A Novel Passive Wireless Sensor for Concrete Humidity Monitoring

This paper presents a passive wireless humidity sensor for concrete monitoring. After discussing the transmission of electromagnetic wave in concrete, a novel architecture of wireless humidity sensor, based on Ultra-High Frequency (UHF) Radio Frequency Identification (RFID) technology, is proposed for low-power application. The humidity sensor utilizes the top metal layer to form the interdigitated electrodes, which were then filled with polyimide as the humidity sensing layer. The sensor interface converts the humidity capacitance into a digital signal in the frequency domain. A two-stage rectifier adopts a dynamic bias-voltage generator to boost the effective gate-source voltage of the switches in differential-drive architecture. The clock generator employs a novel structure to reduce the internal voltage swing. The measurement results show that our proposed wireless humidity can achieve a high linearity with a normalized sensitivity of 0.55% %RH at 20 °C. Despite the high losses of concrete, the proposed wireless humidity sensor achieves reliable communication performances in passive mode. The maximum operating distance is 0.52 m when the proposed wireless sensor is embedded into the concrete at the depth of 8 cm. The measured results are highly consistent with the results measured by traditional methods.

[1]  Soumyajit Mandal,et al.  Low-Power CMOS Rectifier Design for RFID Applications , 2007, IEEE Transactions on Circuits and Systems I: Regular Papers.

[2]  Ming Qin,et al.  A Fully Packaged CMOS Interdigital Capacitive Humidity Sensor With Polysilicon Heaters , 2011, IEEE Sensors Journal.

[3]  Suhwan Kim,et al.  A Delta–Sigma Interface Circuit for Capacitive Sensors With an Automatically Calibrated Zero Point , 2011, IEEE Transactions on Circuits and Systems II: Express Briefs.

[4]  Shahriar Mirabbasi,et al.  An efficiency enhancement technique for CMOS rectifiers with low start-up voltage for UHF RFID tags , 2013, 2013 International Green Computing Conference Proceedings.

[5]  A. Demosthenous,et al.  Humidity-to-Frequency Sensor in CMOS Technology With Wireless Readout , 2013, IEEE Sensors Journal.

[6]  Alison B. Flatau,et al.  Review Paper: Health Monitoring of Civil Infrastructure , 2003 .

[7]  S. V. Savov,et al.  Modal transmission-line modeling of propagation of plane radiowaves through multilayer periodic building structures , 2003 .

[8]  Vladimir P. Vavilov,et al.  Study on Detection Limit of Buried Defects in Concrete Structures by Using Infrared Thermography , 2004 .

[9]  Abdelnasser A. Eldek.  Miniaturized patch antenna for RFID tags on metallic surfaces , 2011 .

[10]  Erkka Laulainen,et al.  A Micropower �-Based Interface ASIC for a Capacitive 3-Axis Micro-Accelerometer , 2009 .

[11]  Ugo Reggiani,et al.  Modelling the electrical properties of concrete for shielding effectiveness prediction , 2007 .

[12]  Norbert J. Delatte,et al.  BOND STRENGTH DEVELOPMENT WITH MATURITY OF HIGH-EARLY-STRENGTH BONDED CONCRETE OVERLAYS , 2000 .

[13]  Mikko Saukoski,et al.  A Micropower Interface ASIC for a Capacitive 3-Axis Micro-Accelerometer , 2007, IEEE Journal of Solid-State Circuits.

[14]  Pedro Arias,et al.  Monitoring biological crusts in civil engineering structures using intensity data from terrestrial laser scanners , 2012 .

[15]  Sung-Min Hong,et al.  High sensitivity capacitive humidity sensor with a novel polyimide design fabricated by MEMS technology , 2009, 2009 4th IEEE International Conference on Nano/Micro Engineered and Molecular Systems.

[16]  Catherine Dehollain,et al.  A passive UHF RFID system with a low-power capacitive sensor interface , 2014, 2014 IEEE RFID Technology and Applications Conference (RFID-TA).

[17]  Guoqing Jiang,et al.  Effect of internal curing with super absorbent polymers on the relative humidity of early-age concrete , 2015 .

[18]  A. Ledeczi,et al.  Wireless Acoustic Emission Sensor Network for Structural Monitoring , 2009, IEEE Sensors Journal.

[19]  K. Leung,et al.  A sub-1-V 15-ppm/°C CMOS bandgap voltage reference without requiring low threshold voltage device , 2002, IEEE J. Solid State Circuits.

