Abstract This paper presents the application of Taguchi method in optimizing the drying parameters of bird’s eye chili in a fluidized bed dryer. The drying parameters studied were bed depths, air velocities, operating temperatures and drying times. The standard L18 orthogonal array was used to accommodate the three factors of drying parameters. The drying experiments were conducted in a fluidized bed dryer at bed depths of 2 cm and 4 cm. The air velocities were varied at 0.85 m/s, 0.97 m/s and 1.09 m/s. The operating temperature is set between 50 °C and 70 °C at 10 °C interval. Meanwhile, the drying times were tested from 40 min to 120 min at 40 min interval. The results showed that the moisture contents and the drying rate were significantly controlled by the drying time. Finally, it was found that the optimum operating condition for the drying parameters were obtained at the bed depth of 2 cm, air velocity of 1.09 m/s and operating temperature of 70 °C. The same result was also obtained when using OFAT (one factor at a time) method.
[1]
E. Akpinar,et al.
Thin layer drying of red pepper
,
2003
.
[2]
Vaios T. Karathanos,et al.
Drying kinetics of some vegetables
,
2003
.
[3]
Siti Kartom Kamarudin,et al.
The drying kinetics of bird’s chillies in a fluidized bed dryer
,
2007
.
[4]
S. Khalloufi,et al.
Water activity of freeze dried mushrooms and berries
,
2000
.
[5]
Madhan Shridhar Phadke,et al.
Quality Engineering Using Robust Design
,
1989
.
[6]
Suat Tanaydin.
Robust Design and Analysis for Quality Engineering
,
1996
.
[7]
Sangeeta Prakash,et al.
Performance evaluation of blanched carrots dried by three different driers
,
2004
.