RESEARCH PROGRAMME ON SEISMIC PERFORMANCE OF REINFORCED CONCRETE WALLS: KEY RECOMMENDATIONS

A wide range of reinforced concrete (RC) wall performance was observed following the 2010/2011 Canterbury earthquakes, with most walls performing as expected, but some exhibiting undesirable and unexpected damage and failure characteristics. A comprehensive research programme, funded by the Building Performance Branch of the New Zealand Ministry of Business, Innovation and Employment, and involving both numerical and experimental studies, was developed to investigate the unexpected damage observed in the earthquakes and provide recommendations for the design and assessment procedures for RC walls. In particular, the studies focused on the performance of lightly reinforced walls; precast walls and connections; ductile walls; walls subjected to bi-directional loading; and walls prone to out-of-plane instability. This paper summarises each research programme and provides practical recommendations for the design and assessment of RC walls based on key findings, including recommended changes to NZS 3101 and the NZ Seismic Assessment Guidelines.

[1]  Yiqiu Lu,et al.  Seismic Design of Lightly Reinforced Concrete Walls , 2017 .

[2]  Stefano Pampanin,et al.  Out-of-Plane Response of In-Plane-Loaded Ductile Structural Walls: State-of-the-Art and Classification of the Observed Mechanisms , 2020 .

[3]  Richard Henry,et al.  Cyclic Testing of Reinforced Concrete Walls with Distributed Minimum Vertical Reinforcement , 2017 .

[4]  Zachary J. Whitman.  Investigation of Seismic Failure Modes in Flexural Concrete Walls Using Finite Element Analysis , 2015 .

[5]  Richard Henry,et al.  Performance of panel-to-foundation connections in low-rise precast concrete buildings , 2018 .

[6]  W. Y. Kam,et al.  Seismic performance of reinforced concrete buildings in the 22 February Christchurch (Lyttelton) earthquake , 2011 .

[7]  F. Dashti,et al.  Evaluation of New Zealand code requirements related to instability failure of structural walls , 2017 .

[8]  Richard Henry,et al.  In-plane cyclic testing of precast concrete wall panels with grouted metal duct base connections , 2019, Engineering Structures.

[9]  Stefano Pampanin,et al.  Blind prediction of in-plane and out-of-plane responses for a thin singly reinforced concrete flanged wall specimen , 2017, Bulletin of Earthquake Engineering.

[10]  Zhang Sihai.  Experimental study on ductility of high performance concrete shearwall , 2009 .

[11]  Arsalan Niroomandi.  Seismic behaviour of rectangular reinforced concrete walls under bi-directional loading. , 2018 .

[12]  Farhad Dashti.  Out-of-plane instability of rectangular reinforced concrete walls under in-plane loading. , 2017 .

[13]  Richard Henry,et al.  In-plane testing of precast concrete wall panels with grout sleeves , 2017 .

[14]  Richard Henry,et al.  Comparison of Minimum Vertical Reinforcement Requirements for Reinforced Concrete Walls , 2018 .

[15]  S. Pampanin,et al.  NUMERICAL INVESTIGATIONS ON RECTANGULAR SQUAT RENFORCED CONCRETE WALLS UNDER BI-DIRECTIONAL LOADING , 2016 .

[16]  Stefano Pampanin,et al.  Validation of a Numerical Model for Prediction of Out-of-Plane Instability in Ductile Structural Walls under Concentric In-Plane Cyclic Loading , 2018 .

[17]  Stefano Pampanin,et al.  Tests on slender ductile structural walls designed according to New Zealand Standard , 2017 .

[18]  Y. Chai,et al.  Lateral Stability of Reinforced Concrete Columns under Axial Reversed Cyclic Tension and Compression , 1999 .

[19]  Dawn E. Lehman,et al.  Impact of Axial Load on the Seismic Response of Rectangular Walls , 2018, Journal of Structural Engineering.

[20]  J. Almeida,et al.  Stability of thin reinforced concrete walls under cyclic loads: state-of-the-art and new experimental findings , 2016, Bulletin of Earthquake Engineering.

[21]  Signy Crowe.  Seismic Performance of Older Reinforced Concrete Walls , 2018 .

[22]  T. Paulay,et al.  Stability of Ductile Structural Walls , 1993 .

[23]  Richard Henry,et al.  Deformation capacity of concrete walls: Research findings for both old and new design practice , 2018 .

[24]  Stefano PAMPANIN,et al.  SIMULATION OF OUT-OF-PLANE INSTABILITY IN RECTANGULAR RC STRUCTURAL , 2014 .

[25]  Stefano Pampanin,et al.  Numerical Modeling of Rectangular Reinforced Concrete Structural Walls , 2017 .

[26]  Aleksey Shegay,et al.  Seismic Performance of Reinforced Concrete Walls Designed for Ductility , 2019 .

[27]  R. Dhakal,et al.  Experimental Study on Slender Rectangular RC Walls under Bi-directional Loading , 2018 .

[28]  Stefano Pampanin,et al.  A parametric study on out-of-plane instability of doubly reinforced structural walls. Part I: FEM predictions , 2020, Bulletin of Earthquake Engineering.

[29]  Richard Henry,et al.  Experimental Validation of Minimum Vertical Reinforcement Requirements for Ductile Concrete Walls , 2018, ACI Structural Journal.

[30]  Richard Henry,et al.  Numerical modelling of reinforced concrete walls with minimum vertical reinforcement , 2017 .

[31]  Kenneth J. Elwood,et al.  Testing of singly reinforced concrete walls used in existing buildings , 2018 .

[32]  Stefano Pampanin,et al.  Evolution of out-of-plane deformation and subsequent instability in rectangular RC walls under in-plane cyclic loading: Experimental observation , 2018, Earthquake Engineering & Structural Dynamics.

[33]  Stefano Pampanin,et al.  Rectangular RC walls under bi-directional loading: Recent experimental and numerical findings , 2018 .

[34]  Katrin Beyer,et al.  Understanding Poor Seismic Performance of Concrete Walls and Design Implications , 2014 .

[35]  Kenneth J. Elwood,et al.  Deformation Capacity Limits for Reinforced Concrete Walls , 2019, Earthquake Spectra.

[36]  Stefano Pampanin,et al.  A parametric study on out-of-plane instability of doubly reinforced structural walls. Part II: Experimental investigation , 2020, Bulletin of Earthquake Engineering.

[37]  Yiqiu Lu,et al.  MINIMUM VERTICAL REINFORCEMENT IN RC WALLS: THEORETICAL REQUIREMENTS FOR LOW AND HIGH DUCTILITY DEMANDS , 2017 .

[38]  J ElwoodKenneth,et al.  Performance of concrete buildings in the 22 February 2011 Christchurch earthquake and implications for Canadian codes1 , 2013 .

[39]  Stefano Pampanin,et al.  A parametric investigation on applicability of the curved shell finite element model to nonlinear response prediction of planar RC walls , 2019, Bulletin of Earthquake Engineering.