A High-Voltage-Compliant Current-to-Digital Sensor for DC–DC Converters in Standard CMOS Technology

Efficient current, voltage, and power sensing are critical blocks for power management, switching regulators, maximum power point tracking (MPPT) circuit, and motor control. This paper presents a standard CMOS and low-power current-to-digital converter (IDC) that senses the current flowing at high-voltage nodes. The proposed sensor uses a CMOS-switched capacitor circuit to sense a dc-dc converter output current and gives digital output without an analog-to-digital converter (ADC), or the need for high-voltage technologies. Compared to the resistor-based current-sensing methods that require current-to-voltage circuit, gain block, and an ADC converter, the proposed sensor is a low-power integrated circuit that achieves high resolution, lower complexity, and lower power consumption. The IDC circuit is fabricated on a 5 V, 0.7 μm, and three metal CMOS technology and occupied less than 10% area (1 mm2 area) compared to other sensors. It consumes 18 mW that is less than 40% power consumed by other sensors, and its current measurement error is below 0.4%. The proposed IDC circuit has been characterized as standalone and with a boost dc-dc regulator and MPPT for photovoltaic systems.

[1]  M. Orabi,et al.  Load current based analog MPPT controller for PV solar systems , 2012, 2012 Twenty-Seventh Annual IEEE Applied Power Electronics Conference and Exposition (APEC).

[2]  P.K.T. Mok,et al.  A monolithic current-mode CMOS DC-DC converter with on-chip current-sensing technique , 2004, IEEE Journal of Solid-State Circuits.

[3]  Jian Sun,et al.  Dual-Boost Single-Phase PFC Input Current Control Based on Output Current Sensing , 2009, IEEE Transactions on Power Electronics.

[4]  Jiann-Jong Chen,et al.  An Adaptive Output Current Estimation Circuit for a Primary-Side Controlled LED Driver , 2013 .

[5]  L.S.Y. Wong,et al.  A very low-power CMOS mixed-signal IC for implantable pacemaker applications , 2004, IEEE Journal of Solid-State Circuits.

[6]  By Bob Mammano.  Current Sensing Solutions for Power Supply Designers , 2000 .

[7]  Shiguo Luo,et al.  Design Considerations for Small Signal Modeling of DC-DC Converters Using Inductor DCR Current Sensing Under Time Constants Mismatch Conditions , 2007, 2007 IEEE Power Electronics Specialists Conference.

[8]  Quan Zhang,et al.  Investigation of the thermal drift of open-loop Hall Effect current sensor and its improvement , 2015, International Workshop on Applied Measurements for Power Systems.

[9]  J. G. Ryan,et al.  A four chip implantable defibrillator/pacemaker chipset , 1989, 1989 Proceedings of the IEEE Custom Integrated Circuits Conference.

[10]  Yen-Shin Lai,et al.  Parameter Tuning Method for Digital Power Converter With Predictive Current-Mode Control , 2009, IEEE Transactions on Power Electronics.

[11]  Michel Steyaert,et al.  Fully-Integrated Inductive DC-DC converters in Standard CMOS , 2010 .

[12]  Fred C. Lee,et al.  Analysis of Unified Output MPPT Control in Subpanel PV Converter System , 2014, IEEE Transactions on Power Electronics.

[13]  Ruqi Li,et al.  A comparative study of small-signal average models for average current mode control , 2012, Proceedings of The 7th International Power Electronics and Motion Control Conference.

[14]  Tao Liu,et al.  A digitally controlled DC-DC buck converter with lossless load-current sensing and BIST functionality , 2011, 2011 IEEE International Solid-State Circuits Conference.

[15]  R. Giral,et al.  Current-Mode Control of a Coupled-Inductor Buck–Boost DC–DC Switching Converter , 2012, IEEE Transactions on Power Electronics.

[16]  R. Giral,et al.  Fast Transitions Between Current Control Loops of the Coupled-Inductor Buck–Boost DC–DC Switching Converter , 2013, IEEE Transactions on Power Electronics.

[17]  Torsten Lehmann,et al.  Nanosecond Delay Floating High Voltage Level Shifters in a 0.35 $\mu$m HV-CMOS Technology , 2011, IEEE Journal of Solid-State Circuits.

[18]  Huang-Jen Chiu,et al.  A High-Efficiency Dimmable LED Driver for Low-Power Lighting Applications , 2010, IEEE Transactions on Industrial Electronics.

[19]  Franziska Hoffmann,et al.  Design Of Analog Cmos Integrated Circuits , 2016 .

[20]  Hao Jiang,et al.  A new MPPT technique for the maximization of overall system output in solar generation , 2015, 2015 IEEE 11th International Conference on Power Electronics and Drive Systems.

[21]  S. Ziegler,et al.  Current Sensing Techniques: A Review , 2009, IEEE Sensors Journal.

[22]  Hsiao-Hsing Chou,et al.  An Adaptive Output Current Estimation Circuit for a Primary-Side Controlled LED Driver , 2013, IEEE Transactions on Power Electronics.

[23]  Anantha Chandrakasan,et al.  Minimum Energy Tracking Loop with Embedded DC-DC Converter Delivering Voltages down to 250mV in 65nm CMOS , 2007, 2007 IEEE International Solid-State Circuits Conference. Digest of Technical Papers.

[24]  Saad Mekhilef,et al.  A novel MPPT algorithm for load protection based on output sensing control , 2011, 2011 IEEE Ninth International Conference on Power Electronics and Drive Systems.

[25]  Joung-Hu Park,et al.  Low-Cost High-Efficiency Discrete Current Sensing Method Using Bypass Switch for PV Systems , 2014, IEEE Transactions on Instrumentation and Measurement.

[26]  Ka Nang Leung,et al.  An integrated CMOS current-sensing circuit for low-Voltage current-mode buck regulator , 2005, IEEE Transactions on Circuits and Systems II: Express Briefs.

[27]  Jinliang He,et al.  Contactless Current Sensors Based on Magnetic Tunnel Junction for Smart Grid Applications , 2015, IEEE Transactions on Magnetics.

[28]  Dragan Maksimovic,et al.  Average Inductor Current Sensor for Digitally Controlled Switched-Mode Power Supplies , 2012, IEEE Transactions on Power Electronics.

[29]  Bertan Bakkaloglu,et al.  Low power integrated on-chip current to digital converter , 2015, 2015 IEEE Applied Power Electronics Conference and Exposition (APEC).