Quadriceps force in relation of intrinsic anteroposterior stability of TKA design

PurposeDecreased quadriceps strength and fatigue is suspected to be one of the contributing factors for anterior knee pain and malfunction after total knee arthroplasty (TKA). The purpose of this in vitro study was to investigate the amount of quadriceps force required to extend the knee isokinetically after TKA in dependence of different prosthesis designs and the state of the posterior cruciate ligament (PCL).Materials and methodsEight fresh frozen human knee specimens underwent testing in a kinematic device simulating an isokinetic knee extension cycle from 120° of flexion to full extension. The quadriceps force was measured after implantation of a cruciate retaining (CR) TKA (Genesis II, Smith&Nephew, Memphis, TN, USA) applying a conventional CR (11 mm) and a highly conforming (deep dished, DD) polyethylene (PE) inlay consecutively before and after resection of the PCL. Finally, tests were repeated with a posterior-stabilized (PS) design.ResultsSimulating a physiological knee extension, no significant differences in the average quadriceps force were detected between the cruciate preserving inlays (CR 1,146.57 ± 88.04 N, DD 1,150.19 ± 97.54 N, P = 0.86) as long as the PCL was intact. After resection of the PCL, the required quadriceps force increased significantly for both designs (CR 1,203.17 ± 91.51 N, P < 0.01 and DD 1,191.88 ± 80.07 N, P < 0.03). After implantation of the posterior stabilized femoral component quad force decreased to its initial levels with forces significantly lower compared to the PCL deficient knees provided with a CR or DD (PS 1,130.91 ± 107.88 N, P < 0.01) inlay. With a deficient PCL there were no statistical differences for the DD design in comparison with CR in mean quad forces (CR 1,203.17 ± 91.51 N vs. DD 1,191.88 ± 80.07 N, P = 0.50) nor in peak forces (CR 1,729.44 ± 161.86 N, DD 1,688.66 ± 123.18 N, P = 0.17).DiscussionAt intact PCL peak quad forces and mean forces beyond 70° of flexion could be shown to be significantly lower with a PS TKA design in comparison with cruciate preserving designs such as CR and DD. In the PCL deficient knee quad forces with a highly conforming implant (DD) and CR were significantly higher than with a PS TKA. The use of PS implants in all PCL deficient knees seems to be advisable.

[1]  Quadriceps force during knee extension after non-hinged and hinged TKA: An in vitro study , 2008, Acta orthopaedica.

[2]  C Hurschler,et al.  Quadriceps function after TKA--an in vitro study in a knee kinematic simulator. , 2004, Clinical biomechanics.

[3]  W. Hayes,et al.  Force ratios in the quadriceps tendon and ligamentum patellae , 1984, Journal of orthopaedic research : official publication of the Orthopaedic Research Society.

[4]  J. Rand.  The patellofemoral joint in total knee arthroplasty. , 1994, The Journal of bone and joint surgery. American volume.

[5]  David M Weinstein,et al.  Comparing two estimations of the quadriceps force distribution for use during patellofemoral simulation. , 2006, Journal of biomechanics.

[6]  H. Kaufer.  Mechanical function of the patella. , 1971, The Journal of bone and joint surgery. American volume.

[7]  Extensor mechanism complications following total knee arthroplasty. , 1987, The Journal of arthroplasty.

[8]  C. Hurschler,et al.  In vitro investigation of the influence of tibial slope on quadriceps extension force after total knee arthroplasty , 2006, Knee Surgery, Sports Traumatology, Arthroscopy.

[9]  Christof Hurschler,et al.  Tibiofemoral contact stress after total knee arthroplasty , 2002 .

[10]  Mohamed R Mahfouz,et al.  Multicenter Determination of In Vivo Kinematics After Total Knee Arthroplasty , 2003, Clinical orthopaedics and related research.

[11]  Mohamed R. Mahfouz,et al.  In Vivo Fluoroscopic Analysis Of Fixed-Bearing Total Knee Replacements , 2003, Clinical orthopaedics and related research.

[12]  R. Laskin,et al.  Deep-Dish Congruent Tibial Component Use in Total Knee Arthroplasty: A Randomized Prospective Study , 2000, Clinical orthopaedics and related research.

[13]  Ashutosh Kumar Singh,et al.  The Axes of Rotation of the Knee , 1993, Clinical orthopaedics and related research.

[14]  T. Thornhill,et al.  Posterior cruciate supplementing total knee replacement using conforming inserts and cruciate recession. Effect on range of motion and radiolucent lines. , 1994, Clinical orthopaedics and related research.

[15]  Mohamed R Mahfouz,et al.  In vivo determination of total knee arthroplasty kinematics: a multicenter analysis of an asymmetrical posterior cruciate retaining total knee arthroplasty. , 2008, The Journal of arthroplasty.

[16]  Scott A Banks,et al.  Implant Design Affects Knee Arthroplasty Kinematics during Stair-stepping , 2004, Clinical orthopaedics and related research.

[17]  A. T. Berman,et al.  Evaluation of total knee arthroplasty using isokinetic testing. , 1991, Clinical orthopaedics and related research.

[18]  T. Andriacchi,et al.  The influence of total knee-replacement design on walking and stair-climbing. , 1982, The Journal of bone and joint surgery. American volume.

[19]  R. Nisell,et al.  Mechanics of the knee. A study of joint and muscle load with clinical applications. , 1985, Acta orthopaedica Scandinavica. Supplementum.

[20]  C J Wirth,et al.  Relative motion of a mobile bearing inlay after total knee arthroplasty--dynamic in vitro study. , 2002, Clinical biomechanics.

[21]  D A Dennis,et al.  In Vivo Anteroposterior Femorotibial Translation of Total Knee Arthroplasty: A Multicenter Analysis , 1998, Clinical orthopaedics and related research.

[22]  A H Burstein,et al.  The posterior stabilized condylar prosthesis: a modification of the total condylar design. Two to four-year clinical experience. , 1982, The Journal of bone and joint surgery. American volume.

[23]  R Poss,et al.  Long-term complications after total knee arthroplasty with or without resurfacing of the patella. , 1993, The Journal of bone and joint surgery. American volume.