Fuel Composition Effects at Constant RON and MON in an HCCI Engine Operated with Negative Valve Overlap

The effects of fuel properties on gasoline HCCI operation have been investigated in a single cylinder, 500 cc, 11.3 CR port fuel injected research engine, operated at lambda=1 and equipped with hydraulic valve actuation. HCCI is promoted by early exhaust valve closing to retain hot exhaust in the cylinder, thereby increasing the cylinder gas temperature. Test fuels were formulated with pure components to have the same RON, MON, and octane sensitivity as an indolene reference fuel, but with a wide range of fuel composition differences. Experiments have been carried out to determine if fuel composition plays a role in HCCI combustion properties, independent of octane numbers. Fuel economy, emissions, and combustion parameters have been measured at several fixed speed/load conditions over a range of exhaust valve closing angles. When the data are compared at constant combustion phasing, fuel effects on emissions and other combustion properties are small. However, when compared at constant exhaust valve closing angle, fuel composition effects are more pronounced, specifically regarding ignition. Operability range differences are also related to fuel composition. An all-paraffinic (normal, iso, and cycloparaffins) fuel exhibited distinctly earlier combustion phasing, increased rate of cylinder pressure rise, and increased rate of maximum heat release comparedmore » to the indolene reference fuel. Conversely, olefin-containing fuels exhibited retarded combustion phasing. The fuels with the most advanced ignition showed a wider operating range in terms of engine speed and load, irrespective of exhaust closing angle. These ignition differences reflect contributions from both fuel and EGR kinetics, the effects of which are discussed. The fuel composition variables are somewhat inter-correlated, which makes the experimental separation their effects imprecise with this small set of fuels, though clear trends are evident. The overall effects of fuel composition on engine performance and emissions are small. However, the results suggest that the effects on combustion phasing and engine operability range may need to be considered in the practical implementation of HCCI for fuels with large compositional variations.« less

[1]  John E. Dec,et al.  Isolating the Effects of Fuel Chemistry on Combustion Phasing in an HCCI Engine and the Potential of Fuel Stratification for Ignition Control , 2004 .

[2]  B. Johansson,et al.  The Effect of Fuel Volatility on HCCI Using Simultaneous Formaldehyde and OH PLIF , 2004 .

[3]  Gautam Kalghatgi,et al.  Auto-Ignition Quality of Practical Fuels and Implications for Fuel Requirements of Future SI and HCCI Engines , 2005 .

[4]  Ingemar Denbratt,et al.  The Influence of PRF and Commercial Fuels with High Octane Number on the Auto-ignition Timing of an Engine Operated in HCCI Combustion Mode with Negative Valve Overlap , 2004 .

[5]  Gen Shibata,et al.  The Effect of Fuel Properties on Low and High Temperature Heat Release and Resulting Performance of an HCCI Engine , 2004 .

[6]  A. Dean,et al.  Combustion Chemistry of Nitrogen , 2000 .

[7]  Koji Yoshida,et al.  A Comparative Study of HCCI and ATAC Combustion Characteristics Based on Experimentation and Simulations Influence of the Fuel Octane Number and Internal EGR on Combustion , 2005 .

[8]  Bruce G. Bunting,et al.  Combustion, Control, and Fuel Effects in a Spark Assisted HCCI Engine Equipped with Variable Valve Timing , 2006 .

[9]  William J. Pitz,et al.  Oxidation of automotive primary reference fuels at elevated pressures , 1999 .

[10]  Steve Richardson,et al.  Operating Characteristics of a Homogeneous Charge Compression Ignition Engine with Cam Profile Switching - Simulation Study , 2003 .

[11]  Tanet Aroonsrisopon,et al.  An Investigation Into the Effect of Fuel Composition on HCCI Combustion Characteristics , 2002 .

[12]  William R. Leppard,et al.  A Comparison of Olefin and Paraffin Autoignition chemistries: A Motored-Engine Study , 1989 .

[13]  Gen Shibata,et al.  The Interaction Between Fuel Chemicals and HCCI Combustion Characteristics Under Heated Intake Air Conditions , 2006 .

[14]  Hui Xie,et al.  EFFECT OF RECYCLED BURNED GASES ON HOMOGENEOUS CHARGE COMPRESSION IGNITION COMBUSTION , 2005 .

[15]  Gautam Kalghatgi,et al.  The Available and Required Autoignition Quality of Gasoline - Like Fuels in HCCI Engines at High Temperatures , 2004 .

[16]  Lucien Koopmans,et al.  Cycle to Cycle Variations: Their Influence on Cycle Resolved Gas Temperature and Unburned Hydrocarbons from a Camless Gasoline Compression Ignition Engine , 2002 .

[17]  Gen Shibata,et al.  Correlation of Low Temperature Heat Release With Fuel Composition and HCCI Engine Combustion , 2005 .

[18]  Hui Xie,et al.  Comparison of HCCI Combustion Respectively Fueled with Gasoline, Ethanol and Methanol through the Trapped Residual Gas Strategy , 2006 .

[19]  Hua Zhao,et al.  Dilution Effects on the Controlled Auto-Ignition (CAI) Combustion of Hydrocarbon and Alcohol Fuels , 2001 .

[20]  Nicolas Jeuland,et al.  New HCCI/CAI combustion process development : Methodology for determination of relevant fuel parameters , 2004 .