Characteristics Analysis of Joint Acoustic Echo and Noise Suppression in Periodic Drillstring Waveguide

A new method of wireless data telemetry used by oil industry uses compressional acoustic waves to transmit downhole information from the bottom hole to the surface. Unfortunately, acoustic echoes and drilling vibration noises in periodic drillstring are a major issue in transmission performance. A combined acoustic echo and noise suppression method based on wave motion characteristic in drillstring is adopted to enhance an upward-going transmitted acoustic signal. The presented scheme consists of a primary acoustic echo canceller using an array of two accelerometers for dealing with the downward-going noises and a secondary acoustic insulation structure for restraining the upward-going vibration noises. Furthermore, the secondary acoustic insulation structure exhibits a banded and dispersive spectral structure because of periodic groove configuration. By using a finite-differential algorithm for the one-dimensional propagation of longitudinal waves, acoustic receiving characteristics of transmitted signals are simulated with additive Gaussian noise in a periodic pipe structure of limited length to investigate the effects on transmission performance optimization. The results reveal that the proposed scheme can achieve a much lower error bit ratio over a specified acoustic isolation frequency range with a 30–40 dB reduction in the average noise level compared to traditional single-receiver scheme.

[1]  T. G. Barnes,et al.  Passbands for Acoustic Transmission in an Idealized Drill String , 1972 .

[2]  J. Rector,et al.  The use of drill‐bit energy as a downhole seismic source , 1991 .

[3]  Wallace R. Gardner,et al.  Acoustic Telemetry Delivers More Real-Time Downhole Data in Underbalanced Drilling Operations , 2006 .

[4]  D. Drumheller.  Attenuation of sound waves in drill strings , 1993 .

[5]  Kazuyasu Wada,et al.  Development of a Continuous Directional Coring System for Deep-sea Drilling , 2011 .

[6]  Li Cheng,et al.  An experimental rig for near-bit force measurement and drillstring acoustic transmission of BHA , 2011 .

[7]  F. Poletto.  Use of dual waves for the elimination of reverberations in drill strings , 2002 .

[8]  Wallace R. Gardner,et al.  Directional Propagation Cancellation for Acoustic Communication Along the Drill String , 2006, 2006 IEEE International Conference on Acoustics Speech and Signal Processing Proceedings.

[9]  D. Drumheller.  Coupled extensional and bending motion in elastic waveguides , 1993 .

[10]  Sw Sjoerd Rienstra,et al.  Sound transmission through a periodic cascade with application to drill pipes , 1998 .

[11]  Sinan Sinanovic.  Limits of acoustic waveguide communication , 2006 .

[12]  Tianhuai Ding,et al.  Coreless Electromagnetic Coupling-Based Drillstem Telemetry Using Dual Electronic Gauges , 2007 .

[13]  J. Oetting,et al.  A Comparison of Modulation Techniques for Digital Radio , 1979, IEEE Trans. Commun..

[14]  Stephen Butt,et al.  Vibration Analysis of a Drillstring in Vibration-Assisted Rotary Drilling: Finite Element Modeling With Analytical Validation , 2013 .

[15]  Michael Reeves,et al.  High Speed Acoustic Telemetry Network Enables Real-Time Along String Measurements, Greatly Reducing Drilling Risk , 2011 .