Mathematical modelling of a dual-fluid concentrating photovoltaic-thermal (PV-T) solar collector

This study presents an improved photovoltaic-thermal (PV-T) solar collector system that integrates a PV panel with a serpentine-flow stainless steel tube as the water-heating component and a double-pass air channel as the air-heating component. A Fresnel lens is used as the glazing and primary concentrator, and compound parabolic concentrators (CPCs) are used as the secondary concentrator. The system can simultaneously generate hot air and hot water in addition to electricity, and the total energy generated per unit area is higher than that of a single-fluid system. This triple-function PV-T solar collector is well suited for a wide range of thermal applications and offers options for hot and/or cold air and water use depending on the application and energy needs. This paper establishes, develops, and validates a conceptual design for a concentrating PV-T dual-fluid solar collector with 1D steady-state energy-balance equations for the dual-fluid (air and water) configuration. Next, this model is used to predict the performance of the dual-fluid solar collector with varying air and water mass flow rates. Then, the simulation results of the single- and dual-fluid operational modes are compared. The simulated results have shown that the total equivalent efficiencies for single fluid condition have ranged from approximately 30 to 60%, and increased to a maximum efficiency of near to 90% for the case of the dual fluids. The dual fluids operation mode has reduced the solar cells temperature and hence increased the electrical output.

[1]  Said Farahat,et al.  An improved thermal and electrical model for a solar photovoltaic thermal (PV/T) air collector , 2010 .

[2]  Ha Herbert Zondag,et al.  The thermal and electrical yield of a PV-thermal collector , 2002 .

[3]  Khaled Touafek,et al.  Modeling and detailed study of hybrid photovoltaic thermal (PV/T) solar collector , 2016 .

[4]  William A. Beckman,et al.  Solar Engineering of Thermal Processes, 2nd ed. , 1994 .

[5]  C. Ménézo,et al.  Dynamic study of a new concept of photovoltaic-thermal hybrid collector , 2014 .

[6]  Kamaruzzaman Sopian,et al.  Performance analysis of photovoltaic thermal (PVT) water collectors , 2014 .

[7]  E. C. Kern,et al.  Combined photovoltaic and thermal hybrid collector systems , 1978 .

[8]  K. P. Gertzos,et al.  Experimental and numerical study of heat transfer phenomena, inside a flat-plate integrated collector storage solar water heater (ICSSWH), with indirect heat withdrawal , 2008 .

[9]  Yiannis Tripanagnostopoulos,et al.  Aspects and improvements of hybrid photovoltaic/thermal solar energy systems , 2007 .

[10]  W. Beckman,et al.  Solar Engineering of Thermal Processes , 1985 .

[11]  Hasila Jarimi,et al.  Design concept and mathematical model of a bi-fluid photovoltaic/thermal (PV/T) solar collector , 2014 .

[12]  Réné Tchinda,et al.  Thermal behaviour of solar air heater with compound parabolic concentrator , 2008 .

[13]  William Gerard Hurley,et al.  A thermal model for photovoltaic panels under varying atmospheric conditions , 2010 .

[14]  Kamaruzzaman Sopian,et al.  Parametric Study on Water Based Photovoltaic Thermal Collector , 2013 .

[15]  K. Sopian,et al.  Performance and cost benefits analysis of double-pass solar collector with and without fins , 2013 .

[16]  L. W. Florschuetz.  Extension of the Hottel-Whillier model to the analysis of combined photovoltaic/thermal flat plate collectors , 1976 .

[17]  Kamaruzzaman Sopian,et al.  Performance of four air-based photovoltaic thermal collectors configurations with bifacial solar cells , 2017 .

[18]  Kamaruzzaman Sopian,et al.  Performance analysis of a double-pass photovoltaic/thermal (PV/T) solar collector with CPC and fins , 2005 .

[19]  J. Brau,et al.  Study of a new concept of photovoltaic-thermal hybrid collector , 2007 .

[20]  K. S. Ong.  Thermal performance of solar air heaters: Mathematical model and solution procedure , 1995 .

[21]  Said Farahat,et al.  Optimization of a solar photovoltaic thermal (PV/T) water collector based on exergy concept , 2014 .

[22]  Kamaruzzaman Sopian,et al.  Performance studies on a finned double-pass photovoltaic-thermal (PV/T) solar collector , 2007 .

[23]  W. Swinbank.  Long‐wave radiation from clear skies , 1963 .

[24]  Karima E. Amori,et al.  Field study of various air based photovoltaic/thermal hybrid solar collectors , 2014 .

[25]  Kamaruzzaman Sopian,et al.  Performance of a double pass photovoltaic thermal solar collector suitable for solar drying systems , 2000 .

[26]  C. Ménézo,et al.  Study of the thermal and electrical performances of PVT solar hot water system , 2014 .

[27]  Paul Cooper,et al.  A dynamic model for air-based photovoltaic thermal systems working under real operating conditions , 2014 .

[28]  Oussama Rejeb,et al.  A numerical investigation of a photovoltaic thermal (PV/T) collector , 2015 .

[29]  Frank P. Incropera,et al.  Fundamentals of Heat and Mass Transfer , 1981 .

[30]  Y. Tripanagnostopoulos,et al.  Hybrid photovoltaic/thermal solar systems , 2002 .

[31]  Hasila Jarimi,et al.  Bi-fluid photovoltaic/thermal (PV/T) solar collector: Experimental validation of a 2-D theoretical model , 2016 .

[32]  Jun-Tae Kim,et al.  Experimental Performance of a Photovoltaic-thermal Air Collector☆ , 2014 .