Reducing the air temperature inside the simple structure greenhouse using roof angle variation

There is a problem with the natural ventilation of a Simple Structure Greenhouse (SSG), having a roof with a gable end and a roof vent placed at a height of <2.5 m above the greenhouse column, with an average roof angle of <15°, that causes the air temperature inside the greenhouse to be much higher than the ambient temperature (an average of 6-8 K), which can be found in greenhouses that are covered by plastic film. This investigation considers the flow pattern and temperature distribution in an empty greenhouse with a dimension of 48 m 2 by using the computational fluid dynamic technique, CFD, as a tool for the study. It was found that the heat convection generated wake flows under the canopy by thermally driven ventilation, and that the heat was transferred from the moving air into the greenhouse by convection and was allowed through the hot temperature outlet via the sidewall vents by the wind. The change of the various roof angles at an average angle of 15°, 30° and 42° pitch, in combination with an external wind speed of <2.0 m s -1 , serves the purpose of reducing the temperature inside the greenhouse to approximately ambient air temperature, considering the loads of external wind speed applied to the roof. The investigation results of the ventilation rate and the wind pressure coefficient, at a reference roof angle of 30°, is adequate for greenhouse construction. There will be air ventilation, called mixed convection, inside the greenhouse where the Gr Re -2 <1 and temperature differences (T i – T o ) at 2.5 m above ground are less than 2 K.

[1]  J. Kalma,et al.  TRANSPIRATION AND GROWTH OF PHASEOLUS VULGARIS L. AS AFFECTED BY WIND SPEED , 1966 .

[2]  G. Bot.  Greenhouse climate : from physical processes to a dynamic model , 1983 .

[3]  Peter Richards,et al.  Computational and wind tunnel modelling of mean wind loads on the Silsoe structures building , 1992 .

[4]  George Papadakis,et al.  Mixed, forced and free convection heat transfer at the greenhouse cover , 1992 .

[5]  Peter Richards,et al.  Structure of the atmospheric boundary layer below 25 m and implications to wind loading on low-rise buildings , 1992 .

[6]  T. Boulard,et al.  Modelling of Air Exchange Rate in a Greenhouse Equipped with Continuous Roof Vents , 1995 .

[7]  C. Kittas,et al.  NATURAL VENTILATION OF A GREENHOUSE WITH RIDGE AND SIDE OPENINGS: SENSITIVITY TO TEMPERATURE AND WIND EFFECTS , 1997 .

[8]  A. F. Mills.  Basic Heat and Mass Transfer , 1999 .

[9]  Bassam A. Younis,et al.  On the prediction of turbulent flows around full-scale buildings , 2000 .

[10]  A. Alarcón,et al.  FUNDAMENTALS , 2000, Springer Monographs in Mathematics.

[11]  Shaojin Wang,et al.  Predicting the Microclimate in a Naturally Ventilated Plastic House in a Mediterranean Climate , 2000 .

[12]  Antonios Mistriotis,et al.  Numerical estimation of the internal and external aerodynamic coefficients of a tunnel greenhouse structure with openings , 2002 .

[13]  Shaojin Wang,et al.  PA—Precision Agriculture: Convective and Ventilation Transfers in Greenhouses, Part 1: the Greenhouse considered as a Perfectly Stirred Tank , 2002 .

[14]  L. Albright.  CONTROLLING GREENHOUSE ENVIRONMENTS , 2002 .

[15]  Hsin Yu,et al.  SE—Structures and Environment: Scale Model Analysis of Opening Effectiveness for Wind-induced Natural Ventilation Openings , 2002 .

[16]  J. B Campen,et al.  Determination of greenhouse-specific aspects of ventilation using three-dimensional Computational Fluid Dynamics , 2003 .

[17]  John D. Ginger,et al.  Effect of building length on wind loads on low-rise buildings with a steep roof pitch , 2003 .

[18]  Juan Ignacio Montero,et al.  Computational Fluid Dynamic Modeling to Improve the Design of the Spanish Parral Style Greenhouse , 2003 .

[19]  J. Montero,et al.  Natural Ventilation of Parral Greenhouses , 2004 .

[20]  John Burnett,et al.  Wind-induced pressure at external surfaces of a high-rise residential building in Hong Kong , 2005 .

[21]  Juan Ignacio Montero,et al.  COMPUTATIONAL FLUID DYNAMIC MODELING TO IMPROVE THE DESIGN OF THE SPANISH PARRAL STYLE GREENHOUSE , 2005 .

[22]  S. Thepa,et al.  COMPARISON BETWEEN MEASURED AND PREDICTED VENTILATION RATES IN A NATURALLY VENTILATED GREENHOUSE , 2006 .

[23]  Thierry Boulard,et al.  Analysis of Greenhouse Ventilation Efficiency based on Computational Fluid Dynamics , 2006 .

[24]  T. Stathopoulos,et al.  CFD simulation of the atmospheric boundary layer: wall function problems , 2007 .

[25]  V. Sethi,et al.  Survey of cooling technologies for worldwide agricultural greenhouse applications , 2007 .

[26]  Nicolas G. Wright,et al.  On the use of the k–ε model in commercial CFD software to model the neutral atmospheric boundary layer , 2007 .

[27]  Juan Ignacio Montero,et al.  Analysis of the role of sidewall vents on buoyancy-driven natural ventilation in parral-type greenhouses with and without insect screens using computational fluid dynamics , 2009 .

[28]  V. Sethi.  On the selection of shape and orientation of a greenhouse: Thermal modeling and experimental validation , 2009 .

[29]  D. Ali.  Sera içi bitki topluluklarının mikroklimatolojik modelle ısı ve kütle transferi karakteristiklerinin saptanması , 2009 .

[30]  Tahir Ayata.  Investigation of building height and roof effect on the air velocity and pressure distribution around the detached houses in Turkey , 2009 .