2 cm spatial-resolution and 2 km range Brillouin optical fiber sensor using a transient differential pulse pair.

We report a high-spatial-resolution and long-range distributed temperature sensor through optimizing differential pulse-width pair Brillouin optical time-domain analysis (DPP-BOTDA). In DPP-BOTDA, the differential signal suffers from a signal-to-noise ratio (SNR) reduction with respect to the original signals, and for a fixed pulse-width difference the SNR reduction increases with the pulse width. Through reducing the pulse width to a transient regime (near to or less than the phonon lifetime) to decrease the SNR reduction after the differential process, the optimized 8/8.2 ns pulse pair is applied to realize a 2 cm spatial resolution, where a pulse generator with a 150 ps fall-time is used to ensure the effective resolution of DPP-BOTDA. In the experiment, a 2 cm spatial-resolution hot-spot detection with a 2 °C temperature accuracy is demonstrated over a 2 km sensing fiber.

[1]  Xiaoyi Bao,et al.  System optimization of a long-range Brillouin-loss-based distributed fiber sensor. , 2010, Applied optics.

[2]  Moshe Tur,et al.  High Spatial and Spectral Resolution Long-Range Sensing Using Brillouin Echoes , 2010, Journal of Lightwave Technology.

[3]  Luc Thevenaz,et al.  Time-Domain Distributed Fiber Sensor With 1 cm Spatial Resolution Based on Brillouin Dynamic Grating , 2010, Journal of Lightwave Technology.

[4]  M. Tur,et al.  High spatial resolution distributed sensing in optical fibers by Brillouin gain-profile tracing. , 2010, Optics express.

[5]  K. Hotate,et al.  One-End-Access High-Speed Distributed Strain Measurement with 13-mm Spatial Resolution Based on Brillouin Optical Correlation-Domain Reflectometry , 2009, IEEE Photonics Technology Letters.

[6]  X. Bao,et al.  Differential pulse-width pair BOTDA for high spatial resolution sensing. , 2008, Optics express.

[7]  Xiaoyi Bao,et al.  Using pulse with a dark base to achieve high spatial and frequency resolution for the distributed Brillouin sensor. , 2008, Optics letters.

[8]  Luc Thévenaz,et al.  Distributed fiber sensing using Brillouin echoes , 2008, International Conference on Optical Fibre Sensors.

[9]  Y. Koyamada,et al.  Novel Technique to Improve Spatial Resolution in Brillouin Optical Time-Domain Reflectometry , 2007, IEEE Photonics Technology Letters.

[10]  B. Colpitts,et al.  Dark-Pulse Brillouin Optical Time-Domain Sensor With 20-mm Spatial Resolution , 2007, Journal of Lightwave Technology.

[11]  Zuyuan He,et al.  Distributed strain measurement with millimeter-order spatial resolution based on Brillouin optical correlation domain analysis. , 2006, Optics letters.

[12]  Kinzo Kishida,et al.  Pulse pre-pump method for cm-order spatial resolution of BOTDA , 2005, International Conference on Optical Fibre Sensors.

[13]  S. M. Maughan,et al.  57-km single-ended spontaneous Brillouin-based distributed fiber temperature sensor using microwave coherent detection. , 2001, Optics letters.

[14]  H. Naruse,et al.  Trade-off between the spatial and the frequency resolutions in measuring the power spectrum of the Brillouin backscattered light in an optical fiber. , 1999, Applied optics.

[15]  X. Bao,et al.  Characterization of the Brillouin-loss spectrum of single-mode fibers by use of very short (<10-ns) pulses. , 1999, Optics letters.

[16]  M Farhadiroushan,et al.  Temperature and strain dependence of the power level and frequency of spontaneous Brillouin scattering in optical fibers. , 1997, Optics letters.

[17]  L. Thévenaz,et al.  Simple distributed fiber sensor based on Brillouin gain spectrum analysis. , 1996, Optics letters.

[18]  X. Bao,et al.  22-km distributed temperature sensor using Brillouin gain in an optical fiber. , 1993, Optics letters.

[19]  T. Horiguchi,et al.  Coherent self-heterodyne detection of spontaneously Brillouin-scattered light waves in a single-mode fiber. , 1993, Optics letters.