Series-connected shaded modules to address partial shading conditions in SPV systems

With the progress of technology and reduced cost of PV cells, the PV systems are being installed in many countries, including India. Even though this method of power generation has sufficient potential but its effective utilization is still lacking. This is because the output power of PV cells depends on many factors like insolation, temperature, climate conditions prevailing nearby, aging, using modules from different technologies/manufacturers or partial shading conditions. Among these factors, partial shading causes major reduction in output power despite the size of PV systems. As a result, the produced power is lower than the expected value. The connection of modules to each other has great impact on output power if they are prone to partial shading conditions. In this paper, PV arrays are investigated under partial shading conditions. The results show that partial shading losses can be minimized by connecting shaded modules in series rather than in parallel.

[1]  Ratna Dahiya,et al.  Output Power Comparison of TCT & SP Topologies for Easy-to-Predict Partial Shadow on a 4×4 PV Field , 2014 .

[2]  Massimo Vitelli,et al.  Distributed maximum power point tracking of photovoltaic arrays: Novel approach and system analysis , 2008, IEEE Transactions on Industrial Electronics.

[3]  Aissa Chouder,et al.  Analysis Model of Mismatch Power Losses in PV Systems , 2009 .

[4]  S. Valkealahti,et al.  Power Losses in Long String and Parallel-Connected Short Strings of Series-Connected Silicon-Based Photovoltaic Modules Due to Partial Shading Conditions , 2012, IEEE Transactions on Energy Conversion.

[5]  Kenji Kobayashi,et al.  A study on a two stage maximum power point tracking control of a photovoltaic system under partially shaded insolation conditions , 2003, IEEE Power Engineering Society General Meeting.

[6]  P. R. Wilson,et al.  Improved Optimization Strategy for Irradiance Equalization in Dynamic Photovoltaic Arrays , 2013, IEEE Transactions on Power Electronics.

[7]  B. Lehman,et al.  A reconfigurable solar photovoltaic array under shadow conditions , 2008, 2008 Twenty-Third Annual IEEE Applied Power Electronics Conference and Exposition.

[8]  Roger A. Dougal,et al.  Parallel-Connected Solar PV System to Address Partial and Rapidly Fluctuating Shadow Conditions , 2009, IEEE Transactions on Industrial Electronics.

[9]  M. Drif,et al.  Modeling and simulation of photovoltaic array with different interconnection configurations under partial shading conditions for fill factor evaluation , 2014, 2014 International Renewable and Sustainable Energy Conference (IRSEC).

[10]  Nuri Gokmen,et al.  Analysis of spatial fixed PV arrays configurations to maximize energy harvesting in BIPV applications , 2015 .

[11]  M. Drif,et al.  A new estimation method of irradiance on a partially shaded PV generator in grid-connected photovoltaic systems , 2008 .

[12]  K. Naito,et al.  Simulation of I–V characteristics of a PV module with shaded PV cells , 2003 .

[13]  J. C. Jimeno,et al.  Experimental results of controlled PV module for building integrated PV systems , 2008 .

[14]  Kenji Kobayashi,et al.  A study on a two stage maximum power point tracking control of a photovoltaic system under partially shaded insolation conditions , 2003, 2003 IEEE Power Engineering Society General Meeting (IEEE Cat. No.03CH37491).

[15]  Ronnie Belmans,et al.  Partial shadowing of photovoltaic arrays with different system configurations: literature review and field test results , 2003 .

[16]  A. Bidram,et al.  Control and Circuit Techniques to Mitigate Partial Shading Effects in Photovoltaic Arrays , 2012, IEEE Journal of Photovoltaics.

[17]  Brad Lehman,et al.  An Adaptive Solar Photovoltaic Array Using Model-Based Reconfiguration Algorithm , 2008, IEEE Transactions on Industrial Electronics.

[18]  Seddik Bacha,et al.  Forecasting photovoltaic array power production subject to mismatch losses , 2010 .

[19]  Yaw-Juen Wang,et al.  An investigation on partial shading of PV modules with different connection configurations of PV cel , 2011 .

[20]  Ratna Dahiya,et al.  Mismatch losses in SPV systems subjected to partial shading conditions , 2013, 2013 International Conference on Advanced Electronic Systems (ICAES).

[21]  V. Agarwal,et al.  MATLAB-Based Modeling to Study the Effects of Partial Shading on PV Array Characteristics , 2008, IEEE Transactions on Energy Conversion.

[22]  C. A. Ramos-Paja,et al.  Mathematical model of total cross-tied photovoltaic arrays in mismatching conditions , 2012, 2012 IEEE 4th Colombian Workshop on Circuits and Systems (CWCAS).

[23]  Eleonora Riva Sanseverino,et al.  A Dynamic Electrical Scheme for the Optimal Reconfiguration of PV Modules under Non-Homogeneous Solar Irradiation , 2012 .

[24]  K. Jayanthi,et al.  A simple PV array modeling using MATLAB , 2011, 2011 International Conference on Emerging Trends in Electrical and Computer Technology.

[25]  F. Chenlo,et al.  Experimental study of mismatch and shading effects in the I-V characteristic of a photovoltaic module , 2006 .

[26]  B. Raison,et al.  Maximizing the Power Output of Partially Shaded Photovoltaic Plants Through Optimization of the Interconnections Among Its Modules , 2012, IEEE Journal of Photovoltaics.

[27]  M. M. A. Salama,et al.  Optimal Photovoltaic Array Reconfiguration to Reduce Partial Shading Losses , 2013, IEEE Transactions on Sustainable Energy.

[28]  Yanli Liu,et al.  An adaptive solar photovoltaic array reconfiguration method based on fuzzy control , 2010, 2010 8th World Congress on Intelligent Control and Automation.

[29]  M. M. A. Salama,et al.  An Optimal Total Cross Tied Interconnection for Reducing Mismatch Losses in Photovoltaic Arrays , 2013, IEEE Transactions on Sustainable Energy.

[30]  J. M. Ruiz,et al.  Computer simulation of shading effects in photovoltaic arrays , 2006 .

[31]  Damien Picault.  REDUCTION OF MISMATCH LOSSES IN GRID-CONNECTED PHOTOVOLTAIC SYSTEMS USING ALTERNATIVE TOPOLOGIES , 2010 .

[32]  Kashif Ishaque,et al.  Accurate MATLAB Simulink PV System Simulator Based on a Two-Diode Model , 2011 .

[33]  Mahmoud Alahmad,et al.  An adaptive utility interactive photovoltaic system based on a flexible switch matrix to optimize performance in real-time , 2012 .

[34]  B. Raison,et al.  Changing photovoltaic array interconnections to reduce mismatch losses: a case study , 2010, 2010 9th International Conference on Environment and Electrical Engineering.