A Switched-Capacitor Inverter Using Series/Parallel Conversion With Inductive Load

A novel switched-capacitor inverter is proposed. The proposed inverter outputs larger voltage than the input voltage by switching the capacitors in series and in parallel. The maximum output voltage is determined by the number of the capacitors. The proposed inverter, which does not need any inductors, can be smaller than a conventional two-stage unit which consists of a boost converter and an inverter bridge. Its output harmonics are reduced compared to a conventional voltage source single phase full bridge inverter. In this paper, the circuit configuration, the theoretical operation, the simulation results with MATLAB/SIMULINK, and the experimental results are shown. The experimental results accorded with the theoretical calculation and the simulation results.

[1]  Janusz A. Starzyk,et al.  A DC-DC charge pump design based on voltage doublers , 2001 .

[2]  Arindam Ghosh,et al.  Switching Characterization of Cascaded Multilevel-Inverter-Controlled Systems , 2008, IEEE Transactions on Industrial Electronics.

[3]  L.U. Gokdere,et al.  Integrated magnetics for interleaved DC-DC boost converter for fuel cell powered vehicles , 2004, 2004 IEEE 35th Annual Power Electronics Specialists Conference (IEEE Cat. No.04CH37551).

[4]  A. Khaligh,et al.  Power electronics intensive solutions for advanced electric, hybrid electric, and fuel cell vehicular power systems , 2006, IEEE Transactions on Power Electronics.

[5]  M. Kazimierczuk Pulse-Width Modulated DC-DC Power Converters: Kazimierczuk/Pulse-width Modulated DC-DC Power Converters , 2008 .

[6]  Xian Zhang,et al.  Study on a modified multilevel cascade inverter with hybrid modulation , 2001, 4th IEEE International Conference on Power Electronics and Drive Systems. IEEE PEDS 2001 - Indonesia. Proceedings (Cat. No.01TH8594).

[7]  Jorge Pontt,et al.  Network-Friendly Low-Switching-Frequency Multipulse High-Power Three-Level PWM Rectifier , 2009, IEEE Transactions on Industrial Electronics.

[8]  Hirotaka Koizumi,et al.  A switched-capacitor inverter using series/parallel conversion , 2010, Proceedings of 2010 IEEE International Symposium on Circuits and Systems.

[9]  Zhong Du,et al.  Hybrid cascaded multilevel inverter with PWM control method , 2008, 2008 IEEE Power Electronics Specialists Conference.

[10]  H. Alan Mantooth,et al.  A technique to increase the efficiency of high-voltage charge pumps , 2006, IEEE Transactions on Circuits and Systems II: Express Briefs.

[11]  Leopoldo García Franquelo,et al.  > Replace This Line with Your Paper Identification Number (double-click Here to Edit) < , 2022 .

[12]  Adrian Ioinovici,et al.  A cascade boost-switched-capacitor-converter - two level inverter with an optimized multilevel output waveform , 2005, IEEE Transactions on Circuits and Systems I: Regular Papers.

[13]  Vassilios G. Agelidis,et al.  On Attaining the Multiple Solutions of Selective Harmonic Elimination PWM Three-Level Waveforms Through Function Minimization , 2008, IEEE Transactions on Industrial Electronics.

[14]  Brendan Peter McGrath,et al.  Multicarrier PWM strategies for multilevel inverters , 2002, IEEE Trans. Ind. Electron..

[15]  L.G. Franquelo,et al.  The age of multilevel converters arrives , 2008, IEEE Industrial Electronics Magazine.

[16]  Hirotaka Koizumi,et al.  A single phase multilevel inverter using switched series/parallel DC voltage sources , 2009 .

[17]  Steven B. Leeb,et al.  A multilevel inverter topology for inductively-coupled power transfer , 2003 .

[18]  A. Ioinovici,et al.  Switched-capacitor inverter with high power density and enhanced regulation capability , 1998 .