Online identification algorithms for integrated dielectric electroactive polymer sensors and self-sensing concepts

Transducers based on dielectric electroactive polymers (DEAP) use electrostatic pressure to convert electric energy into strain energy or vice versa. Besides this, they are also designed for sensor applications in monitoring the actual stretch state on the basis of the deformation dependent capacitive–resistive behavior of the DEAP. In order to enable an efficient and proper closed loop control operation of these transducers, e.g. in positioning or energy harvesting applications, on the one hand, sensors based on DEAP material can be integrated into the transducers and evaluated externally, and on the other hand, the transducer itself can be used as a sensor, also in terms of self-sensing. For this purpose the characteristic electrical behavior of the transducer has to be evaluated in order to determine the mechanical state. Also, adequate online identification algorithms with sufficient accuracy and dynamics are required, independent from the sensor concept utilized, in order to determine the electrical DEAP parameters in real time. Therefore, in this contribution, algorithms are developed in the frequency domain for identifications of the capacitance as well as the electrode and polymer resistance of a DEAP, which are validated by measurements. These algorithms are designed for self-sensing applications, especially if the power electronics utilized is operated at a constant switching frequency, and parasitic harmonic oscillations are induced besides the desired DC value. These oscillations can be used for the online identification, so an additional superimposed excitation is no longer necessary. For this purpose a dual active bridge (DAB) is introduced to drive the DEAP transducer. The capabilities of the real-time identification algorithm in combination with the DAB are presented in detail and discussed, finally.

[1]  P H Sydenham,et al.  Phase sensitive detection as a means to recover signals buried in noise , 1975 .

[2]  J. M. Noworolski,et al.  Generalized averaging method for power conversion circuits , 1990, 21st Annual IEEE Conference on Power Electronics Specialists.

[3]  Ron Pelrine,et al.  Dielectric elastomers: generator mode fundamentals and applications , 2001, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[4]  Peter Sommer-Larsen,et al.  Response of dielectric elastomer actuators , 2001, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[5]  Emilio Calius,et al.  Integrated extension sensor based on resistance and voltage measurement for a dielectric elastomer , 2007, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[6]  D. Rossi,et al.  Dielectric elastomers as electromechanical transducers: Fundamentals, Materials, Devices, Models and Applications of an Emerging Electroactive Polymer Technology , 2008 .

[7]  Hyouk Ryeol Choi,et al.  Self-sensing of dielectric elastomer actuator , 2008, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[8]  Hyouk Ryeol Choi,et al.  A dielectric elastomer actuator with self-sensing capability , 2008, SPIE Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[9]  Yves Leterrier,et al.  Frequency dependent dielectric and mechanical behavior of elastomers for actuator applications , 2009 .

[10]  Skandar Basrour,et al.  Dielectric properties of polyacrylate thick films used in sensors and actuators , 2010 .

[11]  Mohamed Benslimane,et al.  Electromechanical properties of novel large strain PolyPower film and laminate components for DEAP actuator and sensor applications , 2010, Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[12]  Iain A. Anderson,et al.  Closed loop control of dielectric elastomer actuators , 2011, Smart Structures and Materials + Nondestructive Evaluation and Health Monitoring.

[13]  Christian Graf,et al.  Dielectric elastomers for hydro power harvesting , 2012 .

[14]  Todd A. Gisby,et al.  Multi-functional dielectric elastomer artificial muscles for soft and smart machines , 2012 .

[15]  Christian Graf,et al.  A model of the electrodynamic field distribution for optimized electrode design for dielectric electroactive polymer transducers , 2012 .

[16]  Thorben Hoffstadt,et al.  Integrated Sensor Concepts for Dielectric Elastomer Actuators , 2013 .

[17]  Christian Graf,et al.  Modular DC-DC converter system for energy harvesting with EAPs , 2013, Smart Structures.

[18]  Todd A. Gisby,et al.  Self sensing feedback for dielectric elastomer actuators , 2013 .

[19]  Thorben Hoffstadt,et al.  Power electronics concepts for driving EAP actuators , 2013, Smart Structures.

[20]  Christian Graf,et al.  Optimization of the energy harvesting control for dielectric elastomer generators , 2013 .

[21]  S C Burgess,et al.  Multi-modal locomotion: from animal to application , 2013, Bioinspiration & biomimetics.

[22]  Thorben Hoffstadt,et al.  Model-based control of a dual active bridge for bidirectional feeding of DEAP transducers , 2014, 2014 IEEE/ASME International Conference on Advanced Intelligent Mechatronics.