An experimental investigation on the laser cutting of thin metal sheets using a Q-switched diode pumped Nd:YAG laser and a conventional lamp pumped Nd:YAG laser with pulse duration of 150 ns and 0.3 ms respectively is described in this paper. Using the laser with short pulses the lower single pulse energy was not sufficient to remove the material along the entire thickness of the sheet in a single laser scan and multi-passes were required. However, short pulses with higher peak power densities allowed to produce precise cuts with a smaller width than long pulses. These two cutting processes by a multi-passes laser scan (using short pulses of 150 ns) and by a single laser scan (using long pulses of 0.3 ms) were compared in terms of laser energy, machining time and process performance. It was also observed that, when using short pulses, the groove geometry was different depending on the number of passes and the material removal rate due to the laser scan significantly decreases when the groove depth increases.
[1]
Reinhart Poprawe,et al.
Fundamental investigations of micromachining by nano- and picosecond laser radiation
,
1998
.
[2]
Y. Yao,et al.
Time scale effects in laser material removal: a review
,
2005
.
[3]
Ernst Wintner,et al.
Novel applications of short and ultra-short pulses
,
2005
.
[4]
Wolfgang Schulz,et al.
Laser machining by short and ultrashort pulses, state of the art
,
2002
.
[5]
Mool C. Gupta,et al.
Pulse width effect in ultrafast laser processing of materials
,
2005
.
[6]
H. J. Booth,et al.
Recent applications of pulsed lasers in advanced materials processing
,
2004
.
[7]
T. Yue,et al.
Theoretical and experimental study on the kerf profile of the laser micro-cutting NiTi shape memory alloy using 355 nm Nd:YAG
,
2005
.