Cocktail effect of Fe2O3 and TiO2 semiconductors for a high performance dye-sensitized solar cell

Abstract The bi-semiconductors of TiO2 and Fe2O3 were used as a photoelectrode material in a high performance dye-sensitized solar cell due to cocktail effects from the two conduction bands. The size of the semiconductors was reduced by using a paint shaker to enlarge the contact area of the semiconductor with the dye or electrolyte. The fill factor and the efficiency of the prepared dye-sensitized solar cell were improved by over 16% and 300%, respectively; these parameters were measured from a current–voltage curve that was based on the effects of the Fe2O3 co-semiconductor and the size reduction. A mechanism is suggested wherein the conduction band of Fe2O3 works to prohibit the trapping effects of electrons in the conduction band of TiO2. This result is attributed to the prevention of electron recombination between electrons in the TiO2 conduction band with dye or electrolytes. The mechanism is suggested based on impedance results, which indicate improved electron transport at the interface of the TiO2/dye/electrolyte.

[1]  C. Chou,et al.  Preparation of TiO2/Nano-metal composite particles and their applications in dye-sensitized solar cells , 2009 .

[2]  Jin-Kook Lee,et al.  Preparations of TiO2 pastes and its application to light-scattering layer for dye-sensitized solar cells , 2009 .

[3]  S. Icli,et al.  Dicationic bis-imidazolium molten salts for efficient dye sensitized solar cells: Synthesis and photovoltaic properties , 2009 .

[4]  T. Hyeon,et al.  Improved charge transport in dye-sensitized solar cells employing viscous non-volatile electrolytes , 2008 .

[5]  B. Hong,et al.  A comparative study of dye-sensitized solar cells added carbon nanotubes to electrolyte and counter electrodes , 2010 .

[6]  T. Jacobsen,et al.  Electrochemical reaction rates in a dye-sensitised solar cell - The iodide/tri-iodide redox system , 2006 .

[7]  Ji-Yeon Chae,et al.  Comparison of the photovoltaic efficiency on DSSC for nanometer sized TiO2 using a conventional sol-gel and solvothermal methods , 2010 .

[8]  Lijian Meng,et al.  The control of the diameter of the nanorods prepared by dc reactive magnetron sputtering and the applications for DSSC , 2010 .

[9]  K. Ho,et al.  Incorporating carbon nanotube in a low-temperature fabrication process for dye-sensitized TiO2 solar cells , 2008 .

[10]  P. Balraju,et al.  Simple sensitizers of low band gap based on 4-nitro-α-cyanostilbene prepared from a one-step reaction for efficient dye-sensitized solar cells , 2010 .

[11]  Rossella Giorgi,et al.  Impedance analysis of nanocarbon DSSC electrodes , 2009 .

[12]  S. Rhee,et al.  Improved performance of dye-sensitized solar cells with TiO2/alumina core–shell formation using atomic layer deposition , 2010 .

[13]  J. Tao,et al.  Preparation and characterization of polyaniline film on stainless steel by electrochemical polymerization as a counter electrode of DSSC , 2010 .

[14]  Hongxing Yang,et al.  Low resistance dye-sensitized solar cells based on all-titanium substrates using wires and sheets , 2009 .

[15]  J. Zhong,et al.  Dye-sensitized solar cells using ZnO nanotips and Ga-doped ZnO films , 2008 .

[16]  P. Balraju,et al.  Effect of counter electrode, thickness and sintering temperature of TiO2 electrode and TBP addition in electrolyte on photovoltaic performance of dye sensitized solar cell using pyronine G (PYR) dye , 2009 .

[17]  K. Sumathy,et al.  An analytical study of the porosity effect on dye-sensitized solar cell performance , 2006 .

[18]  Shengjun Li,et al.  Electrochemical impedance analysis of nanoporous TiO2 electrode at low bias potential , 2010 .

[19]  Dong Yoon Lee,et al.  Glass frit overcoated silver grid lines for nano-crystalline dye sensitized solar cells , 2006 .

[20]  Jihuai Wu,et al.  The preparation of poly(glycidyl acrylate)–polypyrrole gel-electrolyte and its application in dye-sensitized solar cells , 2010 .

[21]  Jihuai Wu,et al.  Enhancing photoelectrical performance of dye-sensitized solar cell by doping with europium-doped yttria rare-earth oxide , 2010 .

[22]  T. Peng,et al.  Fabrication and photoelectrochemical properties of TiO2 films on Ti substrate for flexible dye-sensitized solar cells , 2010 .

[23]  T. Peng,et al.  Effects of annealing conditions on the photoelectrochemical properties of dye-sensitized solar cells made with ZnO nanoparticles , 2010 .

[24]  N. Park,et al.  Nano-grain SnO2 electrodes for high conversion efficiency SnO2-DSSC , 2011 .

[25]  K. Ho,et al.  Selective conditions for the fabrication of a flexible dye-sensitized solar cell with Ti/TiO2 photoanode , 2010 .

[26]  Yanhong Luo,et al.  Low temperature fabrication of efficient porous carbon counter electrode for dye-sensitized solar cells , 2009 .

[27]  D. Lincot,et al.  Impedance measurements of nanoporosity in electrodeposited ZnO films for DSSC , 2010 .

[28]  W. Zhou,et al.  TiO2-B narrow nanobelt/TiO2 nanoparticle composite photoelectrode for dye-sensitized solar cells , 2009 .

[29]  R. Kikuchi,et al.  Preparation of silica-modified TiO2 and application to dye-sensitized solar cells , 2006 .

[30]  Young-Jin Jung,et al.  Enhanced efficiency of dye-sensitized TiO2 solar cells (DSSC) by doping of metal ions. , 2005, Journal of colloid and interface science.

[31]  M. Stylianakis,et al.  Synthesis, photophysics of two new perylene bisimides and their photovoltaic performances in quasi solid state dye sensitized solar cells , 2009 .

[32]  K. Ho,et al.  A study on the electron transport properties of TiO2 electrodes in dye-sensitized solar cells , 2007 .

[33]  Xiao Wei Sun,et al.  Bilayer ZnO nanostructure fabricated by chemical bath and its application in quantum dot sensitized solar cell , 2009 .

[34]  Yue Shen,et al.  Influence of Fe ions in characteristics and optical properties of mesoporous titanium oxide thin films , 2009 .