Performance Evaluation of a Desiccant Dehumidifier with a Heat Recovery Unit

In order to effectively increase the drying rate and reduce the energy consumption, a dryer which reduces the air humidity at the dryer inlet using desiccant and regenerates the desiccant by recovering waste heat using a heat pipe heat exchanger was developed in this study. Both the adsorption rate and desorption rate of the dryer were measured at several ambient temperatures ranging from 15 °C to 35 °C, relative humidity levels of air ranging from 20% to 85%, and airflow rates ranging from 30 m3/h to 150 m3/h. The results showed that the adsorption rate in an environment of high relative humidity of air was 4.89 times higher than that of low relative humidity of air at 15 °C. Moreover, the difference in adsorption rate between two given relative humidity of air increased as the ambient temperature decreased. The specific energy consumption estimated with both energy consumption during desorption and the desorption rate indicated that the energy consumption was 8.27 kJ/g H2O without using recovered heat, while the energy consumption was 4.77 kJ/g H2O using recovered heat at 130 °C.

[1]  J. Elston Ahlberg,et al.  Rates of Water Vapor Adsorption from Air by Silica Gel , 1939 .

[2]  Ruzhu Wang,et al.  Experimental comparison and analysis on silica gel and polymer coated fin-tube heat exchangers , 2010 .

[3]  R. S. Barlow.  Analysis of the adsorption process and of desiccant cooling systems: A pseudo- steady-state model for coupled heat and mass transfer , 1982 .

[4]  Ryozo Ooka,et al.  Field Study on Humidification Performance of a Desiccant Air-Conditioning System Combined with a Heat Pump , 2016 .

[5]  Carlo Roselli,et al.  Assessment of Energy, Environmental and Economic Performance of a Solar Desiccant Cooling System with Different Collector Types , 2014 .

[6]  Tianshu Ge,et al.  Technical development of rotary desiccant dehumidification and air conditioning: A review , 2010 .

[7]  Cristina Ratti,et al.  Hot air and freeze-drying of high-value foods : a review , 2001 .

[8]  Robert J. Moffat,et al.  Describing the Uncertainties in Experimental Results , 1988 .

[9]  Yuanzhen Jiang,et al.  Experimental investigation on a novel heat pump system based on desiccant coated heat exchangers , 2018 .

[10]  Dae-Young Lee,et al.  Optimization of desiccant wheel speed and area ratio of regeneration to dehumidification as a function of regeneration temperature , 2009 .

[11]  C. Nóbrega,et al.  An analysis of the heat and mass transfer roles in air dehumidification by solid desiccants , 2012, Energy and Buildings.

[12]  S. Srinivasa Murthy,et al.  Application of desiccant wheel to control humidity in air-conditioning systems , 2004 .

[13]  Ahlem Zouaoui,et al.  Open solid desiccant cooling air systems: A review and comparative study , 2016 .

[14]  R Haul,et al.  Nonisothermal sorption kinetics in porous adsorbents , 1984 .

[15]  Robert W. Besant,et al.  Heat and mass transfer during silica gel–moisture interactions , 2005 .

[16]  J. B. Rosen.  General Numerical Solution for Solid Diffusion in Fixed Beds , 1954 .

[17]  H. Z. Hassan.  Performance Evaluation of a Continuous Operation Adsorption Chiller Powered by Solar Energy Using Silica Gel and Water as the Working Pair , 2014 .

[18]  Ruzhu Wang,et al.  Experimental investigation on solar powered desiccant coated heat exchanger humidification air conditioning system in winter , 2017 .

[19]  Ruzhu Wang,et al.  Experimental investigation and analysis of composite silica-gel coated fin-tube heat exchangers , 2015 .

[20]  Yuan Xiugan,et al.  Study of a new modified cross-cooled compact solid desiccant dehumidifier , 2008 .

[21]  Sudhakar Neti,et al.  Measurements of effectiveness in a silica gel rotary exchanger , 2000 .