Strength and dilation of jointed granite specimens in servo-controlled triaxial tests

Abstract We investigated the complete stress–strain response of artificially jointed granitic rock specimens with two joint sets. A series of confined compressive tests on these jointed rock specimens were performed in a fully servo-controlled press. Elastic, strength and post-failure parameters were calculated and analysed, with special attention paid to the dilation angle. The results were compared to those for corresponding intact specimens investigated in a previous study. Although the peak strength of the jointed cores was much lower than that for the intact cores, the residual strength envelopes were practically equal. The apparent elastic and drop moduli tended to be lower for jointed specimens than that for intact specimens. At low confining stress levels, the jointed rock tended to dilate less than the intact rock, but at higher confinement dilation behaviour converged. Another finding with respect to post-yield behaviour was that the dilation angle of the jointed specimens could adequately be represented by an existing plastic-shear–strain and confinement-dependent model developed for intact specimens.

[1]  E. Alonso,et al.  Considerations of the dilatancy angle in rocks and rock masses , 2005 .

[2]  E. Hoek,et al.  Empirical estimation of rock mass modulus , 2006 .

[3]  Allen W. Hatheway,et al.  The Complete ISRM Suggested Methods for Rock Characterization, Testing and Monitoring; 1974–2006 , 2009 .

[4]  P. K. Kaiser,et al.  Determination of residual strength parameters of jointed rock masses using the GSI system , 2007 .

[5]  W. R. Wawersik,et al.  A study of brittle rock fracture in laboratory compression experiments , 1970 .

[6]  E. Hoek,et al.  Gsi: A Geologically Friendly Tool For Rock Mass Strength Estimation , 2000 .

[7]  E. T. Brown,et al.  Underground excavations in rock , 1980 .

[8]  E. T. Brown,et al.  A study of the mechanical behaviour of coal for pillar design , 1998 .

[9]  Diederichs,et al.  Application of modified Hoek-Brown transition relationships for assessing strength and post yield behaviour at both ends of the rock competence scale , 2008 .

[10]  M. Cai,et al.  Considerations of rock dilation on modeling failure and deformation of hard rocks—a case study of the mine-by test tunnel in Canada , 2010 .

[11]  F. Varas,et al.  Ground response curves for rock masses exhibiting strain‐softening behaviour , 2003 .

[12]  P. K. Kaiser,et al.  Estimation of rock mass deformation modulus and strength of jointed hard rock masses using the GSI system , 2004 .

[13]  Leandro R. Alejano,et al.  Comparison of Different Techniques of Tilt Testing and Basic Friction Angle Variability Assessment , 2012, Rock Mechanics and Rock Engineering.

[14]  F. Reusch,et al.  Application of a Non-linear Confinement Sensitive Constitutive Model to Mine Scale Simulations Subject to Varying Levels of Confining Stress , 2010 .

[15]  Emmanuel M Detournay,et al.  Elastoplastic model of a deep tunnel for a rock with variable dilatancy , 1986 .

[16]  I. W. Farmer,et al.  Application of yield models to rock , 1979 .

[17]  J. C. Jaeger,et al.  Fundamentals of rock mechanics , 1969 .

[18]  Leandro R. Alejano,et al.  Dilation in granite during servo-controlled triaxial strength tests , 2013 .

[19]  Christopher H. Scholz,et al.  Microfracturing and the inelastic deformation of rock in compression , 1968 .

[20]  Ming Cai,et al.  A mobilized dilation angle model for rocks , 2010 .

[21]  R. Borst,et al.  Non-Associated Plasticity for Soils, Concrete and Rock , 1984 .

[22]  Evert Hoek,et al.  Practical estimates of rock mass strength , 1997 .

[23]  M. Kwaśniewski,et al.  Study on the Dilatancy Angle of Rocks in the Pre-Failure Domain , 2011 .

[24]  Ming Cai,et al.  Influence of plastic shear strain and confinement-dependent rock dilation on rock failure and displacement near an excavation boundary , 2010 .

[25]  Pinnaduwa Kulatilake,et al.  A physical model study of jointed rock mass strength under uniaxial compressive loading , 1997 .

[26]  Pinnaduwa Kulatilake,et al.  Experimental and numerical simulations of jointed rock block strength under uniaxial loading , 2001 .