[20]  Shahriar Mirabbasi,et al.  A CMOS rectifier with an extended high-efficiency region of operation , 2013, 2013 IEEE International Conference on RFID-Technologies and Applications (RFID-TA).

[21]  Ginu Rajan,et al.  Hybrid Fiber Optic Sensor System for Measuring the Strain, Temperature, and Thermal Strain of Composite Materials , 2014, IEEE Sensors Journal.

[22]  D. Pena,et al.  Measurement and modeling of propagation losses in brick and concrete walls for the 900-MHz band , 2003 .

[23]  Carlo Atzeni,et al.  A microwave radar technique for dynamic testing of large structures , 2003 .

[24]  Ming Qin,et al.  A novel capacitive-type humidity sensor using CMOS fabrication technology , 2004 .

[25]  B. Lothenbach,et al.  Thermodynamic Modelling of the Effect of Temperature on the Hydration and Porosity of Portland Cement , 2008 .

[26]  David A Lange,et al.  Thermal dilation and internal relative humidity of hardened cement paste , 2005 .

[27]  Peng Feng,et al.  Passive and Semi-Passive Wireless Temperature and Humidity Sensors Based on EPC Generation-2 UHF Protocol , 2015, IEEE Sensors Journal.

[28]  Yigang He,et al.  Metric of the Application Environment Impact to the Passive UHF RFID System , 2014, IEEE Transactions on Instrumentation and Measurement.

[29]  Ching-Liang Dai,et al.  Fabrication of a micro humidity sensor with polypyrrole using the CMOS process , 2010, 2010 IEEE 5th International Conference on Nano/Micro Engineered and Molecular Systems.

[30]  M. Grassi,et al.  Integrated microsystem with humidity, temperature and light sensors for monitoring the preservation conditions of food , 2011, 2011 IEEE SENSORS Proceedings.

[31]  Majid Ahmadi,et al.  Low-power oscillator for passive radio frequency identification transponders , 2012, IET Circuits Devices Syst..

[32]  Emidio DiGiampaolo,et al.  Wireless Passive RFID Crack Width Sensor for Structural Health Monitoring , 2015, IEEE Sensors Journal.

[33]  K. Kotani,et al.  High-Efficiency Differential-Drive CMOS Rectifier for UHF RFIDs , 2009, IEEE Journal of Solid-State Circuits.

[34]  D. Inaudi,et al.  Submillimeter crack detection with brillouin-based fiber-optic sensors , 2009, IEEE Sensors Journal.

[35]  Peter M. Asbeck,et al.  Near zero turn-on voltage high-efficiency UHF RFID rectifier in silicon-on-sapphire CMOS , 2010, 2010 IEEE Radio Frequency Integrated Circuits Symposium.

[36]  Ronaldo A. de Medeiros-JuniorMaryangela.  Service life of concrete structures considering the effects of temperature and relative humidity on chloride transport , 2015 .

[37]  Libor Sitek,et al.  ANALYSIS OF INNER STRUCTURE CHANGES OF CONCRETES EXPOSED TO HIGH TEMPERATURES USING MICRO X-RAY COMPUTED TOMOGRAPHY , 2015 .

[38]  Qiang Chen,et al.  Low-Cost Printed Chipless RFID Humidity Sensor Tag for Intelligent Packaging , 2015, IEEE Sensors Journal.

[39]  John H. Sharp,et al.  Effect of temperature on the hydration of the main clinker phases in portland cements: part ii, blended cements , 1998 .

[40]  Ronaldo A. Medeiros-Junior,et al.  Service life of concrete structures considering the effects of temperature and relative humidity on chloride transport , 2015 .

[41]  Stavros V. Georgakopoulos,et al.  Optimum wireless power transmission through reinforced concrete structure , 2011, 2011 IEEE International Conference on RFID.

[42]  Peng Li,et al.  Energy efficient wireless sensor network for structural health monitoring using distributed embedded piezoelectric transducers , 2010, Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[43]  Walter D. Leon-Salas,et al.  A RFID Sensor for Corrosion Monitoring in Concrete , 2016, IEEE Sensors Journal.

[44]  Erkka Laulainen,et al.  A Micropower $\Delta\Sigma$-Based Interface ASIC for a Capacitive 3-Axis Micro-Accelerometer , 2009, IEEE Journal of Solid-State Circuits.