Unsteady Wake and Coolant Density Effects on Turbine Blade Film Cooling Using Pressure Sensitive Paint Technique

[1]  David G. Bogard,et al.  Scaling of Performance for Varying Density Ratio Coolants on an Airfoil With Strong Curvature and Pressure Gradient Effects , 2001 .

[2]  K. Dullenkopf,et al.  A Theory for Wake-Induced Transition , 1989 .

[3]  Je-Chin Han,et al.  Unsteady Wake Effect on Film Temperature and Effectiveness Distributions for a Gas Turbine Blade , 1999 .

[4]  C. P. Lee,et al.  Unsteady Wake Over a Linear Turbine Blade Cascade With Air and CO2 Film Injection: Part I—Effect on Heat Transfer Coefficients , 1993 .

[5]  M. Chyu,et al.  Aerothermal Challenges in Syngas, Hydrogen-Fired, and Oxyfuel Turbines—Part II: Effects of Internal Heat Transfer , 2009 .

[6]  D. Bogard,et al.  Film-cooling effectiveness downstream of a single row of holes with variable density ratio , 1990 .

[7]  R. E. Mayle,et al.  The 1991 IGTI Scholar Lecture: The Role of Laminar-Turbulent Transition in Gas Turbine Engines , 1991 .

[8]  S. J. Kline,et al.  Describing Uncertainties in Single-Sample Experiments , 1953 .

[9]  Je-Chin Han,et al.  Assessment of Steady State PSP, TSP, and IR Measurement Techniques for Flat Plate Film Cooling , 2005 .

[10]  Tim Bradley,et al.  Advanced Hydrogen Turbine Development Update , 2009 .

[11]  Richard J Goldstein,et al.  Film cooling downstream of a row of discrete holes with compound angle , 2000 .

[12]  Robert Haimes,et al.  Fully Scaled Transonic Turbine Rotor Heat Transfer Measurements , 1988 .

[13]  Je-Chin Han,et al.  Full Coverage Film Cooling for a Turbine Blade with Axial Shaped Holes , 2007 .

[14]  Magnus Jonsson,et al.  Experimental and Numerical Study of the Thermal Performance of a Film Cooled Turbine Platform , 2009 .

[15]  Je-Chin Han,et al.  Film effectiveness over a flat surface with air and CO2 injection through compound angle holes using a transient liquid crystal image method , 1995 .

[16]  C. P. Lee,et al.  Unsteady Wake Over a Linear Turbine Blade Cascade With Air and CO2 Film Injection: Part II—Effect on Film Effectiveness and Heat Transfer Distributions , 1994 .

[17]  Denis J. Doorly,et al.  Simulation of the Effects of Shock Wave Passing on a Turbine Rotor Blade , 1985 .

[18]  J. H. Whitelaw,et al.  The effectiveness of the uniform density, two-dimensional wall jet , 1967 .

[19]  C. P. Lee,et al.  Unsteady Wake Over a Linear Turbine Blade Cascade With Air and CO2 Film Injection: Part I — Effect on Heat Transfer Coefficients , 1993 .

[20]  Ken-ichi Funazaki,et al.  The Effect of Periodic Wake Passing on Film Effectiveness of Discrete Cooling Holes Around the Leading Edge of a Blunt Body , 1995 .

[21]  Je-Chin Han,et al.  Influence of Unsteady Wake on Heat Transfer Coefficient From a Gas Turbine Blade , 1993 .

[22]  Je-Chin Han,et al.  Effect of Unsteady Wake With Trailing Edge Coolant Ejection on Film Cooling Performance for a Gas Turbine Blade , 1999 .

[23]  Je-Chin Han,et al.  Combined Effect of Free-Stream Turbulence and Unsteady Wake on Heat Transfer Coefficients From a Gas Turbine Blade , 1995 .

[24]  Richard J Goldstein,et al.  Film Cooling With Large Density Differences Between the Mainstream and the Secondary Fluid Measured by the Heat-Mass Transfer Analogy , 1977 .

[25]  Je-Chin Han,et al.  Effect of Upstream Step on Flat Plate Film-Cooling Effectiveness Using PSP , 2011 .

[26]  Howard P. Hodson,et al.  The Unsteady Development of a Turbulent Wake Through a Downstream Low-Pressure Turbine Blade Passage , 2005 .

[27]  J. Heidmann.  The Effect of Wake Passing on Turbine Blade Film Cooling , 2001 .

[28]  T. V. Jones.  Theory for the use of foreign gas in simulating film cooling , 1999 .

[29]  Je-Chin Han,et al.  Influence of Coolant Density on Turbine Blade Platform Film-Cooling , 2009 .

[30]  Je-Chin Han,et al.  Film-Cooling on a Gas Turbine Blade Pressure Side or Suction Side With Compound Angle Shaped Holes , 2009 .