A wide band envelope modulator for envelope tracking RF power amplifiers

Polar modulation RF power amplifier is a good candidate to enhance the efficiency while maintaining the linearity for high PAPR signals. Among different architecture used for envelope modulator, hybrid switching envelope modulator is attracted the attention. Class AB power amplifier which is the main block of hybrid switching envelope modulator should have wide bandwidth and low output impedance in a wideband of frequency to compensate high switching noise ripples. In this paper a wideband supply modulator with sufficient low output impedance is designed in 0.18 μm CMOS technology. The bandwidth of the modulator is around 437 MHz which is much larger than previously reported in literature. Thanks to the low output impedance of the class AB architecture, the HSEM architecture is capable of reducing the switching frequency noise up to 100MHz, while consuming approximately the same power as other architecture.

[1]  Jinsung Choi,et al.  A Polar Transmitter With CMOS Programmable Hysteretic-Controlled Hybrid Switching Supply Modulator for Multistandard Applications , 2009, IEEE Transactions on Microwave Theory and Techniques.

[2]  A. Salimi,et al.  Design of a rail-to-rail, low output impedance class AB power amplifier for envelope tracking of polar modulators , 2012, 2012 2nd International Conference on Advances in Computational Tools for Engineering Applications (ACTEA).

[3]  Bram Nauta,et al.  A Wideband Supply Modulator for 20 MHz RF Bandwidth Polar PAs in 65 nm CMOS , 2009, IEEE Journal of Solid-State Circuits.

[4]  P. M. Asbeck,et al.  A Wideband CMOS/GaAs HBT Envelope Tracking Power Amplifier for 4G LTE Mobile Terminal Applications , 2012, IEEE Transactions on Microwave Theory and Techniques.

[5]  Jan M. Rabaey,et al.  Digital Integrated Circuits , 2003 .

[6]  Peter M. Asbeck,et al.  A Combined Series-Parallel Hybrid Envelope Amplifier for Envelope Tracking Mobile Terminal RF Power Amplifier Applications , 2012, IEEE Journal of Solid-State Circuits.

[7]  Min-Chul Lee,et al.  A 2 W CMOS Hybrid Switching Amplitude Modulator for EDGE Polar Transmitters , 2007, IEEE Journal of Solid-State Circuits.

[8]  Catherine Dehollain,et al.  Design of a rail-to-rail 460 kS/s 10-bit SAR ADC for capacitive sensor interface , 2013, 2013 IEEE 20th International Conference on Electronics, Circuits, and Systems (ICECS).

[9]  Philip K. T. Mok,et al.  A Two-Phase Switching Hybrid Supply Modulator for RF Power Amplifiers With 9% Efficiency Improvement , 2010, IEEE Journal of Solid-State Circuits.