Influence of activator type on hydration kinetics, hydrate assemblage and microstructural development of alkali activated blast-furnace slags

Abstract The hydration of two slags with different Al 2 O 3 contents activated with sodium hydroxide and hydrous sodium metasilicate (commonly named water glass) is studied using a multi-method approach. In all systems, C-S-H incorporating aluminium and a hydrotalcite-like phase with Mg/Al ratio ~ 2 are the main hydration products. The C-S-H gels present in NaOH activated pastes are more crystalline and contain less water; a calcium silicate hydrate (C-S-H) and a sodium rich C-N-S-H with a similar Ca content are observed at longer hydration times. The activation using NaOH results in high early strength, but strength at 7 days and longer is lower than for the sodium metasilicate systems. The drastic difference in C-S-H structure leads to a coarser capillary porosity and to lower compressive strength for the NaOH activated than for the sodium metasilicate activated slags at the same degree of slag reaction.

[1]  J. Deventer,et al.  Understanding the relationship between geopolymer composition, microstructure and mechanical properties , 2005 .

[2]  V. Zivica,et al.  Effects of type and dosage of alkaline activator and temperature on the properties of alkali-activated slag mixtures , 2007 .

[3]  B. Münch,et al.  Quantification of hydration phases in supersulfated cements: review and new approaches , 2011 .

[4]  Karen L. Scrivener,et al.  Relation of expansion due to alkali silica reaction to the degree of reaction measured by SEM image analysis , 2007 .

[5]  Francisca Puertas,et al.  Effect of activator mix on the hydration and strength behaviour of alkali-activated slag cements , 2003 .

[6]  F. P. Glasser,et al.  The magnesia–silica gel phase in slag cements: alkali (K, Cs) sorption potential of synthetic gels , 2005 .

[7]  J. I. Escalante-García,et al.  Hydration Products and Reactivity of Blast‐Furnace Slag Activated by Various Alkalis , 2003 .

[8]  P. Monteiro,et al.  Structural Investigations of Alkali Silicate Gels , 2005 .

[9]  J. Deventer,et al.  Geopolymer technology: the current state of the art , 2007 .

[10]  E. Kanezaki.  Thermal behavior of the hydrotalcite-like layered structure of Mg and Al-layered double hydroxides with interlayer carbonate by means of in situ powder HTXRD and DTA/TG , 1998 .

[11]  Rachel J. Detwiler,et al.  Pore structure of plain cement pastes hydrated at different temperatures , 1990 .

[12]  Barbara Lothenbach,et al.  Quantification of the degree of reaction of fly ash , 2010 .

[13]  J. Sharp,et al.  The microstructure and mechanical properties of blended cements hydrated at various temperatures , 2001 .

[14]  Francisca Puertas,et al.  Pore solution in alkali-activated slag cement pastes. Relation to the composition and structure of calcium silicate hydrate , 2004 .

[15]  Francisca Puertas,et al.  Alkali-activated slag mortars: Mechanical strength behaviour , 1999 .

[16]  K. Scrivener,et al.  Effects of an early or a late heat treatment on the microstructure and composition of inner C-S-H products of Portland cement mortars , 2002 .

[17]  Frank Winnefeld,et al.  Hydration of alkali-activated slag: comparison with ordinary Portland cement , 2006 .

[18]  Philip G. Malone,et al.  Activation of Ground Blast‐Furnace Slag by Alkali‐Metal and Alkaline‐Earth Hydroxides , 1992 .

[19]  J. Deventer,et al.  The coexistence of geopolymeric gel and calcium silicate hydrate at the early stage of alkaline activation , 2005 .

[20]  Francisca Puertas,et al.  Setting of alkali-activated slag cement. Influence of activator nature , 2001 .

[21]  K. Scrivener,et al.  Quantitative study of Portland cement hydration by X-ray diffraction/rietveld analysis and independent methods , 2004 .

[22]  J. Davidovits.  Geopolymers and geopolymeric materials , 1989 .

[23]  P. L. Pratt,et al.  Factors affecting the strength of alkali-activated slag , 1994 .

[24]  Shi Caijun,et al.  Investigation on some factors affecting the characteristics of alkali-phosphorus slag cement , 1989 .

[25]  C. Dobson,et al.  The characterization of hardened alkali-activated blast-furnace slag pastes and the nature of the calcium silicate hydrate (C-S-H) phase , 1994 .

[26]  K. Scrivener,et al.  29Si and 27Al NMR study of alkali-activated slag , 2003 .

[27]  E. Gartner.  Industrially interesting approaches to “low-CO2” cements ☆ , 2004 .

[28]  H. Taylor.  Proposed Structure for Calcium Silicate Hydrate Gel , 1986 .

[29]  Karen L. Scrivener,et al.  Backscattered electron imaging of cementitious microstructures: Understanding and quantification , 2004 .

[30]  Mohsen Ben Haha.  Mechanical effects of alkali silica reaction in concrete studied by SEM-image analysis , 2006 .

[31]  L. Diamond,et al.  Synthesis and characterization of the LDH hydrotalcite-pyroaurite solid-solution series , 2010 .

[32]  I. Richardson.  The nature of the hydration products in hardened cement pastes , 2000 .

[33]  L. Black,et al.  Cell Dimensions and Composition of Nanocrystalline Calcium Silicate Hydrate Solid Solutions. Part 1: Synchrotron-Based X-Ray Diffraction , 2008 .

[34]  J. Russias,et al.  Structural characterization of C–S–H and C–A–S–H samples—Part I: Long-range order investigated by Rietveld analyses , 2009 .

[35]  F. Puertas,et al.  Mineralogical and microstructural characterisation of alkali-activated fly ash/slag pastes , 2003 .

[36]  I. Richardson.  The calcium silicate hydrates , 2008 .

[37]  Hamlin M. Jennings,et al.  Pore solution chemistry of alkali-activated ground granulated blast-furnace slag , 1999 .

[38]  J. Deventer,et al.  The Role of Inorganic Polymer Technology in the Development of ‘Green Concrete’ , 2007 .

[39]  P. Pochet.  A Quantitative Analysis , 2006 .

[40]  X. Cong,et al.  Effects of the temperature and relative humidity on the structure of CSH gel , 1995 .

[41]  K. Scrivener,et al.  Hydration products of alkali activated slag cement , 1995 .

[42]  B. Lothenbach,et al.  Hydration of alkali-activated slag: thermodynamic modelling , 2007 .

[43]  I. Richardson.  Tobermorite/jennite- and tobermorite/calcium hydroxide-based models for the structure of C-S-H: applicability to hardened pastes of tricalcium silicate, β-dicalcium silicate, Portland cement, and blends of Portland cement with blast-furnace slag, metakaolin, or silica fume , 2004 .