants

The primary purpose of a thermal energy storage system in a concentrating solar power (CSP) plant is to extend the operation of plant at times when energy from the sun is not adequate by dispatching its stored energy. Storing sun’s energy in the form of latent thermal energy of a phase change material (PCM) is desirable due to its high energy storage density which translates to less amount of salt required for a given storage capacity. The objective of this paper is to analyze the dynamic behavior of a packed bed encapsulated PCM energy storage subjected to partial charging and discharging cycles, and constraints on charge and discharge temperatures as encountered in a CSP plant operation. A transient, numerical analysis of a molten salt, single tank latent thermocline energy storage system (LTES) is performed for repeated charging and discharging cycles to investigate its dynamic response. The influence of the design configuration and operating parameters on the dynamic storage and delivery performance of the system is analyzed to identify configurations that lead to higher utilization. This study provides important guidelines for designing a storage tank with encapsulated PCM for a CSP plant operation.Copyright © 2012 by ASME

[1]  S. Ostrach.  Natural convection in enclosures , 1988 .

[2]  S. Garimella,et al.  Molten-salt thermal energy storage in thermoclines under different environmental boundary conditions , 2010 .

[3]  Jon T. Van Lew,et al.  Analysis of Heat Storage and Delivery of a Thermocline Tank Having Solid Filler Material , 2011 .

[4]  Suresh V. Garimella,et al.  Thermal analysis of solar thermal energy storage in a molten-salt thermocline , 2010 .

[5]  S. Ergun.  Fluid flow through packed columns , 1952 .

[6]  S. C. Solanki,et al.  An analysis of a packed bed latent heat thermal energy storage system using PCM capsules: Numerical investigation , 2009 .

[7]  R. Pitchumani,et al.  Analysis and optimization of a latent thermal energy storage system with embedded heat pipes , 2011 .

[8]  R. Pitchumani,et al.  Computational studies on a latent thermal energy storage system with integral heat pipes for concentrating solar power , 2013 .

[9]  R. Saini,et al.  A review on packed bed solar energy storage systems , 2010 .

[10]  T.E.W. Schumann,et al.  Heat transfer: A liquid flowing through a porous prism , 1929 .

[11]  M. Cross,et al.  An enthalpy method for convection/diffusion phase change , 1987 .

[12]  Guiyin Fang,et al.  Dynamic performances of solar heat storage system with packed bed using myristic acid as phase change material , 2011 .

[13]  Gregory J. Kolb,et al.  Performance Analysis of Thermocline Energy Storage Proposed for the 1 MW Saguaro Solar Trough Plant , 2006 .

[14]  Kamal Abdel Radi Ismail,et al.  Numerical and experimental study of spherical capsules packed bed latent heat storage system , 2002 .

[15]  Aldo Steinfeld,et al.  High-temperature thermal storage using a packed bed of rocks - Heat transfer analysis and experimental validation , 2011 .

[16]  D. E. Beasley,et al.  Transient response of a packed bed for thermal energy storage , 1983 .

[17]  J. Pacheco,et al.  DEVELOPMENT OF A MOLTEN-SALT THERMOCLINE THERMAL STORAGE SYSTEM FOR PARABOLIC TROUGH PLANTS , 2001 .

[18]  A. Shitzer,et al.  Transient Behavior of a Rock-Bed Thermal Storage System Subjected to Variable Inlet Air Temperatures: Analysis and Experimentation , 1983 .

[19]  R. Velraj,et al.  Experimental investigation on a combined sensible and latent heat storage system integrated with constant/varying (solar) heat sources , 2007 .

[20]  S. C. Solanki,et al.  Heat transfer characteristics of thermal energy storage system using PCM capsules: A review , 2008 .

[21]  Thomas C. Hales,et al.  Historical Overview of the Kepler Conjecture , 2006, Discret. Comput. Geom..

[22]  T. R. Galloway,et al.  A model of the mechanism of transport in packed, distended, and fluidized beds , 1970 .