Slurry Characterization by Stress Relaxation Test for Tape Casting Process

[1]  J. Tsubaki,et al.  Measuring packing fraction distribution in cake filtered under constant pressure and quantitative estimation from measured filtrate volume , 2006 .

[2]  L. Garrido,et al.  Aqueous tape casting of yttria stabilized zirconia , 2006 .

[3]  J. Ferreira,et al.  Rheological characterisation of water-based AlN slurries for the tape casting process , 2005 .

[4]  J. Lewis,et al.  Soluble organic additive effects on stress development during drying of calcium carbonate suspensions. , 2005, Journal of colloid and interface science.

[5]  J. Gurauskis,et al.  Joining green ceramic tapes made from water-based slurries by applying low pressures at ambient temperature , 2005 .

[6]  Jianfeng Chen,et al.  Rheological properties of nanosized barium titanate prepared by HGRP for aqueous tape casting , 2005 .

[7]  T. Chartier,et al.  Drying mechanisms and stress development in aqueous alumina tape casting , 2005 .

[8]  P. Greil,et al.  Deflocculants for tape casting of TiO2 slurries , 2004 .

[9]  A. Sen,et al.  Influence of ambient temperature on the rheological properties of alumina tape casting slurry , 2004 .

[10]  C. Coddet,et al.  Influence of slurry characteristics on the morphology of spray-dried alumina powders , 2003 .

[11]  J. Lewis,et al.  Rheological, structural, and stress evolution of aqueous Al2O3 :Latex tape-cast layers , 2002 .

[12]  A. Barker,et al.  Controlled drying to enhance properties of technical ceramics , 2002 .

[13]  H. Mori,et al.  The effects of the concentration of a polymer dispersant on apparent viscosity and sedimentation behavior of dense slurries , 2001 .

[14]  P. Greil,et al.  Tape casting of aqueous Al2O3 slurries , 2000 .

[15]  A. Kristoffersson,et al.  Comparison of different binders for water-based tape casting of alumina , 1998 .

[16]  A. Kristoffersson,et al.  Study of Interactions Between Polyelectrolyte Dispersants, Alumina and Latex Binders by Rheological Characterisation , 1998 .

[17]  J. Lewis,et al.  Rheological Property and Stress Development during Drying of Tape‐Cast Ceramic Layers , 1996 .

[18]  M. Cima,et al.  Drying of Granular Ceramic Films: I, Effect of Processing Variables on Cracking Behavior , 1993 .

[19]  J. Tsubaki,et al.  Effects of Slurry Properties on the Crack Formation in Ceramic Green Sheets during Drying , 2006 .

[20]  Juan-Yu Yang,et al.  Aqueous tape casting processing of low dielectric constant cordierite-based glass-ceramics—selection of binder , 2006 .

[21]  P. Xiao,et al.  Agglomeration on drying of yttria-stabilised-zirconia slurry on a metal substrate , 2006 .

[22]  L. Garrido,et al.  Influence of the slip composition on the aqueous processing and properties of yttria stabilized zirconia green tapes , 2006 .

[23]  J. Tsubaki,et al.  Slurry characterization by hydrostatic pressure measurement — analysis based on apparent weight flux ratio , 2006 .

[24]  J. Alcock,et al.  Aqueous colloidal processing and green sheet properties of lead zirconate titanate (PZT) ceramics made by tape casting , 2004 .

[25]  F. Snijkers,et al.  Aqueous tape casting of yttria stabilised zirconia using natural product binder , 2004 .

[26]  R. Greenwood,et al.  Preparation of concentrated aqueous alumina suspensions for tape casting , 1997 .

[27]  M. Descamps,et al.  Tape-casting: Relationship between organic constituents and the physical and mechanical properties of tapes , 1995 .

[28]  George W. Scherer,et al.  Theory of Drying , 1990 .