Electropolishing of AISI-304 stainless steel using an oxidizing solution originally used for electrochemical coloration

Abstract Chemical polishing or electropolishing, instead of mechanical polishing, are recommended for the attainment of metallic surface polishes without the introduction of contaminants or tensions in the surface layers of the metal. The fundamental difference between the chemical and electrochemical polishing processes is that in the latter anodic currents/potentials are used to help in the dissolution and passivation of the metal. In this paper, the use of an oxidizing electrolytic solution (2.5 mol L −1 CrO 3  + 5.0 mol L −1 H 2 SO 4 ) originally employed in electrochemical coloration processes is reported for the electropolishing of AISI-314 stainless steel. Parameters involved in this electropolishing process, such as temperature, current density and time, were optimized so as to attain the best possible results evaluated by the obtained surface brightness measured by reflectance spectra. Surface analyses by scanning electron microscopy allowed a clear correlation between obtained brightness and surface smoothing. The best conditions obtained for the electropolishing process are: temperature of 45 °C, electrolysis time of 10 min and current density of around 25 A dm −2 . It should be pointed out that an electropolishing process signature (periodic oscillations of the cell potential) was established; this may be an important tool for optimizing and monitoring electropolishing processes.

[1]  D. Landolt,et al.  Electropolishing of tantalum in sulfuric acid–methanol electrolytes , 1999 .

[2]  M. Matlosz,et al.  Shape Changes in Electrochemical Polishing: The Effect of Temperature on the Anodic Leveling of Fe‐24Cr , 1989 .

[3]  T. E. Evans,et al.  The Nature of the Film on Coloured Stainless Steel , 1973 .

[4]  A. Marder,et al.  Effect of electropolishing variables on the current density-voltage relationship , 1988 .

[5]  E.-S. Lee,et al.  Machining Characteristics of the Electropolishing of Stainless Steel (STS316L) , 2000 .

[6]  Lawrence J. Durney,et al.  Electroplating Engineering Handbook , 1984 .

[7]  K. Ogura,et al.  Electrochemical Coloration of Stainless Steel and the Scanning Tunneling Microscopic Study , 1993 .

[8]  M. Matlosz,et al.  Impedance Analysis of a Model Mechanism for Acceptor‐Limited Electropolishing , 1994 .

[9]  S. R. Biaggio,et al.  Chemical and electrochemical coloration of stainless steel and pitting corrosion resistance studies , 2004 .

[10]  S. Vijayalakshmi,et al.  Electropolishing of Stainless Steel—a Review , 2001 .

[11]  S. R. Biaggio,et al.  Corrosion resistance of colored films grown on stainless steel by the alternating potential pulse method , 2003 .

[12]  D. Landolt,et al.  Fundamental aspects of electropolishing , 1987 .

[13]  J. Roux,et al.  Nanoscopic studies of stainless steel electropolishing , 2000 .

[14]  A. West,et al.  Copper Electropolishing in Concentrated Phosphoric Acid I . Experimental Findings , 1995 .

[15]  S. Fujimoto,et al.  The electrochemical conditions for coloured film formation on type 304 stainless steel with square wave polarization , 1993 .

[16]  K. A. Padmanabhan,et al.  Effect of electropolishing on the room-temperature low-cycle fatigue behaviour of AISl 304LN stainless steel , 1995 .