论文信息 - A new convex-hull based approach to evaluating flatness tolerance

A new convex-hull based approach to evaluating flatness tolerance

Abstract In this paper, we consider a minimum-zone evaluation problem for flatness to determine the minimum tolerance zone enclosing all the measurement points obtained from a surface. For the problem, a new geometric approach called the ‘convex-hull edge method’ (CONHEM) is proposed. The method guarantees the minimum zone tolerance for a given set of measurement points. Several examples discussed by other researchers are illustrated to compare the method with some existing approaches.

Moon-Kyu Lee | Moon-Kyu Lee

[1] T.S.R. Murthy,et al. Minimum zone evaluation of surfaces , 1980 .

[2] Michael Ian Shamos,et al. Computational geometry: an introduction , 1985 .

[3] M. S. Shunmugam,et al. Criteria for Computer-Aided Form Evaluation , 1991 .

[4] M. S. Shunmugam,et al. New approach for evaluating form errors of engineering surfaces , 1987 .

[5] K. Fan,et al. A new minimum zone method for evaluating straightness errors , 1993 .

[6] M. W. Cho,et al. New inspection planning strategy for sculptured surfaces using coordinate measuring machine , 1995 .

[7] H J Pahk,et al. The Application of a Microcomputer to the on-line Calibration of the Flatness of Engineering Surfaces , 1989 .

[8] Soichiro Suzuki,et al. Evaluation of minimum zone flatness by means of nonlinear optimization techniques and its verification , 1993 .

[9] D G Chetwynd,et al. Applications of Linear Programming to Engineering Metrology , 1985 .

[10] Michael Yu Wang,et al. Minimum Zone Evaluation of Form Tolerances , 1992 .

[11] Tom M. Cavalier,et al. Evaluation of straightness and flatness tolerances using the minimum zone , 1989 .

[12] David P. Dobkin,et al. The quickhull algorithm for convex hulls , 1996, TOMS.