Chirped pulse heterodyne for optimal beat note detection between a frequency comb and a continuous wave laser.

Chirped pulse heterodyne is proposed to maximize the signal-to-noise ratio (SNR) when measuring the beat note between an optical frequency comb and a continuous wave (CW) laser. The noise model reveals that all the comb power within the largest possible detection bandwidth can be used to increase the SNR. The chirped comb/CW interference experiment is shown to be equivalent to CW/CW interference, using the comb's spectrally available power. The approach can also greatly alleviate dynamic range issues when detected pulsed heterodyne signals. A beat note SNR of 68.3 dB in a 100 kHz bandwidth is achieved.

[1]  J. L. Hall,et al.  Optical frequency measurement across a 104-THz gap with a femtosecond laser frequency comb. , 2000, Optics letters.

[2]  Brandon Botzer,et al.  Demonstration of on-sky calibration of astronomical spectra using a 25 GHz near-IR laser frequency comb. , 2012, Optics express.

[3]  M. Akbulut,et al.  A Semiconductor-Based 10-GHz Optical Comb Source With Sub 3-fs Shot-Noise-Limited Timing Jitter and $\sim$500-Hz Comb Linewidth , 2010, IEEE Photonics Technology Letters.

[4]  E. A. Curtis,et al.  Direct comparison of two cold-atom-based optical frequency standards by using a femtosecond-laser comb. , 2001, Optics letters.

[5]  Motoichi Ohtsu,et al.  12-THz frequency difference measurements and noise analysis of an optical frequency comb in optical fibers , 1999 .

[6]  J. Genest,et al.  Heterodyne beats between a continuous-wave laser and a frequency comb beyond the shot-noise limit of a single comb mode , 2013 .

[7]  J. Diels,et al.  Stabilization of femtosecond lasers for optical frequency metrology and direct optical to radio frequency synthesis. , 2001, Physical review letters.

[8]  P. Maddaloni,et al.  Absolute frequency measurement of molecular transitions by a direct link to a comb generated around 3-µm , 2008 .

[9]  William C Swann,et al.  High-performance, vibration-immune, fiber-laser frequency comb. , 2009, Optics letters.

[10]  Sakae Kawato,et al.  A multi-branch, fiber-based frequency comb with millihertz-level relative linewidths using an intra-cavity electro-optic modulator. , 2010, Optics express.

[11]  Jun Ye,et al.  Optical frequency comb with submillihertz linewidth and more than 10 W average power , 2008 .

[12]  Etienne Perret,et al.  Group-Delay Engineered Noncommensurate Transmission Line All-Pass Network for Analog Signal Processing , 2010, IEEE Transactions on Microwave Theory and Techniques.

[13]  H Matsumoto,et al.  Frequency metrology with a turnkey all-fiber system. , 2004, Optics letters.

[14]  William C. Swann,et al.  Low-noise fiber-laser frequency combs (Invited) , 2007 .

[15]  S. Diddams,et al.  Exploiting shot noise correlations in the photodetection of ultrashort optical pulse trains , 2013, 1302.6206.

[16]  Hirokazu Matsumoto,et al.  Long-term measurement of optical frequencies using a simple, robust and low-noise fiber based frequency comb. , 2006, Optics express.

[17]  Jun Ye,et al.  Phase-stabilized, 1.5 W frequency comb at 2.8-4.8 microm. , 2009, Optics letters.

[18]  K. Cossel,et al.  Ultrabroadband coherent supercontinuum frequency comb , 2011, 1105.2093.

[19]  Jun Ye,et al.  Continuously tunable, precise, single frequency optical signal generator. , 2002, Optics express.

[20]  M. Kirchner,et al.  Ultralow phase noise microwave generation with an Er:fiber-based optical frequency divider. , 2011, Optics letters.

[21]  S. Diddams,et al.  Analysis of shot noise in the detection of ultrashort optical pulse trains , 2013 .

[22]  Theodor W. Hänsch,et al.  Measuring the frequency of light with mode-locked lasers , 1999 .

[23]  Günter Steinmeyer,et al.  Carrier-envelope offset phase control: A novel concept for absolute optical frequency measurement and ultrashort pulse generation , 1999 .