论文信息 - Time modeling in high-speed machining of mold pocket - 字舞流文

Time modeling in high-speed machining of mold pocket

Moncef Hbaieb | Wassila Bouzid | Radhouane Othmani | M. Hbaieb | W. Bouzid | Radhouane Othmani

[1] Moncef Hbaieb,et al. Machining time in rough milling , 2008 .

[2] Ying Tang,et al. Optimization strategy in end milling process for high speed machining of hardened die/mold steel , 2006 .

[3] Chen-Yuan Chen,et al. Fuzzy Logic Derivation of Neural Network Models with Time Delays in Subsystems , 2005, Int. J. Artif. Intell. Tools.

[4] Dooyong Lee,et al. The optimal cutter orientation in ball end milling of cantilever-shaped thin plate , 2004 .

[5] Pascal Ray,et al. Corner optimization for pocket machining , 2004 .

[6] Ciro A. Rodríguez,et al. Influence of tool path strategy on the cycle time of high-speed milling , 2003, Comput. Aided Des..

[7] Myung-Chang Kang,et al. A study on the precision machinability of ball end milling by cutting speed optimization , 2002 .

[8] J. Lebrun,et al. An investigation of the influence of sulphide inclusions on tool-wear in high speed milling of tool steels , 2001 .

[9] Sri Hinduja,et al. Determination of optimum cutter diameter for machining 2-O pockets , 2001 .

[10] Z. Wang,et al. Guest Editorial Foreword to the Special Issue on Intelligent Computation for Bioinformatics , 2008, IEEE Trans. Syst. Man Cybern. Part C.